اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدTime Evolution of the 3-D Accretion Flows: Effects of the Adiabatic Index and Outer Boundary Condition
56
0
0.0
(
0
)
تأليف
Agnieszka Janiuk
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We study a slightly rotating accretion flow onto a black hole, using the fully three dimensional (3-D)numerical simulations. We consider hydrodynamics of an inviscid flow, assuming a spherically symmetric density distribution at the outer boundary and a small, latitude-dependent angular momentum. We investigate the role of the adiabatic index and gas temperature, and the flow behaviour due to non-axisymmetric effects. Our 3-D simulations confirm axisymmetric results: the material that has too much angular momentum to be accreted forms a thick torus near the equator and the mass accretion rate is lower than the Bondi rate. In our previous study of the 3-D accretion flows, for gamma=5/3, we found that the inner torus precessed, even for axisymmetric conditions at large radii. The present study shows that the inner torus precesses also for other values of the adiabatic index: gamma=4/3, 1.2 and 1.01. However, the time for the precession to set increases with decreasing gamma. In particular, for gamma=1.01 we find that depending on the outer boundary conditions, the torus may shrink substantially due to the strong inflow of the non-rotating matter and the precession will have insufficient time to develop. On the other hand, if the torus is supplied by the continuous inflow of the rotating material from the outer radii, its inner parts will eventually tilt and precess, as it was for the larger gammas.
قيم البحث
اقرأ أيضاً
We analyze two 3D general-relativistic magnetohydrodynamic accretion simulations in the context of how they would manifest in Event Horizon Telescope (EHT) observations of supermassive black holes. The two simulations differ only in whether the initi
al angular momentum of the plasma is aligned with the rapid (a = 0.9) spin of the black hole. Both have low net magnetic flux. Ray tracing is employed to generate resolved images of the synchrotron emission. When using parameters appropriate for Sgr A* and assuming a viewing angle aligned with the black hole spin, we find the most prominent difference is that the central shadow in the image is noticeably eccentric in tilted models, with the ring of emission relatively unchanged. Applying this procedure to M87 with a viewing angle based on the large-scale jet, we find that adding tilt increases the angular size of the ring for fixed black hole mass and distance, while at the same time increasing the number of bright spots in the image. Our findings illustrate observable features that can distinguish tilted from aligned flows. They also show that tilted models can be viable for M87, and that not accounting for tilt can bias inferences of physical parameters. Future modeling of horizon-scale observations should account for potential angular momentum misalignment, which is likely generic at the low accretion rates appropriate for EHT targets.
We solved the set of two-dimensional magnetohydrodynamic (MHD) equations for optically thin black hole accretion flows incorporating toroidal component of magnetic field. Following global and local MHD simulations of black hole accretion disks, the m
agnetic field inside the disk is decomposed into a large scale field and a fluctuating field. The effects of the fluctuating magnetic field in transferring the angular momentum and dissipating the energy are described through the usual $ alpha $ description. We solved the MHD equations by assuming steady state and radially self-similar approximation in $ r-theta $ plane of spherical coordinate system. We found that as the amount of magnetic field at the equatorial plane increases, the heating by the viscosity decreases. In addition, the maximum amount of the heating by the viscous dissipation is produced at the mid-plane of the disk, while that of the heating by the magnetic field dissipation is produced at the surface of the disk. Our main conclusion is that in terms of the no-outflow solution, thermal equilibrium still exists for the strong magnetic filed at the equatorial plane of the disk.
We have used a model of magnetic accretion to investigate the accretion flows of magnetic cataclysmic variables. Numerical simulations demonstrate that four types of flow are possible: discs, streams, rings and propellers. The fundamental observable
determining the accretion flow, for a given mass ratio, is the spin-to-orbital period ratio of the system. If IPs are accreting at their equilibrium spin rates, then for a mass ratio of 0.5, those with Pspin/Porb < 0.1 will be disc-like, those with 0.1 < Pspin/Porb < 0.6 will be stream-like, and those with Pspin/Porb ~ 0.6 will be ring-like. The spin to orbital period ratio at which the systems transition between these flow types increases as the mass ratio of the stellar components decreases. For the first time we present evolutionary tracks of mCVs which allow investigation of how their accretion flow changes with time. As systems evolve to shorter orbital periods and smaller mass ratios, in order to maintain spin equilibrium, their spin-to-orbital period ratio will generally increase. As a result, the relative occurrence of ring-like flows will increase, and the occurrence of disc-like flows will decrease, at short orbital periods. The growing number of systems observed at high spin-to-orbital period ratios with orbital periods below 2h, and the observational evidence for ring-like accretion in EX Hya, are fully consistent with this picture.
We use Smoothed Particle Hydrodynamics to study viscous accretion flows around a weakly magnetic neutron star. We show the formation of multiple ``boundary layers in presence of both cooling and viscosity. We find that with the introduction of a smal
l viscosity in a sub-Keplerian flow, much like the wind accretion in HMXBs such as Cir X-1, only a single Normal Boundary Layer (NBOL) forms to adjust the rotational velocity component. With the increase of viscosity, the region extends radially and beyond some critical value, a RAdiative KEplerian Disk/layer (RAKED) forms between the sub-Keplerian flow and the NBOL. When viscosity is increased further only NBOL and RAKED remain. In all such cases, the CENtrifugal pressure dominated BOundary Layer (CENBOL) is formed, away from the star, as in the case of black holes. This is the first self-consistent study where such a transition from sub-Keplerian flows has been reported for neutron stars. We also identify the connection between accretion and ejection of matter, following the Two-Component Advective Flow for black holes, for neutron stars. The results are crucial in the understanding of the formation of disks, boundary layers and outflows in wind dominated neutron star systems.
We study the effects of accretion environment (gas density, temperature and angular momentum) at large radii ($sim 10$pc) on luminosity of hot accretion flows. The radiative feedback effects from the accretion flow on the accretion environment are al
so self-consistently taken into account. We find that the slowly rotating flows at large radii can significantly deviate from Bondi accretion when radiation heating and cooling are considered. We further find that when the temperature of environment gas is low (e.g. $T=2times 10^7$K), the luminosity of hot accretion flows is high. When the temperature of gas is high (e.g. $Tgeq4times 10^7$K), the luminosity of hot accretion flow significantly deceases. The environment gas density can also significantly influence the luminosity of accretion flows. When density is higher than $sim 4times 10^{-22}text{g} text{cm}^{-3}$ and temperature is lower than $2times 10^7$K, hot accretion flow with luminosity lower than $2%L_{text{Edd}}$ is not present. Therefore, the pc-scale environment density and temperature are two important parameters to determine the luminosity. The results are also useful for the sub-grid models adopted by the cosmological simulations.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
