اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدRadio Astronomical Image Deconvolution Using Prolate Spheroidal Wave Functions
109
0
0.0
(
0
)
تأليف
Sarod Yatawatta
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
In order to produce high dynamic range images in radio interferometry, bright extended sources need to be removed with minimal error. However, this is not a trivial task because the Fourier plane is sampled only at a finite number of points. The ensuing deconvolution problem has been solved in many ways, mainly by algorithms based on CLEAN. However, such algorithms that use image pixels as basis functions have inherent limitations and by using an orthonormal basis that span the whole image, we can overcome them. The construction of such an orthonormal basis involves fine tuning of many free parameters that define the basis functions. The optimal basis for a given problem (or a given extended source) is not guaranteed. In this paper, we discuss the use of generalized prolate spheroidal wave functions as a basis. Given the geometry (or the region of interest) of an extended source and the sampling points on the visibility plane, we can construct the optimal basis to model the source. Not only does this gives us the minimum number of basis functions required but also the artifacts outside the region of interest are minimized.
قيم البحث
اقرأ أيضاً
The discrete prolate spheroidal sequences (DPSSs) are a set of orthonormal sequences in $ell_2(mathbb{Z})$ which are strictly bandlimited to a frequency band $[-W,W]$ and maximally concentrated in a time interval ${0,ldots,N-1}$. The timelimited DPSS
s (sometimes referred to as the Slepian basis) are an orthonormal set of vectors in $mathbb{C}^N$ whose discrete time Fourier transform (DTFT) is maximally concentrated in a frequency band $[-W,W]$. Due to these properties, DPSSs have a wide variety of signal processing applications. The DPSSs are the eigensequences of a timelimit-then-bandlimit operator and the Slepian basis vectors are the eigenvectors of the so-called prolate matrix. The eigenvalues in both cases are the same, and they exhibit a particular clustering behavior -- slightly fewer than $2NW$ eigenvalues are very close to $1$, slightly fewer than $N-2NW$ eigenvalues are very close to $0$, and very few eigenvalues are not near $1$ or $0$. This eigenvalue behavior is critical in many of the applications in which DPSSs are used. There are many asymptotic characterizations of the number of eigenvalues not near $0$ or $1$. In contrast, there are very few non-asymptotic results, and these dont fully characterize the clustering behavior of the DPSS eigenvalues. In this work, we establish two novel non-asymptotic bounds on the number of DPSS eigenvalues between $epsilon$ and $1-epsilon$. Also, we obtain bounds detailing how close the first $approx 2NW$ eigenvalues are to $1$ and how close the last $approx N-2NW$ eigenvalues are to $0$. Furthermore, we extend these results to the eigenvalues of the prolate spheroidal wave functions (PSWFs), which are the continuous-time version of the DPSSs. Finally, we present numerical experiments demonstrating the quality of our non-asymptotic bounds on the number of DPSS eigenvalues between $epsilon$ and $1-epsilon$.
Prolate spheroidal wave functions provide a natural and effective tool for computing with bandlimited functions defined on an interval. As demonstrated by Slepian et al., the so called generalized prolate spheroidal functions (GPSFs) extend this appa
ratus to higher dimensions. While the analytical and numerical apparatus in one dimension is fairly complete, the situation in higher dimensions is less satisfactory. This report attempts to improve the situation by providing analytical and numerical tools for GPSFs, including the efficient evaluation of eigenvalues, the construction of quadratures, interpolation formulae, etc. Our results are illustrated with several numerical examples.
Deconvolution is essential for radio interferometric imaging to produce scientific quality data because of finite sampling in the Fourier plane. Most deconvolution algorithms are based on CLEAN which uses a grid of image pixels, or clean components.
A critical matter in this process is the selection of pixel size for optimal results in deconvolution. As a rule of thumb, the pixel size is chosen smaller than the resolution dictated by the interferometer. For images consisting of unresolved (or point like) sources, this approach yields optimal results. However, for sources that are not point like, in particular for partially resolved sources, the selection of right pixel size is still an open issue. In this paper, we investigate the limitations of pixelization in deconvolving extended sources. In particular, we pursue the usage of orthonormal basis functions to model extended sources yielding better results than by using clean components.
Radio interferometers suffer from the problem of missing information in their data, due to the gaps between the antennas. This results in artifacts, such as bright rings around sources, in the images obtained. Multiple deconvolution algorithms have b
een proposed to solve this problem and produce cleaner radio images. However, these algorithms are unable to correctly estimate uncertainties in derived scientific parameters or to always include the effects of instrumental errors. We propose an alternative technique called Bayesian Inference for Radio Observations (BIRO) which uses a Bayesian statistical framework to determine the scientific parameters and instrumental errors simultaneously directly from the raw data, without making an image. We use a simple simulation of Westerbork Synthesis Radio Telescope data including pointing errors and beam parameters as instrumental effects, to demonstrate the use of BIRO.
An image restoration approach based on a Bayesian maximum entropy method (MEM) has been applied to a radiological image deconvolution problem, that of reduction of geometric blurring in magnification mammography. The aim of the work is to demonstrate
an improvement in image spatial resolution in realistic noisy radiological images with no associated penalty in terms of reduction in the signal-to-noise ratio perceived by the observer. Images of the TORMAM mammographic image quality phantom were recorded using the standard magnification settings of 1.8 magnification/fine focus and also at 1.8 magnification/broad focus and 3.0 magnification/fine focus; the latter two arrangements would normally give rise to unacceptable geometric blurring. Measured point-spread functions were used in conjunction with the MEM image processing to de-blur these images. The results are presented as comparative images of phantom test features and as observer scores for the raw and processed images. Visualization of high resolution features and the total image scores for the test phantom were improved by the application of the MEM processing. It is argued that this successful demonstration of image de-blurring in noisy radiological images offers the possibility of weakening the link between focal spot size and geometric blurring in radiology, thus opening up new approaches to system optimization.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
