ترغب بنشر مسار تعليمي؟ اضغط هنا

Magnetic and transport properties of n-type Fe-doped In2O3 ferromagnetic thin films

274   0   0.0 ( 0 )
 نشر من قبل Gillian Gehring
 تاريخ النشر 2009
  مجال البحث فيزياء
والبحث باللغة English




اسأل ChatGPT حول البحث

Room temperature ferromagnetism was observed in n-type Fe-doped In2O3 thin films deposited on c-cut sapphire substrates by pulsed laser deposition. Structure, magnetism, composition, and transport studies indicated that Fe occupied the In sites of the In2O3 lattice rather than formed any metallic Fe or other magnetic impurity phases. Magnetic moments of films were proved to be intrinsic and showed to have a strong dependence on the carrier densities which depended on the Fe concentration and its valance state as well as oxygen pressure.



قيم البحث

اقرأ أيضاً

The double perovskite Sr2CrReO6 is an interesting material for spintronics, showing ferrimagnetism up to 635 K with a predicted high spin polarization of about 86%. We fabricated Sr2CrReO6 epitaxial films by pulsed laser deposition on (001)-oriented SrTiO3 substrates. Phase-pure films with optimum crystallographic and magnetic properties were obtained by growing at a substrate temperature of 700 degree C in pure O2 of 6.6x10-4 mbar. The films are c-axis oriented, coherently strained, and show less than 20% anti-site defects. The magnetization curves reveal high saturation magnetization of 0.8 muB per formula unit and high coercivity of 1.1 T, as well as a strong magnetic anisotropy.
82 - D. Han , R. Moalla , I. Fina 2021
The impact of epitaxial strain on the structural, electronic, and thermoelectric properties of p-type transparent Sr-doped LaCrO3 thin films has been investigated. For this purpose, high-quality fully strained La0.75Sr0.25CrO3 (LSCO) epitaxial thin f ilms were grown by molecular beam epitaxy on three different (pseudo)cubic (001)-oriented perovskite oxide substrates: LaAlO3, (LaAlO3)0.3(Sr2AlTaO6)0.7, and DyScO3. The lattice mismatch between the LSCO films and the substrates induces in-plane strain ranging from -2.06% (compressive) to +1.75% (tensile). The electric conductivity can be controlled over 2 orders of magnitude, ranging from 0.5 S/cm (tensile strain) to 35 S/cm (compressive strain). Consistently, the Seebeck coefficient S can be finely tuned by a factor of almost 2 from 127 microV/K (compressive strain) to 208 microV/K (tensile strain). Interestingly, we show that the thermoelectric power factor can consequently be tuned by almost 2 orders of magnitude. The compressive strain yields a remarkable enhancement by a factor of 3 for 2% compressive strain with respect to almost relaxed films. These results demonstrate that epitaxial strain is a powerful lever to control the electric properties of LSCO and enhance its thermoelectric properties, which is of high interest for various devices and key applications such as thermal energy harvesters, coolers, transparent conductors, photocatalyzers, and spintronic memories.
88 - M.Z. Shi , B. Lei , C. S. Zhu 2019
The observation of quantized anomalous Hall conductance in the forced ferromagnetic state of MnBi2Te4 thin flakes has attracted much attentions. However, strong magnetic field is needed to fully polarize the magnetic moments due to the large antiferr omagnetic interlayer exchange coupling. Here, we reported the magnetic and electrical transport properties of the magnetic van der Waals MnBi2Te4(Bi2Te3)n (n=1,2) single crystals, in which the interlayer antiferromagnetic exchange coupling is greatly suppressed with the increase of the separation layers Bi2Te3. MnBi4Te7 and MnBi6Te10 show weak antiferromagnetic transition at 12.3 and 10.5 K, respectively. The ferromagnetic hysteresis was observed at low temperature for both of the crystals, which is quite crucial for realizing the quantum anomalous Hall effect without external magnetic field. Our work indicates that MnBi2Te4(Bi2Te3)n (n=1,2) provide ideal platforms to investigate the rich topological phases with going to their 2D limits.
The spectacular metal-to-insulator transition of V2O3 can be progressively suppressed in thin film samples. Evidence for phase separation was observed using microbridges as a mesoscopic probe of transport properties where the same film possesses doma ins that exhibit a metal-to-insulator transition with clear first order features or remain metallic down to low temperatures. A simple model consisting of two parallel resistors can be used to quantify a phase coexistence scenario explaining the measured macroscopic transport properties. The interaction between film and substrate is the most plausible candidate to explain this extended phase coexistence as shown by a correlation between the transport properties and the structural data.
We present high-temperature ferromagnetism and large magnetic anisotropy in heavily Fe-doped n-type ferromagnetic semiconductor (In1-x,Fex)Sb (x = 20 - 35%) thin films grown by low-temperature molecular beam epitaxy. The (In1-x,Fex)Sb thin films with x = 20 - 35% maintain the zinc-blende crystal and band structure with single-phase ferromagnetism. The Curie temperature (TC) of (In1-x,Fex)Sb reaches 390 K at x = 35%, which is significantly higher than room temperature and the highest value so far reported in III-V based ferromagnetic semiconductors. Moreover, large coercive force (HC = 160 Oe) and large remanent magnetization (Mr/MS = 71%) have been observed for a (In1-x,Fex)Sb thin film with x = 35%. Our results indicate that the n-type ferromagnetic semiconductor (In1-x,Fex)Sb is very promising for spintronics devices operating at room temperature.
التعليقات
جاري جلب التعليقات جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا