اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدA Low-Complexity Joint Detection-Decoding Algorithm for Nonbinary LDPC-Coded Modulation Systems
71
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
In this paper, we present a low-complexity joint detection-decoding algorithm for nonbinary LDPC codedmodulation systems. The algorithm combines hard-decision decoding using the message-passing strategy with the signal detector in an iterative manner. It requires low computational complexity, offers good system performance and has a fast rate of decoding convergence. Compared to the q-ary sum-product algorithm (QSPA), it provides an attractive candidate for practical applications of q-ary LDPC codes.
قيم البحث
اقرأ أيضاً
Non-binary low-density parity-check codes are robust to various channel impairments. However, based on the existing decoding algorithms, the decoder implementations are expensive because of their excessive computational complexity and memory usage. B
ased on the combinatorial optimization, we present an approximation method for the check node processing. The simulation results demonstrate that our scheme has small performance loss over the additive white Gaussian noise channel and independent Rayleigh fading channel. Furthermore, the proposed reduced-complexity realization provides significant savings on hardware, so it yields a good performance-complexity tradeoff and can be efficiently implemented.
Layered decoding is well appreciated in Low-Density Parity-Check (LDPC) decoder implementation since it can achieve effectively high decoding throughput with low computation complexity. This work, for the first time, addresses low complexity column-l
ayered decoding schemes and VLSI architectures for multi-Gb/s applications. At first, the Min-Sum algorithm is incorporated into the column-layered decoding. Then algorithmic transformations and judicious approximations are explored to minimize the overall computation complexity. Compared to the original column-layered decoding, the new approach can reduce the computation complexity in check node processing for high-rate LDPC codes by up to 90% while maintaining the fast convergence speed of layered decoding. Furthermore, a relaxed pipelining scheme is presented to enable very high clock speed for VLSI implementation. Equipped with these new techniques, an efficient decoder architecture for quasi-cyclic LDPC codes is developed and implemented with 0.13um CMOS technology. It is shown that a decoding throughput of nearly 4 Gb/s at maximum of 10 iterations can be achieved for a (4096, 3584) LDPC code. Hence, this work has facilitated practical applications of column-layered decoding and particularly made it very attractive in high-speed, high-rate LDPC decoder implementation.
We analyze the achievable information rates (AIRs) for coded modulation schemes with QAM constellations with both bit-wise and symbol-wise decoders, corresponding to the case where a binary code is used in combination with a higher-order modulation u
sing the bit-interleaved coded modulation (BICM) paradigm and to the case where a nonbinary code over a field matched to the constellation size is used, respectively. In particular, we consider hard decision decoding, which is the preferable option for fiber-optic communication systems where decoding complexity is a concern. Recently, Liga emph{et al.} analyzed the AIRs for bit-wise and symbol-wise decoders considering what the authors called emph{hard decision decoder} which, however, exploits emph{soft information} of the transition probabilities of discrete-input discrete-output channel resulting from the hard detection. As such, the complexity of the decoder is essentially the same as the complexity of a soft decision decoder. In this paper, we analyze instead the AIRs for the standard hard decision decoder, commonly used in practice, where the decoding is based on the Hamming distance metric. We show that if standard hard decision decoding is used, bit-wise decoders yield significantly higher AIRs than symbol-wise decoders. As a result, contrary to the conclusion by Liga emph{et al.}, binary decoders together with the BICM paradigm are preferable for spectrally-efficient fiber-optic systems. We also design binary and nonbinary staircase codes and show that, in agreement with the AIRs, binary codes yield better performance.
This paper investigates the design and performance of delayed bit-interleaved coded modulation (DBICM) with low-density parity-check (LDPC) codes. For Gray labeled square $M$-ary quadrature amplitude modulation (QAM) constellations, we investigate th
e optimal delay scheme with the largest spectrum efficiency of DBICM for a fixed maximum number of delayed time slots and a given signal-to-noise ratio. When analyzing the capacity of DBICM, we find two important properties: the capacity improvement due to delayed coded bits being mapped to the real and imaginary parts of the transmitted symbols are independent of each other; a pair of delay schemes with delayed coded bits having identical bit-channel capacity lead to equivalent DBICM capacity. Using these two properties, we efficiently optimize the delay scheme for any uniform Gray-QAM systems. Furthermore, these two properties enable efficient LDPC code designs regarding unequal error protection via bit-channel type classifications. Moreover, we use protograph-based extrinsic information transfer charts to jointly optimize degree distributions and channel assignments of LDPC codes and propose a constrained progressive edge growth like algorithm to jointly construct LDPC codes and bit-interleavers for DBICM, taking distinctive bit-channels capacity into account. Simulation results demonstrate that the designed LDPC coded DBICM systems significantly outperform LDPC coded BICM systems.
A framework for linear-programming (LP) decoding of nonbinary linear codes over rings is developed. This framework facilitates linear-programming based reception for coded modulation systems which use direct modulation mapping of coded symbols. It is
proved that the resulting LP decoder has the maximum-likelihood certificate property. It is also shown that the decoder output is the lowest cost pseudocodeword. Equivalence between pseudocodewords of the linear program and pseudocodewords of graph covers is proved. It is also proved that if the modulator-channel combination satisfies a particular symmetry condition, the codeword error rate performance is independent of the transmitted codeword. Two alternative polytopes for use with linear-programming decoding are studied, and it is shown that for many classes of codes these polytopes yield a complexity advantage for decoding. These polytope representations lead to polynomial-time decoders for a wide variety of classical nonbinary linear codes. LP decoding performance is illustrated for the [11,6] ternary Golay code with ternary PSK modulation over AWGN, and in this case it is shown that the performance of the LP decoder is comparable to codeword-error-rate-optimum hard-decision based decoding. LP decoding is also simulated for medium-length ternary and quaternary LDPC codes with corresponding PSK modulations over AWGN.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
