اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدDoping incorporation paths in catalyst-free Be-doped GaAs nanowires
323
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The incorporation paths of Be in GaAs nanowires grown by the Ga-assisted method in molecular beam epitaxy has been investigated by electrical measurements of nanowires with different doping profiles. We find that Be atoms incorporate preferentially via the nanowire side facets, while the incorporation path through the Ga droplet is negligible. We also demonstrate that Be can diffuse into the volume of the nanowire giving an alternative incorporation path. This work is an important step towards controlled doping of nanowires and will serve as a help for designing future devices based on nanowires.
قيم البحث
اقرأ أيضاً
We simulated and experimentally investigated the sputter yield of ZnO and GaAs nanowires, which were implanted with energetic Mn ions at room temperature. The resulting thinning of the nanowires and the dopant concentration with increasing Mn ion flu
ency were measured by accurate scanning electron microscopy (SEM) and nano-X-Ray Fluorescence (nanoXRF) quantification, respectively. We observed a clear enhanced sputter yield for the irradiated nanowires compared to bulk, which is also corroborated by iradina simulations. These show a maximum if the ion range matches the nanowire diameter. As a consequence of the erosion thinning of the nanowire, the incorporation of the Mn dopants is also enhanced and increases non-linearly with increasing ion fluency.
GaAs was central to the development of quantum devices but is rarely used for nanowire-based quantum devices with InAs, InSb and SiGe instead taking the leading role. p-type GaAs nanowires offer a path to studying strongly-confined 0D and 1D hole sys
tems with strong spin-orbit effects, motivating our development of nanowire transistors featuring Be-doped p-type GaAs nanowires, AuBe alloy contacts and patterned local gate electrodes towards making nanowire-based quantum hole devices. We report on nanowire transistors with traditional substrate back-gates and EBL-defined metal/oxide top-gates produced using GaAs nanowires with three different Be-doping densities and various AuBe contact processing recipes. We show that contact annealing only brings small improvements for the moderately-doped devices under conditions of lower anneal temperature and short anneal time. We only obtain good transistor performance for moderate doping, with conduction freezing out at low temperature for lowly-doped nanowires and inability to reach a clear off-state under gating for the highly-doped nanowires. Our best devices give on-state conductivity 95 nS, off-state conductivity 2 pS, on-off ratio ~$10^{4}$, and sub-threshold slope 50 mV/dec at T = 4 K. Lastly, we made a device featuring a moderately-doped nanowire with annealed contacts and multiple top-gates. Top-gate sweeps show a plateau in the sub-threshold region that is reproducible in separate cool-downs and indicative of possible conductance quantization highlighting the potential for future quantum device studies in this material system.
The resistivity and the mobility of Carbon doped GaAs nanowires have been studied for different doping concentrations. Surface effects have been evaluated by comparing upassivated with passivated nanowires. We directly see the influence of the surfac
e: the pinning of the Fermi level and the consequent existence of a depletion region lead to an increase of the mobility up to 30 cm^2/(V*s) for doping concentrations lower than 3*10^18 cm^-3. Electron beam induced current measurements show that the minority carrier diffusion path can be as high as 190 nm for passivated nanowires.
The synthesis of Si3N4 nanowires from the reaction of silicon nanoparticles with N2 in the 1200-1440 C temperature range is reported. The nitridation conditions are such that the reaction with nitrogen is favoured by the presence of silicon oxide in
the particles and by the active oxidation of silicon without a catalyst. It is shown that the Si to Si3N4 conversion rate depends on the amount of silicon particles used in the experiments and that, in general, the reaction slows down for greater amounts. This trend is explained by particle stacking, which restricts the exchange of gases between the furnace atmosphere and the atmosphere around the inner particles. In a first stage, local oxygen partial pressure increases around the inner particles and inhibits nitridation locally. If the amount of reactant Si nanoparticles is small enough, this extrinsic effect is avoided and the intrinsic nitridation kinetics can be measured. Experiments show that intrinsic kinetics does not depend on temperature.
Growth of GaAs and InGaAs nanowires by the group-III assisted Molecular Beam Epitaxy growth method is studied in dependence of growth temperature, with the objective of maximizing the indium incorporation. Nanowire growth was achieved for growth temp
eratures as low as 550{deg}C. The incorporation of indium was studied by low temperature micro-photoluminescence spectroscopy, Raman spectroscopy and electron energy loss spectroscopy. The results show that the incorporation of indium lowering the growth temperature does not have an effect in increasing the indium concentration in the bulk of the nanowire, which is limited to 3-5%. For growth temperatures below 575{deg}C, indium rich regions form at the surface of the nanowires as a consequence of the radial growth. This results in the formation of quantum dots, which exhibit extremely sharp luminescence.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
