ترغب بنشر مسار تعليمي؟ اضغط هنا

Optimization and analysis of experimental parameters for polarization gradient cooling in optical molasses

410   0   0.0 ( 0 )
 نشر من قبل Zhonghua Ji
 تاريخ النشر 2013
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

We systematically investigate the dependence of the temperature of cold cesium atoms of polarization gradient cooling (PGC) in optical molasses on experimental parameters, which contain changing modes of cooling laser, PGC interaction time, cooling laser frequency and its intensity. The SR mode of cooling laser, that means the cooling laser frequency is changed with step mode and cooling laser intensity is changed with ramp mode, is found to be the best for PGC comparing with other SS, RS, and RR modes. We introduce a statistical explanation and an exponential decay function to explain the variation of cold atomic temperature on time. The heating effect is observed when the cooling laser intensity is lower than the saturation intensity of cold atoms. After optimization, the lowest temperature of cold cesium atoms is observed to be about 4uK with the number of 2x10^9, a density of 1x10^11/cm^3 and the phase space density of 4.4x10^(-5). The optimization process and analysis of controllable experimental parameters are also meaningful for other cold atomic systems.


قيم البحث

اقرأ أيضاً

Robust cooling and nondestructive imaging are prerequisites for many emerging applications of neutral atoms trapped in optical tweezers, such as their use in quantum information science and analog quantum simulation. The tasks of cooling and imaging can be challenged, however, by the presence of large trap-induced shifts of their respective optical transitions. Here, we explore a system of $^{39}$K atoms trapped in a near-detuned ($780$ nm) optical tweezer, which leads to relatively minor differential (ground vs. excited state) Stark shifts. We demonstrate that simple and robust loading, cooling, and imaging can be achieved through a combined addressing of the D$_textrm{1}$ and D$_textrm{2}$ transitions. While imaging on the D$_textrm{2}$ transition, we can simultaneously apply $Lambda$-enhanced gray molasses (GM) on the D$_textrm{1}$ transition, preserving low backgrounds for single-atom imaging through spectral filtering. Using D$_textrm{1}$ cooling during and after trap loading, we demonstrate enhanced loading efficiencies as well as cooling to low temperatures. These results suggest a simple and robust path for loading and cooling large arrays of potassium atoms in optical tweezers through the use of resource-efficient near-detuned optical tweezers and GM cooling.
We report our experimental measurements and theoretical analysis of the position response function of a cloud of cold atoms residing in the viscous medium of an optical molasses and confined by a magneto-optical trap (MOT). We measure the position re sponse function by applying a transient homogeneous magnetic field as a perturbing force. We observe a transition from a damped oscillatory motion to an over-damped relaxation, stemming from a competition between the viscous drag provided by the optical molasses and the restoring force of the MOT. Our observations are in both qualitative and quantitative agreement with the predictions of a theoretical model based on the Langevin equation. As a consistency check, and as a prototype for future experiments, we also study the free diffusive spreading of the atomic cloud in our optical molasses with the confining magnetic field of the MOT turned off. We find that the measured value of the diffusion coefficient agrees with the value predicted by our Langevin model, using the damping coefficient. The damping coefficient was deduced from our measurements of the position response function at the same temperature.
We implement three-dimensional polarization gradient cooling of trapped ions. Counter-propagating laser beams near $393,$nm impinge in lin$,perp,$lin configuration, at a frequency below the S$_{1/2}$ to P$_{3/2}$ resonance in $^{40}$Ca$^+$. We demons trate mean phonon numbers of $5.4(4)$ at a trap frequency of $2pi times 285,$kHz and $3.3(4)$ at $2pitimes480,$kHz, in the axial and radial directions, respectively. Our measurements demonstrate that cooling with laser beams detuned to lower frequencies from the resonance is robust against an elevated phonon occupation number, and thus works well for an initial ion motion far out of the Lamb-Dicke regime, for up to four ions, and for a micromotion modulation index $betaleq 0.1$. Still, we find that the spectral impurity of the laser field influences both, cooling rates and cooling limits. Thus, a Fabry-P{e}rot cavity filter is employed for efficiently suppressing amplified spontaneous emission of the diode laser.
We have examined loading of 85Rb atoms into a shallow Far-Off-Resonance Trap (FORT) from an optical molasses and compared it to loading from a Magneto-Optical Trap (MOT). We found that substantially more atoms could be loaded into the FORT via an opt ical molasses as compared to loading from the MOT alone. To determine why this was the case, we measured the rate of atoms loaded into the FORT and the losses from the FORT during the loading process. For both MOT and molasses loading, we examined atom load rate and losses over a range of detunings as well as hyperfine pump powers. We found that the losses induced during MOT loading were essentially the same as the losses induced during molasses loading at the same MOT/molasses detuning. In contrast, load rate of the molasses was higher than that of a MOT at a given detuning. This caused the optical molasses to be able to load more atoms than the MOT. Optimization of FORT loading form an optical molasses improved the number of atoms we could trap by a factor of two over that of optimal loading from a MOT.
We present an efficient scheme to implement a gray optical molasses for sub-Doppler cooling of $^{6}$Li atoms with minimum experimental overhead. To integrate the $D_1$ light for the gray molasses (GM) cooling into the same optical setup that is used for the $D_2$ light for a standard magneto-optical trap (MOT), we rapidly switch the injection seeding of a slave laser between the $D_2$ and $D_1$ light sources. Switching times as short as $30,mutextrm{s}$ can be achieved, inferred from monitor optical beat signals. The resulting low-intensity molasses cools a sample of $N=9times10^8$ atoms to about $60,mutextrm{K}$. A maximum phase-space density of $rho=1.2times10^{-5}$ is observed. On the same setup, the performance of the GM is compared to that of narrow-line cooling in a UV MOT, following the procedure in Sebastian et al. (2014). Further, we compare the production of a degenerate Fermi gas using both methods. Loading an optical dipole trap from the gray molasses yields a quantum degenerate sample with $3.3times10^5$ atoms, while loading from the denser UV MOT yields $2.4times10^6$ atoms. Where the highest atom numbers are not a priority this implementation of the gray molasses technique yields sufficiently large samples at a comparatively low technical effort.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا