اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدUncovering the Dominant Scatterer in Graphene Sheets on SiO2
381
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We have measured the impact of atomic hydrogen adsorption on the electronic transport properties of graphene sheets as a function of hydrogen coverage and initial, pre-hydrogenation field-effect mobility. Our results are compatible with hydrogen adsorbates inducing intervalley mixing by exerting a short-range scattering potential. The saturation coverages for different devices are found to be proportional to their initial mobility, indicating that the number of native scatterers is proportional to the saturation coverage of hydrogen. By extrapolating this proportionality, we show that the field-effect mobility can reach $1.5 times 10^4$ cm$^2$/V sec in the absence of the hydrogen-adsorbing sites. This affinity to hydrogen is the signature of the most dominant type of native scatterers in graphene-based field-effect transistors on SiO$_2$.
قيم البحث
اقرأ أيضاً
A large variability of carrier mobility of graphene-based field effect transistors hampers graphene science and technology. We determine the scattering strength of the dominant scatterer responsible for the variability of graphene-based transistors o
n silicon oxide. The strength of the scatterer is found to be more consistent with charged impurities than with resonant impurities.
We have carried out scanning tunneling spectroscopy measurements on exfoliated monolayer graphene on SiO$_2$ to probe the correlation between its electronic and structural properties. Maps of the local density of states are characterized by electron
and hole puddles that arise due to long range intravalley scattering from intrinsic ripples in graphene and random charged impurities. At low energy, we observe short range intervalley scattering which we attribute to lattice defects. Our results demonstrate that the electronic properties of graphene are influenced by intrinsic ripples, defects and the underlying SiO$_2$ substrate.
The amount of rippling in graphene sheets is related to the interactions with the substrate or with the suspending structure. Here, we report on an irreversibility in the response to forces that act on suspended graphene sheets. This may explain why
one always observes a ripple structure on suspended graphene. We show that a compression-relaxation mechanism produces static ripples on graphene sheets and determine a peculiar temperature $T_c$, such that for $T<T_c$ the free-energy of the rippled graphene is smaller than that of roughened graphene. We also show that $T_c$ depends on the structural parameters and increases with increasing sample size.
We investigate the size scaling of the conductance of surface disordered graphene sheets of width W and length L. Metallic leads are attached to the sample ends across its width. At E ~ 0, the conductance scales with the system size as follows: i) Fo
r constant W/L, it remains constant as size is increased, at a value which depends almost lineally on that ratio; this scaling allows the definition of a conductivity value that results similar to the experimental one. ii) For fixed width, the conductance decreases exponentially with length L, both for ordered and disordered samples. Disorder reduces the exponential decay, leading to a higher conductance. iii) For constant length, conductance increases linearly with width W, a result that is exclusively due to the tails of the states of the metallic wide contact. iv) The average conductance does not show an appreciable dependence on magnetic field. Away from E = 0, the conductance shows the behavior expected in two-dimensional systems with surface disorder, i.e., ballistic transport.
We demonstrate how self-assembled monolayers of aromatic molecules on copper substrates can be converted into high-quality single-layer graphene using low-energy electron irradiation and subsequent annealing. We characterize this two-dimensional soli
d state transformation on the atomic scale and study the physical and chemical properties of the formed graphene sheets by complementary microscopic and spectroscopic techniques and by electrical transport measurements. As substrates we successfully use Cu(111) single crystals and the technologically relevant polycrystalline copper foils.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
