ترغب بنشر مسار تعليمي؟ اضغط هنا

Ferromagnetic Josephson switching device with high characteristic voltage

59   0   0.0 ( 0 )
 نشر من قبل Igor Vernik
 تاريخ النشر 2012
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

We develop a fast Magnetic Josephson Junction (MJJ) - a superconducting ferromagnetic device for a scalable high-density cryogenic memory compatible in speed and fabrication with energy-efficient Single Flux Quantum (SFQ) circuits. We present experimental results for Superconductor-Insulator-Ferromagnet-Superconductor (SIFS) MJJs with high characteristic voltage IcRn of >700 uV proving their applicability for superconducting circuits. By applying magnetic field pulses, the device can be switched between MJJ logic states. The MJJ IcRn product is only ~30% lower than that of conventional junction co-produced in the same process, allowing for integration of MJJ-based and SIS-based ultra-fast digital SFQ circuits operating at tens of gigahertz.

قيم البحث

اقرأ أيضاً

We present a quantitative study of the current-voltage characteristics (CVC) of diffusive superconductor/ insulator/ ferromagnet/ superconductor (SIFS) tunnel Josephson junctions. In order to obtain the CVC we calculate the density of states (DOS) in the F/S bilayer for arbitrary length of the ferromagnetic layer, using quasiclassical theory. For a ferromagnetic layer thickness larger than the characteristic penetration depth of the superconducting condensate into the F layer, we find an analytical expression which agrees with the DOS obtained from a self-consistent numerical method. We discuss general properties of the DOS and its dependence on the parameters of the ferromagnetic layer. In particular we focus our analysis on the DOS oscillations at the Fermi energy. Using the numerically obtained DOS we calculate the corresponding CVC and discuss their properties. Finally, we use CVC to calculate the macroscopic quantum tunneling (MQT) escape rate for the current biased SIFS junctions by taking into account the dissipative correction due to the quasiparticle tunneling. We show that the influence of the quasiparticle dissipation on the macroscopic quantum dynamics of SIFS junctions is small, which is an advantage of SIFS junctions for superconducting qubits applications.
217 - M. Houzet 2008
The Josephson current in a diffusive superconductor/ferromagnet/superconductor junction with precessing magnetization is calculated within the quasiclassical theory of superconductivity. When the junction is phase-biased, a stationary current (withou t a.c. component) can flow through it despite the non-equilibrium condition. A large critical current is predicted due to a dynamically induced long range triplet proximity effect. Such effect could be observed in a conventional hybrid device close to the ferromagnetic resonance.
The dependence of the critical current density j_c on the ferromagnetic interlayer thickness d_F was determined for Nb/Al_2O_3/Cu/Ni/Nb Josephson tunnel junctions with ferromagnetic Ni interlayer from very thin film thicknesses (sim 1 nm) upwards and classified into F-layer thickness regimes showing a dead magnetic layer, exchange, exchange + anisotropy and total suppression of j_c. The Josephson coupling changes from 0 to pi as function of d_F, and -very close to the crossover thickness- as function of temperature. The strong suppression of the supercurrent in comparison to non-magnetic Nb/Al_2O_3/Cu/Nb junctions indicated that the insertion of a F-layer leads to additional interface scattering. The transport inside the dead magnetic layer was in dirty limit. For the magnetically active regime fitting with both the clean and the dirty limit theory were carried out, indicating dirty limit condition, too. The results were discussed in the framework of literature
We fabricated high quality Nb/Al_2O_3/Ni_{0.6}Cu_{0.4}/Nb superconductor-insulator-ferromagnet-superconductor Josephson tunnel junctions. Using a ferromagnetic layer with a step-like thickness, we obtain a 0-pi junction, with equal lengths and critic al currents of 0 and pi parts. The ground state of our 330 microns (1.3 lambda_J) long junction corresponds to a spontaneous vortex of supercurrent pinned at the 0-pi step and carrying ~6.7% of the magnetic flux quantum Phi_0. The dependence of the critical current on the applied magnetic field shows a clear minimum in the vicinity of zero field.
We present a study on low-$T_c$ superconductor-insulator-ferromagnet-superconductor (SIFS) Josephson junctions. SIFS junctions have gained considerable interest in recent years because they show a number of interesting properties for future classical and quantum computing devices. We optimized the fabrication process of these junctions to achieve a homogeneous current transport, ending up with high-quality samples. Depending on the thickness of the ferromagnetic layer and on temperature, the SIFS junctions are in the ground state with a phase drop either 0 or $pi$. By using a ferromagnetic layer with variable step-like thickness along the junction, we obtained a so-called 0-$pi$ Josephson junction, in which 0 and $pi$ ground states compete with each other. At a certain temperature the 0 and $pi$ parts of the junction are perfectly symmetric, i.e. the absolute critical current densities are equal. In this case the degenerate ground state corresponds to a vortex of supercurrent circulating clock- or counterclockwise and creating a magnetic flux which carries a fraction of the magnetic flux quantum $Phi_0$.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا