اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدProviding 1E-16 short-term stability of a 1.5 {mu}m laser to optical clocks
123
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We report on transferring 1E-16-level fractional frequency stability of a master laser operated at 1.5 {mu}m to a slave laser operated at 698 nm, using a femtosecond fiber comb as transfer oscillator. With the 698 nm laser, the 1S_0 - 3P_0 clock transition of 87Sr was resolved to a Fourier-limited line width of 1.5 Hz (before: 10 Hz). Potential noise sources contributed by the frequency comb are discussed in detail.
قيم البحث
اقرأ أيضاً
We report the coherent phase-locking of a quantum cascade laser (QCL) at 10-$mu$m to the secondary frequency standard of this spectral region, a CO2 laser stabilized on a saturated absorption line of OsO4. The stability and accuracy of the standard a
re transferred to the QCL resulting in a line width of the order of 10 Hz, and leading to our knowledge to the narrowest QCL to date. The locked QCL is then used to perform absorption spectroscopy spanning 6 GHz of NH3 and methyltrioxorhenium, two species of interest for applications in precision measurements.
We developed an all-optical link system for making remote comparisons of two distant ultra-stable optical clocks. An optical carrier transfer system based on a fiber interferometer was employed to compensate the phase noise accumulated during the pro
pagation through a fiber link. Transfer stabilities of $2times10^{-15}$ at 1 second and $4times10^{-18}$ at 1000 seconds were achieved in a 90-km link. An active polarization control system was additionally introduced to maintain the transmitted light in an adequate polarization, and consequently, a stable and reliable comparison was accomplished. The instabilities of the all-optical link system, including those of the erbium doped fiber amplifiers (EDFAs) which are free from phase-noise compensation, were below $2times10^{-15}$ at 1 second and $7times10^{-17}$ at 1000 seconds. The system was available for the direct comparison of two distant $^{87}$Sr lattice clocks via an urban fiber link of 60 km. This technique will be essential for the measuring the reproducibility of optical frequency standards.
We report the first mode-locked fiber laser to operate in the femtosecond regime well beyond 3 {mu}m. The laser uses dual-wavelength pumping and non-linear polarisation rotation to produce 3.5 {mu}m wavelength pulses with minimum duration of 580 fs a
t a repetition rate of 68 MHz. The pulse energy is 3.2 nJ, corresponding to a peak power of 5.5 kW.
We report an all-polarization-maintaining fiber optic approach to generating sub-2 cycle pulses at 2 {mu}m and a corresponding octave-spanning optical frequency comb. Our configuration leverages mature Er:fiber laser technology at 1.5 {mu}m to provid
e a seed pulse for a thulium-doped fiber amplifier that outputs 330 mW average power at 100 MHz repetition rate. Following amplification, nonlinear self-compression in fiber decreases the pulse duration to 9.5 fs, or 1.4 optical cycles. Approximately 32 % of the energy sits within the pulse peak, and the polarization extinction ratio is more than 15 dB. The spectrum of the ultrashort pulse spans from 1 {mu}m to beyond 2.4 {mu}m and enables direct measurement of the carrier-envelope offset frequency using only 12 mW, or ~3.5 % of the total power. Our approach employs only commercially-available fiber components, resulting in a turnkey amplifier design that is compact, and easy to reproduce in the larger community. Moreover, the overall design and self-compression mechanism are scalable in repetition rate and power. As such, this system should be useful as a robust frequency comb source in the near-infrared or as a pump source to generate mid-infrared frequency combs.
We stabilized the frequency of a compact planar-waveguide external cavity laser (ECL) on a Fabry-Perot cavity (FPC) through a Pound-Drever-Hall scheme. The residual frequency stability of the ECL is 1E-14, comparable to the stability achievable with
a fiber laser (FL) locked to a FPC through the same scheme. We set up an optical link of 100 km, based on fiber spools, that reaches 1E-19 relative stability, and we show that its performances using the ECL or FL are comparable. Thus ECLs could serve as an excellent replacement for FLs in optical links where cost-effectiveness and robustness are important considerations.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
