ترغب بنشر مسار تعليمي؟ اضغط هنا

Low-column density HVC and IVC gas in the halo of the Milky Way

264   0   0.0 ( 0 )
 نشر من قبل Nadya Ben Bekhti
 تاريخ النشر 2009
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

Recent studies of the circumgalactic gaseous environment of the Milky Way have concentrated on the distribution, chemical composition, and physical properties of the most massive neutral gas clouds and the highly-ionized halo absorbers. Relatively little effort has been put so far in exploring the circumgalactic neutral and weakly ionized metal absorbers at low HI column densities. With our work we systematically study the distribution and physical properties of neutral and ionised low-column density gas in the halo of the Milky Way. We combine CaII and NaI absorption line measurements with HI 21-cm emission line data. For some of the sight lines high-resolution radio synthesis observations were performed allowing us to study small-scale structures that cannot be resolved with single dish telescopes. In total 177 lines of sight were observed, providing a large absorption-selected data sample for the analysis of IVC and HVC gas in the circumgalactic environment of the Milky Way. The study allows us to compare the observed absorption column density distribution (CDD) of gas in the Milky Way halo with the overall CDD of intervening absorbers towards quasars. The sensitive absorption line analysis enables us to identify the neutral and ionised gaseous structures at low column densities and small angular extent that possibly remain unseen in large 21-cm all-sky surveys. If this gas cover a significant portion of the sky, it possibly has a large influence on the evolution of the Milky Way.



قيم البحث

اقرأ أيضاً

We perform a systematic study of physical properties and distribution of neutral and ionised gas in the halo of the Milky Way (MW). Beside the large neutral intermediate- and high-velocity cloud (IVC, HVC) complexes there exists a population of partl y ionised gaseous structures with low-column densities that have a substantial area filling factor. The origin and nature of these structures are still under debate. We analyse the physical parameters of the MW halo gas and the relation to quasar (QSO) metal-absorption line systems at low and high redshifts. For this purpose we combine new HI 21-cm data from the EBHIS and GASS surveys with optical quasar absorption line data to study the filling factor and distribution of these gaseous clouds in the halo at HI densities below 10^19 1/cm^2. This study is important to understand the evolution of the MW in particular and the gas accretion mechanisms of galaxies in general.
We aim at analysing systematically the distribution and physical properties of neutral and mildly ionised gas in the Milky Way halo, based on a large absorption-selected data set. Multi-wavelength studies were performed combining optical absorption l ine data of CaII and NaI with follow-up HI 21-cm emission line observations along 408 sight lines towards low- and high-redshift QSOs. We made use of archival optical spectra obtained with UVES/VLT. HI data were extracted from the Effelsberg-Bonn HI survey and the Galactic All-Sky survey. For selected sight lines we obtained deeper follow-up observations using the Effelsberg 100-m telescope. CaII (NaI) halo absorbers at intermediate and high radial velocities are present in 40-55% (20-35%) of the sightlines, depending on the column density threshold chosen. Many halo absorbers show multi-component absorption lines, indicating the presence of sub-structure. In 65% of the cases, absorption is associated with HI 21-cm emission. The CaII (NaI) column density distribution function follows a power-law with a slope of -2.2 (-1.4). Our absorption-selected survey confirms our previous results that the Milky Way halo is filled with a large number of neutral gas structures whose high column density tail represents the population of common HI high- and intermediate-velocity clouds seen in 21-cm observations. We find that CaII/NaI column density ratios in the halo absorbers are typically smaller than those in the Milky Way disc, in the gas in the Magellanic Clouds, and in damped Lyman-alpha systems. The small ratios (prominent in particular in high-velocity components) indicate a lower level of Ca depletion onto dust grains in Milky Way halo absorbers compared to gas in discs and inner regions of galaxies.
83 - Hartmut Bluhm 2000
In front of the LMC molecular hydrogen is found in absorption near 0 km/s, being local disk gas, near +60 km/s in an intermediate velocity cloud, and near +120 km/s, in a high velocity halo cloud. The nature of the gas is discussed based on four ORFE US far UV spectra of LMC stars and including data from the ground and from the IUE satellite. The local gas is cool and, given a span of sight lines of only 2.5 deg, rather fluffy. The fractional abundance of H_2 varies from log(f)=-5.4 to -3.3. Metal depletions (up to -1.7 dex for Fe) are typical for galactic disk gas. In the IV and HV gas an apparent underabundance of neutral oxygen points to an ionization level of the gas of about 90%. H_2 is detected in IV and HV gas toward HD 269546. In the IV gas we find an H_2 column density of log(N)simeq15.6. The H_2 excitation indicates that the line of sight samples a cloud at a temperature below 150 K. Column densities are too small to detect the higher UV pumped excitation levels. The high velocity H_2 (log(N)simeq15.6) is highly excited and probably exposed to a strong radiation field. Its excitation temperature exceeds 1000 K. Due to the radial velocity difference between the halo gas and the Milky Way disk, the unattenuated disk radiation is available for H_2 excitation in the halo. We do not find evidence for an intergalactic origin of this gas; a galactic as well as a Magellanic Cloud origin is possible.
99 - G. C. Myeong 2018
We analyse the structure of the local stellar halo of the Milky Way using $sim$ 60000 stars with full phase space coordinates extracted from the SDSS--{it Gaia} catalogue. We display stars in action space as a function of metallicity in a realistic a xisymmetric potential for the Milky Way Galaxy. The metal-rich population is more distended towards high radial action $J_R$ as compared to azimuthal or vertical action, $J_phi$ or $J_z$. It has a mild prograde rotation $(langle v_phi rangle approx 25$ km s$^{-1}$), is radially anisotropic and highly flattened with axis ratio $q approx 0.6 - 0.7$. The metal-poor population is more evenly distributed in all three actions. It has larger prograde rotation $(langle v_phi rangle approx 50$ km s$^{-1}$), a mild radial anisotropy and a roundish morphology ($qapprox 0.9$). We identify two further components of the halo in action space. There is a high energy, retrograde component that is only present in the metal-rich stars. This is suggestive of an origin in a retrograde encounter, possibly the one that created the stripped dwarf galaxy nucleus, $omega$Centauri. Also visible as a distinct entity in action space is a resonant component, which is flattened and prograde. It extends over a range of metallicities down to [Fe/H] $approx -3$. It has a net outward radial velocity $langle v_R rangle approx 12$ km s$^{-1}$ within the Solar circle at $|z| <3.5$ kpc. The existence of resonant stars at such extremely low metallicities has not been seen before.
314 - A. Helmi , M. Irwin , A. Deason 2019
The goal of this survey is to study the formation and evolution of the Milky Way halo to deduce its assembly history and the 3D distribution of mass in the Milky Way. The combination of multi-band photometry, Gaia proper motion and parallax data, and radial velocities and the metallicity and elemental abundances obtained from low-resolution spectra of halo giants with 4MOST, will yield an unprecedented characterisation of the Milky Way halo and its interface with the thick disc. The survey will produce a volume- and magnitude-limited complete sample of giant stars in the halo. It will cover at least 10,000 square degrees of high Galactic latitude, and measure line-of-sight velocities with a precision of 1-2 km/s as well as metallicities to within 0.2 dex.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا