اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدPreparation and characterization of highly thulium- and alumina-doped optical fibers for single-frequency fiber lasers
85
0
0.0
(
0
)
تأليف
Pavel Honzatko
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Thulium-doped fibers suitable for core-pumped single-frequency lasers were fabricated by the modified chemical vapor deposition (MCVD) method. Refractive index profile, doping profile and spectral absorption was measured. High doping concentration of thulium ions should be achieved to allow for high absorption of light at a pump wavelength while the thulium ions clustering should be avoided to prevent the cooperative upconversion and quenching processes. The fabricated fibers featured pump absorption up to 70dB/m at a pump wavelength of 1611nm. The single-frequency master oscillator with a resonator composed of a pair of fiber Bragg gratings and a thulium-doped fiber was demonstrated with predominantly single ended operation. We achieved a slope efficiency of 22% and a threshold of 22mW at a lasing wavelength of 1944nm.
قيم البحث
اقرأ أيضاً
Highly efficient coupling of photons from nanoemitters into single-mode optical fibers is demonstrated using tapered fibers. 7.4 +/- 1.2 % of the total emitted photons from single CdSe/ZnS nanocrystals were coupled into a 300-nm-diameter tapered fibe
r. The dependence of the coupling efficiency on the taper diameter was investigated and the coupling efficiency was found to increase exponentially with decreasing diameter. This method is very promising for nanoparticle sensing and single-photon sources.
We report on the design and whole characterization of low-noise and affordable-cost Yb-doped double-clad fiber amplifiers operating at room temperature in the near-infrared spectral region at pulse repetition rate of 160 MHz. Two different experiment
al configurations are discussed. In the first one, a broadband seed radiation with a transform limited pulse duration of 71 fs, an optical spectrum of 20 nm wide at around 1040 nm, and 20 mW average power is adopted. In the second configuration, the seed radiation is constituted by stretched pulses with a time duration as long as 170 ps, with a 5-nm narrow pulse spectrum centered at 1029 nm and 2 mW average input power. In both cases we obtained transform limited pulse trains with an amplified output power exceeding 2 W. Furthermore, relative intensity noise measurements show that no significant noise degradation occurs during the amplification process.
Deformed square resonators with the flat sides replaced by circular sides are proposed and demonstrated to enhance mode Q factors and adjust transverse mode intervals using the regular ray dynamic analysis and numerical simulations. Dual-transverse-m
ode emissions due to the ultrahigh-Q factors with different wavelength intervals are realized experimentally for AlGaInAs/InP circular-side square microlasers, and the stationary condition of the dual-mode emission is satisfied because the high-Q confined modes have totally different mode numbers. Furthermore, optical frequency combs are generated using the dual-mode lasing microlaser as a seeding light source by cascaded four-wave mixing in a highly nonlinear optical fiber.
Complex assemblies of light-emitting polymer nanofibers with molecular materials exhibiting optical gain can lead to important advance to amorphous photonics and to random laser science and devices. In disordered mats of nanofibers, multiple scatteri
ng and waveguiding might interplay to determine localization or spreading of optical modes as well as correlation effects. Here we study electrospun fibers embedding a lasing fluorene-carbazole-fluorene molecule and doped with titania nanoparticles, which exhibit random lasing with sub-nm spectral width and threshold of about 9 mJ cm^-2 for the absorbed excitation fluence. We focus on the spatial and spectral behavior of optical modes in the disordered and non-woven networks, finding evidence for the presence of modes with very large spatial extent, up to the 100 micrometer-scale. These findings suggest emission coupling into integrated nanofiber transmission channels as effective mechanism for enhancing spectral selectivity in random lasers and correlations of light modes in the complex and disordered material.
This paper presents the progress in the fields of the modelling and design of lanthanide ion doped chalcogenide glass fiber lasers. It presents the laser cavity designs that have been developed in order to optimize the performance of lanthanide ion d
oped chalcogenide glass fiber lasers. Also various numerical algorithms that have been applied for the optimization of chalcogenide glass lasers are reviewed and compared. The comparison shows that a combination of less accurate but more robust algorithms with more accurate ones gives the most promising performance.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
