اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدThe broad emission-line region: the confluence of the outer accretion disc with the inner edge of the dusty torus
223
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
(Abridged) We investigate the observational characteristics of BLR geometries in which the BLR clouds bridge the gap, both in distance and scale height, between the outer accretion disc and the hot dust, forming an effective surface of a bowl. The gas dynamics are dominated by gravity, and we include the effects of transverse Doppler shift, gravitational redshift and scale-height dependent macro-turbulence. Our simple model reproduces many of the phenomena observed in broad emission-line variability studies, including (i) the absence of response in the core of the optical recombination lines on short timescales, (ii) the enhanced red-wing response on short timescales, (iii) differences between the measured delays for the HILs and LILs, and (iv) identifies turbulence as a means of producing Lorentzian profiles (esp. for LILs) in low inclination systems, and for suppressing significant continuum--emission-line delays between the line wings and line core (esp. in LILs). A key motivation of this work was to reveal the physical underpinnings of the reported measurements of SMBH masses and their uncertainties. We find that SMBH masses derived from measurements of the fwhm of the mean and rms profiles show the closest correspondence between the emission lines in a single object, even though the emission line fwhm is a more biased mass indicator with respect to inclination. The predicted large discrepancies in the SMBH mass estimates between emission lines at low inclination, as derived using the line dispersion, we suggest may be used as a means of identifying near face-on systems. Our general results do not depend on specific choices in the simplifying assumptions, but are in fact generic properties of BLR geometries with axial symmetry that span a substantial range in radially-increasing scale height supported by turbulence, which then merge into the inner dusty TOR.
قيم البحث
اقرأ أيضاً
The existence of intermediate-width emission line regions (IELRs) in active galactic nuclei has been discussed for over two decades. A consensus, however, is yet to be arrived at due to the lack of convincing evidence for their detection. We present
a detailed analysis of the broadband spectrophotometry of the partially obscured quasar OI 287. The ultraviolet intermediate-width emission lines (IELs) are very prominent, in high contrast to the corresponding broad emission lines (BELs) which are heavily suppressed by dust reddening. Assuming that the IELR is virialized, we estimated its distance to the central black hole of $sim 2.9$ pc, similar to the dust sublimation radius of $sim 1.3$ pc. Photo-ionization calculations suggest that the IELR has a hydrogen density of $sim 10^{8.8}-10^{9.4} ~ rm cm^{-3}$, within the range of values quoted for the dusty torus near the sublimation radius. Both its inferred location and physical conditions suggest that the IELR originates from the inner surface of the dusty torus. In the spectrum of this quasar, we identified only one narrow absorption-line system associated with the dusty material. With the aid of photo-ionization model calculations, we found that the obscuring material might originate from an outer region of the dusty torus. We speculate that the dusty torus, which is exposed to the central ionizing source, may produce IELs through photo-ionization processes, while also obscure BELs as a natural coronagraph. Such a coronagraph could be found in a large number of partially obscured quasars and be a useful tool to study IELRs.
We performed VLBA observations of the Broad Absorption Line Quasar FIRST,J155633.8+351758, the first radio loud BALQSO. Our observations at 15.3 GHz partially resolved a secondary component at positional angle (PA) $approx 35^{circ}$. We combine this
determination of the radio jet projection on the sky plane, with the constraint that the jet is viewed within $14.3^{circ}$ of the line of sight (as implied by the high variability brightness temperature) and with the position angle (PA) of the optical/UV continuum polarization in order to study the quasar geometry. Within the context of the standard model, the data indicates a dusty torus (scattering surface) with a symmetry axis tilted relative to the accretion disk normal and a polar broad absorption line outflow aligned with the accretion disk normal. We compare this geometry to that indicated by the higher resolution radio data, brightness temperature and optical/UV continuum polarization PA of a similar high optical polarization BALQSO, Mrk,231. A qualitatively similar geometry is found in these two polar BALQSOs; the continuum polarization is determined primarily by the tilt of the dusty torus.
A method is proposed for measuring the size of the broad emission line region (BLR) in quasars using broadband photometric data. A feasibility study, based on numerical simulations, points to the advantages and pitfalls associated with this approach.
The method is applied to a subset of the Palomar-Green quasar sample for which independent BLR size measurements are available. An agreement is found between the results of the photometric method and the spectroscopic reverberation mapping technique. Implications for the measurement of BLR sizes and black hole masses for numerous quasars in the era of large surveys are discussed.
The Broad Emission Lines (BELs) in spectra of type 1 Active Galactic Nuclei (AGN) can be very complex, indicating a complex Broad Line Region (BLR) geometry. According to the standard unification model one can expect an accretion disk around a superm
assive black hole in all AGN. Therefore, a disk geometry is expected in the BLR. However, a small fraction of BELs show double-peaked profiles which indicate the disk geometry. Here, we discuss a two-component model, assuming an emission from the accretion disk and one additional emission from surrounding region. We compared the modeled BELs with observed ones (mostly broad H$alpha$ and H$beta$ profiles) finding that the model can well describe single-peaked and double-peaked observed broad line profiles.
Optical and near-mid-infrared reverberation mapping data obtained at Universit{a}tssternwarte Bochum in Chile and with the Spitzer Space Telescope allow us to explore the geometry of both the H$alpha$ BLR and the dust torus for the nearby Seyfert 1 g
alaxy WPVS,48. On average, the H$alpha$ variations lag the blue AGN continuum by about 18 days, while the dust emission variations lag by 70 days in the J+K and by 90 days in the L+M bands. The IR echoes are sharp, while the H$alpha$ echo is smeared. This together favours a bowl-shaped toroidal geometry where the dust sublimation radius is defined by a bowl surface, which is virtually aligned with a single iso-delay surface, thus leading to the sharp IR echoes. The BLR clouds, however, are located inside the bowl and spread over a range of iso-delay surfaces, leading to a smeared echo.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
