اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدWavefront Phase Retrieval with Non-linear Curvature Sensors
157
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Increasing interest in astronomical applications of non-linear curvature wavefront sensors for turbulence detection and correction makes it important to understand how best to handle the data they produce, particularly at low light levels. Algorithms for wavefront phase-retrieval from a four-plane curvature wavefront sensor are developed and compared, with a view to their use for low order phase compensation in instruments combining adaptive optics and Lucky Imaging. The convergence speed and quality of iterative algorithms is compared to their step-size and techniques for phase retrieval at low photon counts are explored. Computer simulations show that at low light levels, preprocessing by convolution of the measured signal with a gaussian function can reduce by an order of magnitude the photon flux required for accurate phase retrieval of low-order errors. This facilitates wavefront correction on large telescopes with very faint reference stars.
قيم البحث
اقرأ أيضاً
The Adaptive Optics Lucky Imager (AOLI) is a new instrument under development to demonstrate near diffraction limited imaging in the visible on large ground-based telescopes. We present the adaptive optics system being designed for the instrument com
prising a large stroke deformable mirror, fixed component non-linear curvature wavefront sensor and photon-counting EMCCD detectors. We describe the optical design of the wavefront sensor where two photoncounting CCDs provide a total of four reference images. Simulations of the optical characteristics of the system are discussed, with their relevance to low and high order AO systems. The development and optimisation of high-speed wavefront reconstruction algorithms are presented. Finally we discuss the results of simulations to demonstrate the sensitivity of the system.
We discuss the use of parametric phase-diverse phase retrieval as an in-situ high-fidelity wavefront measurement method to characterize and optimize the transmitted wavefront of a high-contrast coronagraphic instrument. We apply our method to correct
the transmitted wavefront of the HiCAT (High contrast imager for Complex Aperture Telescopes) coronagraphic testbed. This correction requires a series of calibration steps, which we describe. The correction improves the system wavefront from 16 nm RMS to 3.0 nm RMS.
Fourier-based wavefront sensors, such as the Pyramid Wavefront Sensor (PWFS), are the current preference for high contrast imaging due to their high sensitivity. However, these wavefront sensors have intrinsic nonlinearities that constrain the range
where conventional linear reconstruction methods can be used to accurately estimate the incoming wavefront aberrations. We propose to use Convolutional Neural Networks (CNNs) for the nonlinear reconstruction of the wavefront sensor measurements. It is demonstrated that a CNN can be used to accurately reconstruct the nonlinearities in both simulations and a lab implementation. We show that solely using a CNN for the reconstruction leads to suboptimal closed loop performance under simulated atmospheric turbulence. However, it is demonstrated that using a CNN to estimate the nonlinear error term on top of a linear model results in an improved effective dynamic range of a simulated adaptive optics system. The larger effective dynamic range results in a higher Strehl ratio under conditions where the nonlinear error is relevant. This will allow the current and future generation of large astronomical telescopes to work in a wider range of atmospheric conditions and therefore reduce costly downtime of such facilities.
The Large Synoptic Survey Telescope (LSST) will use an active optics system (AOS) to maintain alignment and surface figure on its three large mirrors. Corrective actions fed to the LSST AOS are determined from information derived from 4 curvature wav
efront sensors located at the corners of the focal plane. Each wavefront sensor is a split detector such that the halves are 1mm on either side of focus. In this paper we describe the extensions to published curvature wavefront sensing algorithms needed to address challenges presented by the LSST, namely the large central obscuration, the fast f/1.23 beam, off-axis pupil distortions, and vignetting at the sensor locations. We also describe corrections needed for the split sensors and the effects from the angular separation of different stars providing the intra- and extra-focal images. Lastly, we present simulations that demonstrate convergence, linearity, and negligible noise when compared to atmospheric effects when the algorithm extensions are applied to the LSST optical system. The algorithm extensions reported here are generic and can easily be adapted to other wide-field optical systems including similar telescopes with large central obscuration and off-axis curvature sensing.
We investigate the improvements in Shack-Hartmann wavefront sensor image processing that can be realised using total variation minimisation techniques to remove noise from these images. We perform Monte-Carlo simulation to demonstrate that at certain
signal-to-noise levels, sensitivity improvements of up to one astronomical magnitude can be realised. We also present on-sky measurements taken with the CANARY adaptive optics system that demonstrate an improvement in performance when this technique is employed, and show that this algorithm can be implemented in a real-time control system. We conclude that total variation minimisation can lead to improvements in sensitivity of up to one astronomical magnitude when used with adaptive optics systems.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
