اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدContraction and expansion effects on the substitution-defect properties of thirteen alloying elements in bcc Fe
228
0
0.0
(
0
)
تأليف
Wei Liu
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Proposed as blanket structural materials for fusion power reactors, reduced activation ferritic/martensitic (RAFM) steel undergoes volume expanding and contracting in a cyclic mode under service environment. Particularly, being subjected to significant fluxes of fusion neutrons RAFM steel suffers considerable local volume variations in the radiation damage involved regions. It is necessary to study the structure properties of the alloying elements in contraction and expansion states. In this paper we studied local substitution structures of thirteen alloying elements Al, Co, Cr, Cu, Mn, Mo, Nb, Ni, Si, Ta, Ti, V, and W in bcc Fe and calculated their substitutional energies in the volume variation range from -1.0% to 1.0%. From the structure relaxation results of the first five neighbor shells around the substitutional atom we find the relaxation in each neighbor shell keeps approximately uniform within the volume variation from -1.0% to 1.0% except those of Mn and the relaxation of the fifth neighbor shell is stronger than that of the third and forth, indicating that the lattice distortion due to the substitution atom is easier to spread in <111> direction than in other direction. The relaxation pattern and intensity are related to the size and electron structure of the substitutional atom. For some alloying elements, such as Mo, Nb, Ni, Ta, Ti and W, the substitutional energy decreases noticeably when the volume increases. Further analysis show that the substitutional energy comprises the energy variation originated from local structure relaxation and the chemical potential difference of the substitutional atom between its elemental crystalline state and the solid solution phase in bcc Fe. We think the approximately uniform relaxation of each neighbor shell around a substitutional atom give rise to a linear decrease in the substitutional energy with the increasing volume.
قيم البحث
اقرأ أيضاً
We report on detailed structural, electronic and magnetic studies of GdMn$_{1-x}$Cr$_x$O$_3$ for Cr doping levels 0 $le$ $x$ $le$ 1. In the solid solutions, the Jahn-Teller distortion associated with Mn$^{3+}$ ions gives rise to major changes in the
${bc}$-plane sub-lattice and also the effective orbital ordering in the ${ab}$-plane, which persist up to the compositions $x$ $sim$ 0.35. These distinct features in the lattice and orbital degrees of freedom are also correlated with $bc$-plane anisotropy of the local Gd environment. A gradual evolution of electronic states with doping is also clearly seen in O $K$-edge x-ray absorption spectra. Evidence of magnetization reversal in field-cooled-cooling mode for $x$ $ge$ 0.35 coinciding the Jahn-Teller crossover, suggests a close correlation between magnetic interaction and structural distortion. These observations indicate a strong entanglement between lattice, spin, electronic and orbital degrees of freedom. The nonmonotonic variation of remnant magnetization can be explained by doping induced modification of magnetic interactions. Density functional theory calculations are consistent with a layer-by-layer type doping with ferromagnetic (antiferomagnetic) coupling between Mn (Cr) ions for intermediate compound ($x$ = 0.5), which is distinct from that observed for the end members GMnO$_3$ and GdCrO$_3$.
The present study investigates the partial substitutions of Mn and Cu for Fe in the TiFe-system to gain better understanding of the role of elemental substitution on its hydrogen storage properties. The TiFe0.88-xMn0.02Cux (x = 0, 0.02, 0.04) composi
tions were studied. From X-Ray Diffraction (XRD) and Electron Probe Micro-Analysis (EPMA), it was found that all alloys are multi-phase, with TiFe as a major phase, together with b{eta}-Ti and Ti4Fe2O-type as secondary precipitates, of all them containing also Mn and Cu. Increasing the Cu content augments the secondary phase amounts. Low quantity of secondary phases helps the activation of the main TiFe phase for the first hydrogen absorption, but on increasing their amounts, harsher activation occurs. Both Mn and Cu substitutions increase the cell parameter of TiFe, thus decreasing the first plateau pressure. However, Cu substitution rises the second plateau pressure revealing the predominancy of electronic effects associated to this substitution. All samples have fast kinetics and high hydrogen capacity making these substituted compounds promising for large scale stationary applications.
