اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدElectronic structure of vacancy-ordered iron-selenide K$_{0.5}$Fe$_{1.75}$Se$_2$
225
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The electronic structure of the vacancy-ordered K$_{0.5}$Fe$_{1.75}$Se$_2$ iron-selenide compound (278 phase) is studied using the first-principles density functional method. The ground state of the 278 phase is stripe-like antiferromagnetic, and its bare electron susceptibility shows a large peak around $(pi, pi)$ in the folded Brillouin zone. Near Fermi level, the density of states are dominated by the Fe-3d orbitals, and both electron-like and hole-like Fermi surfaces appear in the Brillouin zone. Unfolded band structure shows limited similarities to a hole doped 122 phase. With 0.1e electron doping, the susceptibility peak is quickly suppressed and broadened; while the two-dimensionality of the electron-like Fermi surfaces are greatly enhanced, resulting in a better nesting behavior. Our study should be relevant to the recently reported superconducting phase K$_{0.5+x}$Fe$_{1.75+y}$Se$_2$ with both $x$ and $y$ very tiny.
قيم البحث
اقرأ أيضاً
We report an infrared spectroscopy study on K$_{0.83}$Fe$_{1.53}$Se$_2$, a semiconducting parent compound of the new iron-selenide system. The major spectral features are found to be distinctly different from all other Fe-based superconducting system
s. Our measurement revealed two peculiar spectral structures: a double peak structure between 4000-6000 cm$^{-1}$ and abundant phonon modes much more than those expected for a 122 structure. We elaborate that those features could be naturally explained from the blocked antiferromagnetism due to the presence of Fe vacancy ordering as determined by recent neutron diffraction experiments. The double peaks reflect the coexistence of ferromagnetic and antiferromagnetic couplings between the neighboring Fe sites.
Since the discovery of high-temperature superconductivity in the thin-film FeSe/SrTiO$_3$ system, iron selenide and its derivates have been intensively scrutinized. Using ab initio density functional theory calculations we review the electronic struc
tures that could be realized in iron-selenide if the structural parameters could be tuned at liberty. We calculate the momentum-dependence of the susceptibility and investigate the symmetry of electron pairing within the random phase approximation. Both the susceptibility and the symmetry of electron pairing depend on the structural parameters in a nontrivial way. These results are consistent with the known experimental behavior of binary iron chalcogenides and, at the same time, reveal two promising new ways of tuning superconducting transition temperatures in these materials. On the one hand by expanding the iron lattice of FeSe at constant iron-selenium distance and, on the other hand, by increasing the iron-selenium distance with unchanged iron lattice.
We report polarized neutron scattering measurements of the low energy spin fluctuations of the iron-selenide superconductor Li$_{0.8}$Fe$_{0.2}$ODFeSe below and above its superconducting transition temperature $T_c=41$ K. Our experiments confirmed th
at the resonance mode near 21 meV is magnetic. Moreover, the spin excitations are essentially isotropic in spin space at 5$leq Eleq$ 29 meV in the superconducting and normal states. Our results suggest that the resonance mode in iron-based superconductors becomes isotropic when the influence of spin-orbit coupling and magnetic/nematic order is minimized, similar to those observed in cuprate superconductors.
The recent discovery of high-temperature superconductivity in single-layer iron selenide has generated significant experimental interest for optimizing the superconducting properties of iron-based superconductors through the lattice modification. For
simulating the similar effect by changing the chemical composition due to S doping, we investigate the superconducting properties of high-quality single crystals of FeSe$_{1-x}$S$_{x}$ ($x$=0, 0.04, 0.09, and 0.11) using magnetization, resistivity, the London penetration depth, and low temperature specific heat measurements. We show that the introduction of S to FeSe enhances the superconducting transition temperature $T_{c}$, anisotropy, upper critical field $H_{c2}$, and critical current density $J_{c}$. The upper critical field $H_{c2}(T)$ and its anisotropy are strongly temperature dependent, indicating a multiband superconductivity in this system. Through the measurements and analysis of the London penetration depth $lambda _{ab}(T)$ and specific heat, we show clear evidence for strong coupling two-gap $s$-wave superconductivity. The temperature-dependence of $lambda _{ab}(T)$ calculated from the lower critical field and electronic specific heat can be well described by using a two-band model with $s$-wave-like gaps. We find that a $d$-wave and single-gap BCS theory under the weak-coupling approach can not describe our experiments. The change of specific heat induced by the magnetic field can be understood only in terms of multiband superconductivity.
In unconventional superconductors, it is generally believed that understanding the physical properties of the normal state is a pre-requisite for understanding the superconductivity mechanism. In conventional superconductors like niobium or lead, the
normal state is a Fermi liquid with a well-defined Fermi surface and well-defined quasipartcles along the Fermi surface. Superconductivity is realized in this case by the Fermi surface instability in the superconducting state and the formation and condensation of the electron pairs (Cooper pairing). The high temperature cuprate superconductors, on the other hand, represent another extreme case that superconductivity can be realized in the underdoped region where there is neither well-defined Fermi surface due to the pseudogap formation nor quasiparticles near the antinodal regions in the normal state. Here we report a novel scenario that superconductivity is realized in a system with well-defined Fermi surface but without quasiparticles along the Fermi surface in the normal state. High resolution laser-based angle-resolved photoemission measurements have been performed on an optimally-doped iron-based superconductor (Ba$_{0.6}$K$_{0.4}$)Fe$_2$As$_2$. We find that, while sharp superconducting coherence peaks emerge in the superconducting state on the hole-like Fermi surface sheets, no quasiparticle peak is present in the normal state. Its electronic behaviours deviate strongly from a Fermi liquid system. The superconducting gap of such a system exhibits an unusual temperature dependence that it is nearly a constant in the superconducting state and abruptly closes at T$_c$. These observations have provided a new platform to study unconventional superconductivity in a non-Fermi liquid system.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
