اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدPhonon Heat Conduction in Corrugated Silicon Nanowires Below the Casimir Limit
55
0
0.0
(
0
)
تأليف
Christophe Blanc
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The thermal conductance of straight and corrugated monocrystalline silicon nanowires has been measured between 0.3 K and 5 K. The difference in the thermal transport between corrugated nanowires and straight ones demonstrates a strong reduction in the mean free path of the phonons. This averaged mean free path is remarkably smaller than the smaller diameter of the nanowire, evidencing a phonon thermal transport reduced below the Casimir limit. Monte Carlo simulations highlight that this effect can be attributed to significant multiple scattering of ballistic phonons occuring on the corrugated surfaces. This result suggests an original approach to transforming a monocrystalline material into a phonon glass.
قيم البحث
اقرأ أيضاً
Aluminum scandium nitride alloy (Al1-xScxN) is regarded as a promising material for high-performance acoustic devices used in wireless communication systems. Phonon scattering and heat conduction processes govern the energy dissipation in acoustic re
sonators, ultimately determining their performance quality. This work reports, for the first time, on phonon scattering processes and thermal conductivity in Al1-xScxN alloys with the Sc content (x) up to 0.26. The thermal conductivity measured presents a descending trend with increasing x. Temperature-dependent measurements show an increase in thermal conductivity as the temperature increases at temperatures below 200K, followed by a plateau at higher temperatures (T> 200K). Application of a virtual crystal phonon conduction model allows us to elucidate the effects of boundary and alloy scattering on the observed thermal conductivity behaviors. We further demonstrate that the alloy scattering is caused mainly by strain-field difference, and less by the atomic mass difference between ScN and AlN, which is in contrast to the well-studied Al1-xGaxN and SixGe1-x alloy systems where atomic mass difference dominates the alloy scattering. This work studies and provides the quantitative knowledge for phonon scattering and the thermal conductivity in Al1-xScxN, paving the way for future investigation of materials and design of acoustic devices.
Previous studies have predicted the failure of Fouriers law of thermal conduction due to the existence of wave like propagation of heat with finite propagation speed. This non-Fourier thermal transport phenomenon can appear in both the hydrodynamic a
nd (quasi) ballistic regimes. Hence, it is not easy to clearly distinguish these two non-Fourier regimes only by this phenomenon. In this work, the transient heat propagation in homogeneous thermal system is studied based on the phonon Boltzmann transport equation (BTE) under the Callaway model. Given a quasi-one or quasi-two (three) dimensional simulation with homogeneous environment temperature, at initial moment, a heat source is added suddenly at the center with high temperature, then the heat propagates from the center to the outer. Numerical results show that in quasi-two (three) dimensional simulations, the transient temperature will be lower than the lowest value of initial temperature in the hydrodynamic regime within a certain range of time and space. This phenomenon appears only when the normal scattering dominates heat conduction. Besides, it disappears in quasi-one dimensional simulations. Similar phenomenon is also observed in thermal systems with time varying heat source. This novel transient heat propagation phenomenon of hydrodynamic phonon transport distinguishes it well from (quasi) ballistic phonon transport.
Understanding microscopic heat conduction in thin films is important for nano/micro heat transfer and thermal management for advanced electronics. As the thickness of thin films is comparable to or shorter than a phonon wavelength, phonon dispersion
relations and transport properties are significantly modulated, which should be taken into account for heat conduction in thin films. Although phonon confinement and depletion effects have been considered, it should be emphasized that surface-localized phonons (surface phonons) arise whose influence on heat conduction may not be negligible due to the high surface-to-volume ratio. However, the role of surface phonons in heat conduction has received little attention thus far. In the present work, we performed anharmonic lattice dynamics calculations to investigate the thickness and temperature dependence of in-plane thermal conductivity of silicon thin films with sub-10-nm thickness in terms of surface phonons. Through systematic analysis of the influences of surface phonons, we found that anharmonic coupling between surface and internal phonons localized in thin films significantly suppresses overall in-plane heat conduction in thin films. We also discovered that specific low-frequency surface phonons significantly contribute to surface--internal phonon scattering and heat conduction suppression. Our findings are beneficial for the thermal management of electronics and phononic devices and may lead to surface phonon engineering for thermal conductivity control.
In stark contrast with three-dimensional (3D) nanostructures, we show that boundary scattering in two-dimensional (2D) nanoribbons alone does not lead to a finite phonon mean free path. If combined with an intrinsic scattering mechanism, 2D boundary
scattering does reduce the overall mean free path, however the latter does not scale proportionally to the ribbon width, unlike the well known Casimir regime occurring in 3D nanowires. We show that boundary scattering can be accounted for by a simple Mathiessen type approach for many different 3D nanowire cross sectional shapes, however this is not possible in the 2D nanoribbon case, where a complete solution of the Boltzmann transport equation is required. These facts have strong implications for the thermal conductivity of suspended nanostructures.
This review focuses on the investigation and enhancement of the thermoelectric properties of semiconducting nanowires (NWs). NWs are nanostructures with typical diameters between few to hundreds of nm and length of few to several microns, exhibiting
a high surface-to-volume ratio. Nowadays an extraordinary control over their growth has been achieved, enabling also the integration of different types of heterostructures, which can lead to the engineering of the functional properties of the NWs. In this review, we discuss all concepts which have been presented and achieved so far for the improvements of the thermoelectric performances of semiconducting NWs. Furthermore, we present a brief survey of the experimental methods which enable the investigation of the thermoelectric properties of these nanostructures.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