The long-term safety of water-based nuclear reactors relies in part on the reliability of zirconium-based nuclear fuel. Yet the progressive ingress of hydrogen during service makes zirconium alloys subject to delayed hydride cracking. Here, we use a
combination of electron back-scattered diffraction and atom probe tomography to investigate specific microstructural features from the as-received sample and in the blocky-alpha microstructure, before and after electrochemical charging with hydrogen or deuterium followed by a low temperature heat treatment at 400C for 5 hours followed by furnace cooling at a rate of 0. 5C per min. Specimens for atom probe were prepared at cryogenic temperature to avoid the formation of spurious hydrides. We report on the compositional evolution of grains and grain boundaries over the course of the samples thermal history, as well as the ways the growth of the hydrides modifies locally the composition and the structure of the alloy. We observe a significant amount of deuterium left in the matrix, even after the slow cooling and growth of the hydrides. Stacking faults form ahead of the growth front and Sn segregates at the hydride-matrix interface and on these faults. We propose that this segregation may facilitate further growth of the hydride. Our systematic investigation enables us discuss how the solute distribution affects the evolution of the alloys properties during its service lifetime.
Molecular dynamics simulations have been performed to understand the influence of temperature on the tensile deformation and fracture behavior of $<$111$>$ BCC Fe nanowires. The simulations have been carried out at different temperatures in the range
10-1000 K employing a constant strain rate of $1times$ $10^8$ $s^{-1}$. The results indicate that at low temperatures (10-375 K), the nanowires yield through the nucleation of a sharp crack and fails in brittle manner. On the other hand, nucleation of multiple 1/2$<$111$>$ dislocations at yielding followed by significant plastic deformation leading to ductile failure has been observed at high temperatures in the range 450-1000 K. At the intermediate temperature of 400 K, the nanowire yields through nucleation of crack associated with many mobile 1/2$<$111$>$ and immobile $<$100$>$ dislocations at the crack tip and fails in ductile manner. The ductile-brittle transition observed in $<$111$>$ BCC Fe nanowires is appropriately reflected in the stress-strain behavior and plastic strain at failure. The ductile-brittle transition increases with increasing nanowire size. The change in fracture behavior has been discussed in terms of the relative variations in yield and fracture stresses and change in slip behavior with respect to temperature. Further, the dislocation multiplication mechanism assisted by the kink nucleation from the nanowire surface observed at high temperatures has been presented.
Moessbauer transmission spectra for the 14.41-keV resonant line in 57Fe have been collected at room temperature by using 57Co(Rh) commercial source and alpha-Fe strain-free single crystal as an absorber. The absorber was magnetized to saturation in t
he absorber plane perpendicular to the gamma-ray beam axis applying small external magnetic field. Spectra were collected for various orientations of the magnetizing field, the latter lying close to the [110] crystal plane. A positive electric quadrupole coupling constant was found practically independent on the field orientation. One obtains the following value Vzz=+1.61(4)x10^19 V/m^2 for the (average) principal component of the electric field gradient (EFG) tensor under assumption that the EFG tensor is axially symmetric and the principal axis is aligned with the magnetic hyperfine field acting on the 57Fe nucleus. The nuclear spectroscopic electric quadrupole moment for the first excited state of the 57Fe nucleus was adopted as +0.17 b. Similar measurement was performed at room temperature using as-rolled polycrystalline alpha-Fe foil of high purity in the zero external field. Corresponding value for the principal component of the EFG was found as Vzz=+1.92(4)x10^19 V/m^2. Hence, it seems that the origin of the EFG is primarily due to the local (atomic) electronic wave function distortion caused by the spin-orbit interaction between effective electronic spin S and incompletely quenched electronic angular momentum L. It seems as well that the lowest order term proportional to the product L.LAMBDA.S dominates, as no direction dependence of the EFG principal component is seen. The lowest order term is isotropic for a cubic symmetry as one has LAMBDA=lambda.1 for cubic systems with the symbol 1 denoting unit operator and lambda being the coupling parameter.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
