اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدThe Cooling of Coronal Plasmas. iv: Catastrophic Cooling of Loops
306
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We examine the radiative cooling of coronal loops and demonstrate that the recently identified catastrophic cooling (Reale and Landi, 2012) is due to the inability of a loop to sustain radiative / enthalpy cooling below a critical temperature, which can be > 1 MK in flares, 0.5 - 1 MK in active regions and 0.1 MK in long tenuous loops. Catastrophic cooling is characterised by a rapid fall in coronal temperature while the coronal density changes by a small amount. Analytic expressions for the critical temperature are derived and show good agreement with numerical results. This effect limits very considerably the lifetime of coronal plasmas below the critical temperature.
قيم البحث
اقرأ أيضاً
We aim to study the influence of radiative cooling on the standing kink oscillations of a coronal loop. Using the FLASH code, we solved the 3D ideal magnetohydrodynamic equations. Our model consists of a straight, density enhanced and gravitationally
stratified magnetic flux tube. We perturbed the system initially, leading to a transverse oscillation of the structure, and followed its evolution for a number of periods. A realistic radiative cooling is implemented. Results are compared to available analytical theory. We find that in the linear regime (i.e. low amplitude perturbation and slow cooling) the obtained period and damping time are in good agreement with theory. The cooling leads to an amplification of the oscillation amplitude. However, the difference between the cooling and non-cooling cases is small (around 6% after 6 oscillations). In high amplitude runs with realistic cooling, instabilities deform the loop, leading to increased damping. In this case, the difference between cooling and non-cooling is still negligible at around 12%. A set of simulations with higher density loops are also performed, to explore what happens when the cooling takes place in a very short time (tcool = 100 s). We strengthen the results of previous analytical studies that state that the amplification due to cooling is ineffective, and its influence on the oscillation characteristics is small, at least for the cases shown here. Furthermore, the presence of a relatively strong damping in the high amplitude runs even in the fast cooling case indicates that it is unlikely that cooling could alone account for the observed, flare-related undamped oscillations of coronal loops. These results may be significant in the field of coronal seismology, allowing its application to coronal loop oscillations with observed fading-out or cooling behaviour.
Condensations in the more than 10^6 K hot corona of the Sun are commonly observed in the extreme ultraviolet (EUV). While their contribution to the total solar EUV radiation is still a matter of debate, these condensations certainly provide a valuabl
e tool for studying the dynamic response of the corona to the heating processes. We investigate different distributions of energy input in time and space to investigate which process is most relevant for understanding these coronal condensations. For a comparison to observations we synthesize EUV emission from a time-dependent, one-dimensional model for coronal loops, where we employ two heating scenarios: simply shutting down the heating and a model where the heating is very concentrated at the loop footpoints, while keeping the total heat input constant. The heating off/on model does not lead to significant EUV count rates that one observes with SDO/AIA. In contrast, the concentration of the heating near the footpoints leads to thermal non-equilibrium near the loop top resulting in the well-known catastrophic cooling. This process gives a good match to observations of coronal condensations. This shows that the corona needs a steady supply of energy to support the coronal plasma, even during coronal condensations. Otherwise the corona would drain very fast, too fast to even form a condensation.
The evolution of a coronal loop is studied by means of numerical simulations of the fully compressible three-dimensional magnetohydrodynamic equations using the HYPERION code. The footpoints of the loop magnetic field are advected by random motions.
As a consequence the magnetic field in the loop is energized and develops turbulent nonlinear dynamics characterized by the continuous formation and dissipation of field-aligned current sheets: energy is deposited at small scales where heating occurs. Dissipation is non-uniformly distributed so that only a fraction of the coronal mass and volume gets heated at any time. Temperature and density are highly structured at scales which, in the solar corona, remain observationally unresolved: the plasma of our simulated loop is multi-thermal, where highly dynamical hotter and cooler plasma strands are scattered throughout the loop at sub-observational scales. Numerical simulations of coronal loops of 50000 km length and axial magnetic field intensities ranging from 0.01 to 0.04 Tesla are presented. To connect these simulations to observations we use the computed number densities and temperatures to synthesize the intensities expected in emission lines typically observed with the Extreme ultraviolet Imaging Spectrometer (EIS) on Hinode. These intensities are used to compute differential emission measure distributions using the Monte Carlo Markov Chain code, which are very similar to those derived from observations of solar active regions. We conclude that coronal heating is found to be strongly intermittent in space and time, with only small portions of the coronal loop being heated: in fact, at any given time, most of the corona is cooling down.
We investigate the relaxation of braided magnetic loops in order to find out how the type of braiding via footpoint motions affects resultant heating of the loop. Two magnetic loops, braided in different ways, are used as initial conditions in resist
ive MHD simulations and their subsequent evolution is studied. The fields both undergo a resistive relaxation in which current sheets form and fragment and the system evolves towards a state of lower energy. In one case this relaxation is very efficient with current sheets filling the volume and homogeneous heating of the loop occurring. In the other case fewer current sheets develop, less magnetic energy is released in the process and a patchy heating of the loop results. The two cases, although very similar in their setup, can be distinguished by the mixing properties of the photospheric driver. The mixing can be measured by the topological entropy of the plasma flow, an observable quantity.
Outflows are a pervasive feature of mechanical feedback from super star clusters (SSC) in starburst galaxies, playing a fundamental role in galaxy evolution. Observations are now starting to confirm that outflows can undergo catastrophic cooling, sup
pressing adiabatic superwinds. Here we present a suite of one-dimensional, hydrodynamic simulations that study the ionization structure of these outflows and the resulting line emission generated by the cooling gas. We use the non-equilibrium atomic chemistry package within MAIHEM, our modified version of FLASH, which evolves the ionization state of the gas and computes the total cooling rate on an ion-by-ion basis. We find that catastrophically cooling models produce strong nebular line emission compared to adiabatic outflows. We also show that such models exhibit non-equilibrium conditions, thereby generating more highly ionized states than equivalent equilibrium models. When including photoionization from the parent SSC, catastrophically cooling models show strong C IV {lambda}1549 and O VI {lambda}1037 emission. For density bounded photoionization, He II {lambda}1640, {lambda}4686, C III] {lambda}1908, Si IV {lambda}1206, and Si III {lambda}1400 are also strongly enhanced. These lines are seen in extreme starbursts where catastrophic cooling is likely to occur, suggesting that they may serve as diagnostics of such conditions. The higher ionization generated by these flows may help to explain line emission that cannot be attributed to SSC photoionization alone.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
