اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدYielding and microstructure in a 2D jammed material under shear deformation
256
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The question of how a disordered materials microstructure translates into macroscopic mechanical response is central to understanding and designing materials like pastes, foams and metallic glasses. Here, we examine a 2D soft jammed material under cyclic shear, imaging the structure of ~50,000 particles. Below a certain strain amplitude, the structure becomes conserved at long times, while above, it continually rearranges. We identify the boundary between these regimes as a yield strain, defined without rheological measurement. Its value is consistent with a simultaneous but independent measurement of yielding by stress-controlled bulk rheometry. While there are virtually no irreversible rearrangements in the steady state below yielding, we find a largely stable population of plastic rearrangements that are reversed with each cycle. These results point to a microscopic view of mechanical properties under cyclic deformation.
قيم البحث
اقرأ أيضاً
We report on experiments that probe the stability of a two-dimensional jammed granular system formed by imposing a quasistatic simple shear strain $gamma_{rm I}$ on an initially stress free packing. We subject the shear jammed system to quasistatic c
yclic shear with strain amplitude $deltagamma$. We observe two distinct outcomes after thousands of shear cycles. For small $gamma_{rm I}$ or large $deltagamma$, the system reaches a stress-free, yielding state exhibiting diffusive strobed particle displacements with a diffusion coefficient proportional to $deltagamma$. For large $gamma_{rm I}$ and small $deltagamma$, the system evolves to a stable state in which both particle positions and contact forces are unchanged after each cycle and the response to small strain reversals is highly elastic. Compared to the original shear jammed state, a stable state reached after many cycles has a smaller stress anisotropy, a much higher shear stiffness, and less tendency to dilate when sheared. Remarkably, we find that stable states show a power-law relation between shear modulus and pressure with an exponent $betaapprox 0.5$, independent of $deltagamma$. Based on our measurements, we construct a phase diagram in the $(gamma_{rm I},deltagamma)$ plane showing where our shear-jammed granular materials either stabilize or yield in the long-time limit.
We study numerically the yielding transition of a two dimensional model glass subjected to athermal quasi-static cyclic shear deformation, with the aim of investigating the effect on the yielding behaviour of the degree of annealing, which in turn de
pends on the preparation protocol. We find two distinct regimes of annealing separated by a threshold energy. Poorly annealed glasses progressively evolve towards the threshold energy as the strain amplitude is increased towards the yielding value. Well annealed glasses with initial energies below the threshold energy exhibit stable behaviour, with negligible change in energy with increasing strain amplitude, till they yield. Discontinuities in energy and stress at yielding increase with the degree of annealing, consistently with recent results found in three dimensions. We observe significant structural change with strain amplitude that closely mirrors the changes in energy and stresses. We investigate groups of particles that are involved in plastic rearrangements. We analyse the distributions of avalanche sizes, of clusters of connected rearranging particles, and related quantities, employing finite size scaling analysis. We verify previously investigated relations between exponents characterising these distributions, and a newly proposed relation between exponents describing avalanche and cluster size distributions.
Granular materials react to shear stresses differently than do ordinary fluids. Rather than deforming uniformly, materials such as dry sand or cohesionless powders develop shear bands: narrow zones containing large relative particle motion leaving ad
jacent regions essentially rigid[1,2,3,4,5]. Since shear bands mark areas of flow, material failure and energy dissipation, they play a crucial role for many industrial, civil engineering and geophysical processes[6]. They also appear in related contexts, such as in lubricating fluids confined to ultra-thin molecular layers[7]. Detailed information on motion within a shear band in a three-dimensional geometry, including the degree of particle rotation and inter-particle slip, is lacking. Similarly, only little is known about how properties of the individual grains - their microstructure - affect movement in densely packed material[5]. Combining magnetic resonance imaging, x-ray tomography, and high-speed video particle tracking, we obtain the local steady-state particle velocity, rotation and packing density for shear flow in a three-dimensional Couette geometry. We find that key characteristics of the granular microstructure determine the shape of the velocity profile.
Considering a recently proposed model for the yielding of amorphous solids under cyclic shear deformation, we show that it can be analyzed by mapping it, in the simplest case, to a random walk in a confining potential with an absorbing boundary. The
dynamics is governed by the first passage time into the absorbing state, which captures the essential features of the original model, thereby providing insight into the observed robustness of earlier results. Including the possibility of activated escape from absorbing states leads to a unique determination of a threshold energy and yield strain, and further, suggests an appealing approach to understanding fatigue failure.
Dense suspensions are non-Newtonian fluids which exhibit strong shear thickening and normal stress differences. Using numerical simulation of extensional and shear flows, we investigate how rheological properties are determined by the microstructure
which is built under flows and by the interactions between particles. By imposing extensional and shear flows, we can assess the degree of flow-type dependence in regimes below and above thickening. Even when the flow-type dependence is hindered, nondissipative responses, such as normal stress differences, are present and characterise the non-Newtonian behaviour of dense suspensions.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
