ترغب بنشر مسار تعليمي؟ اضغط هنا

Probing charge scattering mechanisms in suspended graphene by varying its dielectric environment

231   0   0.0 ( 0 )
 نشر من قبل A.K.M. Newaz
 تاريخ النشر 2012
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

Graphene with high carrier mobility mu is required both for graphene-based electronic devices and for the investigation of the fundamental properties of graphenes Dirac fermions. It is largely accepted that the mobility-limiting factor in graphene is the Coulomb scattering off of charged impurities that reside either on graphene or in the underlying substrate. This is true both for traditional graphene devices on SiO2 substrates and possibly for the recently reported high-mobility suspended and supported devices. An attractive approach to reduce such scattering is to place graphene in an environment with high static dielectric constant kappa that would effectively screen the electric field due to the impurities. However, experiments so far report only a modest effect of high-kappa environment on mobility. Here, we investigate the effect of the dielectric environment of graphene by studying electrical transport in multi-terminal graphene devices that are suspended in liquids with kappa ranging from 1.9 to 33. For non-polar liquids (kappa <5) we observe a rapid increase of mu with kappa and report a record room-temperature mobility as large as ~60,000 cm2/Vs for graphene devices in anisole (kappa=4.3), while in polar liquids (kappa >18) we observe a drastic drop in mobility. We demonstrate that non-polar liquids enhance mobility by screening charged impurities adsorbed on graphene, while charged ions in polar liquids cause the observed mobility suppression. Furthermore, using molecular dynamics simulation we establish that scattering by out-of-plane flexural phonons, a dominant scattering mechanism in suspended graphene in vacuum at room temperature, is suppressed by the presence of liquids. We expect that our findings may provide avenues to control and reduce carrier scattering in future graphene-based electronic devices.



قيم البحث

اقرأ أيضاً

We report measurements of the cyclotron mass in graphene for carrier concentrations n varying over three orders of magnitude. In contrast to the single-particle picture, the real spectrum of graphene is profoundly nonlinear so that the Fermi velocity describing the spectral slope reaches ~3x10^6 m/s at n <10^10 cm^-2, three times the value commonly used for graphene. The observed changes are attributed to electron-electron interaction that renormalizes the Dirac spectrum because of weak screening. Our experiments also put an upper limit of ~0.1 meV on the possible gap in graphene.
It is widely assumed that the dominant source of scattering in graphene is charged impurities in a substrate. We have tested this conjecture by studying graphene placed on various substrates and in high-k media. Unexpectedly, we have found no signifi cant changes in carrier mobility either for different substrates or by using glycerol, ethanol and water as a top dielectric layer. This suggests that Coulomb impurities are not the scattering mechanism that limits the mean free path currently attainable for graphene on a substrate.
Using the semiclassical quantum Boltzmann equation (QBE), we numerically calculate the DC transport properties of bilayer graphene near charge neutrality. We find, in contrast to prior discussions, that phonon scattering is crucial even at temperatur es below 40K. Nonetheless, electron-electron scattering still dominates over phonon collisions allowing a hydrodynamic approach. We introduce a simple two-fluid hydrodynamic model of electrons and holes interacting via Coulomb drag and compare our results to the full QBE calculation. We show that the two-fluid model produces quantitatively accurate results for conductivity, thermopower, and thermal conductivity.
Devices made from two-dimensional (2D) materials such as graphene or transition metal dichalcogenides possess interesting electronic properties that can become accessible to experimental probes when the samples are protected from deleterious environm ental effects by encapsulating them between hexagonal boron nitride (hBN) layers. While the encapsulated flakes can be detected through post-processing of optical images or confocal Raman mapping, these techniques lack the sub-micrometer scale resolution to identify tears, structural defects or impurities, which is crucial for the fabrication of high-quality devices. Here we demonstrate a simple method to visualize such buried flakes with sub-micrometer resolution, by combining Kelvin force probe microscopy (KPFM) with electrostatic force microscopy (EFM). KPFM, which measures surface potential fluctuations, is extremely effective in spotting charged contaminants within and on top of the heterostructure, making it possible to distinguish contaminated regions in the buried flake. When applying a tip bias larger than the surface potential fluctuations, EFM becomes extremely efficient in highlighting encapsulated flakes and their sub-micron structural defects. We show that these imaging modes, which are standard extensions of atomic force microscopy (AFM), are perfectly suited for locating encapsulated conductors, for visualizing nanometer scale defects and bubbles, and for characterizing their local charge environment.
Recent experiments have shown surprisingly large thermal time constants in suspended graphene ranging from 10 to 100 ns in drums with a diameter ranging from 2 to 7 microns. The large time constants and their scaling with diameter points towards a th ermal resistance at the edge of the drum. However, an explanation of the microscopic origin of this resistance is lacking. Here, we show how phonon scattering at a kink in the graphene, e.g. formed by sidewall adhesion at the edge of the suspended membrane, can cause a large thermal time constant. This kink strongly limits the fraction of flexural phonons that cross the suspended graphene edge, which causes a thermal interface resistance at its boundary. Our model predicts thermal time constants that are of the same order of magnitude as experimental data, and shows a similar dependence on the circumference. Furthermore, the model predicts the relative in-plane and out-of-plane phonon contributions to graphenes thermal expansion force, in agreement with experiments. We thus show, that in contrast to conventional thermal (Kapitza) resistance which occurs between two different materials, in 2D materials another type of thermal interface resistance can be geometrically induced in a single material.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا