ترغب بنشر مسار تعليمي؟ اضغط هنا

The metals-to-dust ratio to very low metallicities using GRB and QSO absorbers; extremely rapid dust formation

52   0   0.0 ( 0 )
 نشر من قبل Tayyaba Zafar
 تاريخ النشر 2013
  مجال البحث فيزياء
والبحث باللغة English
 تأليف Tayyaba Zafar




اسأل ChatGPT حول البحث

Among the key parameters defining the ISM of galaxies is the fraction of the metals that are locked up in dust: the metals-to-dust ratio. This ratio bears not only on the ISM and its evolution, but particularly on the origin of cosmic dust. We combine extinction and abundance data from GRB afterglows, from QSO absorbers, as well as from galaxy-lensed QSOs, to determine the metals-to-dust ratios for lines-of-sight through a wide diversity of galaxies from blue, dwarf starbursts to massive ellipticals, across a vast range in redshift z=0.1-6.3, and nearly three orders of magnitude in column density and metal abundance. We thus determine the metals-to-dust ratio in a unique way, providing direct determinations of in situ gas and dust columns without recourse to assumptions with large uncertainties. We find that the metals-to-dust ratios in these systems are surprisingly close to the value for the local group (10^{21.3} cm-2 A_V mag-1), with a mean value of 10^{21.2} cm-2 A_V mag-1 and a standard deviation of 0.3 dex. There is no evidence of deviation from this mean ratio as a function of metallicity, even down to our lowest metallicity of 0.01 Z/Z_sun. The lack of any obvious dependence of the metals-to-dust ratio on either column density, galaxy type or age, redshift, or metallicity indicates a close correspondence between the formation of the metals and the formation of dust. Any delay between the formation of metals and dust must be shorter than the typical metal-enrichment times of these galaxies. Formation of the bulk of the dust in low mass stars is therefore ruled out by these data at any cosmic epoch. Furthermore, dust destruction must not dominate over formation/growth in virtually any galaxy environment. The correlation between metals and dust is a natural consequence of the formation of the bulk of dust in SNe [Abridged].


قيم البحث

اقرأ أيضاً

We explore the minimal conditions which enable the formation of metal-enriched solar and sub-solar mass stars. We find that in the absence of dust grains, gas fragmentation occurs at densities nH ~ [10^4-10^5]cm^{-3} when the metallicity exceeds Z ~ 10^{-4} Zsun. The resulting fragmentation masses are > 10 Msun. The inclusion of Fe and Si cooling does not affect the thermal evolution as this is dominated by molecular cooling even for metallicities as large as Z = 10^{-2} Zsun. The presence of dust is the key driver for the formation of low-mass stars. We focus on three representative core-collapse supernova (SN) progenitors, and consider the effects of reverse shocks of increasing strength: these reduce the depletion factors, fdep = Mdust/(Mdust+Mmet), alter the shape of the grain size distribution function and modify the relative abundances of grain species and of metal species in the gas phase. We find that the lowest metallicity at which fragmentation occurs is Z=10^{-6} Zsun for gas pre-enriched by the explosion of a 20 Msun primordial SN (fdep > 0.22) and/or by a 35 Msun, Z=10^{-4} Zsun SN (fdep > 0.26); it is ~ 1 dex larger, when the gas is pre-enriched by a Z = 10^{-4} Zsun, 20 Msun SN (fdep > 0.04). Cloud fragmentation depends on the depletion factor and it is suppressed when the reverse shock leads to a too large destruction of dust grains. These features are all consistent with the existence of a minimum dust-to-gas ratio, Dcr, above which fragmentation is activated. We derive a simple analytic expression for Dcr which, for grain composition and properties explored in the present study, reads Dcr = [2.6 - 6.3] x 10^{-9}. When the dust-to-gas ratio of star forming clouds exceeds this value, the fragmentation masses range between 0.01 Msun and 1 Msun, thus enabling the formation of the first low-mass stars.
69 - Lars Mattsson 2019
Turbulence can significantly accelerate the growth of dust grains by accretion of molecules. For dust dynamically coupled to the gas, the growth rate scales with the square of the Mach number, which means that the growth timescale can easily be reduc ed by more than an order of magnitude. The limiting timescale is therefore rather the rate of molecular cloud formation, which means that dust production in the ISM can rapidly reach the levels needed to explain the dust masses observed at high redshifts. Thus, turbulence may be the solution to the replenishment problem in models of dust evolution in high-redshift galaxies and explain the dust masses seen at $z = 7 - 8$. A simple analytic galactic dust-evolution model is presented, where grain growth nicely compensates for the expected higher rate of dust destruction by supernova shocks. This model is simpler, relies on fewer assumptions and seems to yields a better fit to data derived from observations, compared to previous models of the same type.
We investigate the relationship between the dust-to-metals ratio (D/M) and the local interstellar medium environment at ~2 kpc resolution in five nearby galaxies: IC342, M31, M33, M101, and NGC628. A modified blackbody model with a broken power-law e missivity is used to model the dust emission from 100 to 500 um observed by Herschel. We utilize the metallicity gradient derived from auroral line measurements in HII regions whenever possible. Both archival and new CO rotational line and HI 21 cm maps are adopted to calculate gas surface density, including new wide field CO and HI maps for IC342 from IRAM and the VLA, respectively. We experiment with several prescriptions of CO-to-H$_2$ conversion factor, and compare the resulting D/M-metallicity and D/M-density correlations, both of which are expected to be non-negative from depletion studies. The D/M is sensitive to the choice of the conversion factor. The conversion factor prescriptions based on metallicity only yield too much molecular gas in the center of IC342 to obtain the expected correlations. Among the prescriptions tested, the one that yields the expected correlations depends on both metallicity and surface density. The 1-$sigma$ range of the derived D/M spans 0.40-0.58. Compared to chemical evolution models, our measurements suggest that the dust growth time scale is much shorter than the dust destruction time scale. The measured D/M is consistent with D/M in galaxy-integrated studies derived from infrared dust emission. Meanwhile, the measured D/M is systematically higher than the D/M derived from absorption, which likely indicates a systematic offset between the two methods.
In order to investigate the origin of the excess of strong MgII systems towards GRB afterglows as compared to QSO sightlines, we have measured the incidence of MgII absorbers towards a third class of objects: the Blazars. This class includes the BL L ac object population for which a tentative excess of MgII systems had already been reported. We observed with FORS1 at the ESO-VLT 42 Blazars with an emission redshift 0.8<z_em<1.9, to which we added the three high z northern objects belonging to the 1Jy BL Lac sample. We detect 32 MgII absorbers in the redshift range 0.35-1.45, leading to an excess in the incidence of MgII absorbers compared to that measured towards QSOs by a factor ~2, detected at 3 sigma. The amplitude of the effect is similar to that found along GRB sightlines. Our analysis provides a new piece of evidence that the observed incidence of MgII absorbers might depend on the type of background source. In front of Blazars, the excess is apparent for both strong (w_ r(2796) > 1.0 A) and weaker (0.3 < w_r(2796) < 1.0 A) MgII systems. The dependence on velocity separation with respect to the background Blazars indicates, at the ~1.5 sigma level, a potential excess for beta = v/c ~0.1. We show that biases involving dust extinction or gravitational amplification are not likely to notably affect the incidence of MgII systems towards Blazars. Finally we discuss the physical conditions required for these absorbers to be gas entrained by the powerful Blazar jets. More realistic numerical modelling of jet-ambient gas interaction is required to reach any firm conclusions as well as repeat observations at high spectral resolution of strong MgII absorbers towards Blazars in both high and low states.
We aim at assessing what are the most dominant dust species or types, including silicate and iron oxide grains present in the ISM, by using recent observations of dust depletion of galaxies at various evolutionary stages. We use the observed elementa l abundances in dust of several metals (O, S, Si, Mg, and Fe) in different environments, considering systems with different metallicities and dust content, namely damped Lyman-{alpha} absorbers (DLAs) towards quasars and the Galaxy. We derive a possible dust composition by computationally finding the statistically expected elemental abundances in dust assuming a set of key dust species with the iron content as a free parameter. Carbonaceous dust is not considered in the present study. Metallic iron (likely in the form of inclusions in silicate grains) and iron oxides is an important component of the mass composition of carbon-free dust. Iron oxides make up a significant mass fraction (~1/4 in some cases) of the oxygen-bearing dust and there are good reasons to believe that metallic iron constitutes a similar mass fraction of dust. Wustite (FeO) could be a simple explanation for the depletion of iron and oxygen because it is easily formed. There appears to be no silicate species clearly dominating the silicate mass, but rather a mix of iron-poor as well as iron-rich olivine and pyroxene. To what extent sulphur depletion is due to sulfides remains unclear. In general, there seems to be little evolution of the dust composition (not considering carbonaceous dust) from low-metallicity systems to the Galaxy.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا