اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدNoise properties of the CoRoT data: a planet-finding perspective
139
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
In this short paper, we study the photometric precision of stellar light curves obtained by the CoRoT satellite in its planet finding channel, with a particular emphasis on the timescales characteristic of planetary transits. Together with other articles in the same issue of this journal, it forms an attempt to provide the building blocks for a statistical interpretation of the CoRoT planet and eclipsing binary catch to date. After pre-processing the light curves so as to minimise long-term variations and outliers, we measure the scatter of the light curves in the first three CoRoT runs lasting more than 1 month, using an iterative non-linear filter to isolate signal on the timescales of interest. The bevhaiour of the noise on 2h timescales is well-described a power-law with index 0.25 in R-magnitude, ranging from 0.1mmag at R=11.5 to 1mmag at R=16, which is close to the pre-launch specification, though still a factor 2-3 above the photon noise due to residual jitter noise and hot pixel events. There is evidence for a slight degradation of the performance over time. We find clear evidence for enhanced variability on hours timescales (at the level of 0.5 mmag) in stars identified as likely giants from their R-magnitude and B-V colour, which represent approximately 60 and 20% of the observed population in the direction of Aquila and Monoceros respectively. On the other hand, median correlated noise levels over 2h for dwarf stars are extremely low, reaching 0.05mmag at the bright end.
قيم البحث
اقرأ أيضاً
Like the miniaturization of modern computers, next-generation radial velocity instruments will be significantly smaller and more powerful than their predecessors.
We present a framework for the analysis of direct detection planet finding missions using space telescopes. This framework generates simulations of complete missions, with varying populations of planets, to produce ensembles of mission simulations, w
hich are used to calculate distributions of mission science yields. We describe the components of a mission simulation, including the complete description of an arbitrary planetary system, the description of a planet finding instrument, and the modeling of a target system observation. These components are coupled with a decision modeling algorithm, which allows us to automatically generate mission timelines with simple mission rules that lead to an optimized science yield. Along with the details of our implementation of this algorithm, we discuss validation techniques and possible future refinements. We apply this analysis technique to four mission concepts whose common element is a 4m diameter telescope aperture: an internal pupil mapping coronagraph with two different inner working angles, an external occulter, and the THEIA XPC multiple distance occulter. The focus of this study is to determine the ability of each of these designs to achieve one of their most difficult mission goals - the detection and characterization of Earth-like planets in the habitable zone. We find that all four designs are capable of detecting on the order of 5 Earth-like planets within a 5 year mission, even if we assume that only 1 out of every 10 stars has such a planet. The designs do differ significantly in their ability to characterize the planets they find. Along with science yield, we also analyze fuel usage for the two occulter designs, and discuss the strengths and weaknesses of each of the mission concepts.
The Star-Planet Activity Research CubeSat (SPARCS) is a NASA-funded astrophysics mission, devoted to the study of the ultraviolet (UV) time-domain behavior in low-mass stars. Given their abundance and size, low-mass stars are important targets in the
search for habitable-zone, exoplanets. However, not enough is known about the stars flare and quiescent emission, which powers photochemical reactions on the atmospheres of possible planets. Over its initial 1-year mission, SPARCS will stare at ~10 stars in order to measure short- (minutes) and long- (months) term variability simultaneously in the near-UV (NUV - lam = 280 nm) and far-UV (FUV - lam = 162 nm). The SPARCS payload consists of a 9-cm reflector telescope paired with two high-sensitivity 2D-doped CCDs. The detectors are kept passively cooled at 238K, in order to reduce dark-current contribution. The filters have been selected to provide strong rejection of longer wavelengths, where most of the starlight is emitted. The payload will be integrated within a 6U CubeSat to be placed on a Sun-synchronous terminator orbit, allowing for long observing stares for all targets. Launch is expected to occur not earlier than October 2021.
Since 2009, the Kepler, K2, and TESS missions have produced a vast number of lightcurves for public use. To assist citizen scientists in processing those lightcurves, the LcTools software system was developed. The system provides a set of tools to ef
ficiently search for signals of interest in large sets of lightcurves using automated and manual (visual) techniques. At the heart of the system is a multipurpose lightcurve viewer and signal processor with advanced navigation and display capabilities to facilitate the search for signals. Other applications in the system are available for building lightcurve files in bulk, finding periodic signals automatically, and generating signal reports. This paper describes each application in the system and the methods by which the software can be used to detect and record signals. The software is free and can be obtained from the lead author by request.
As part of the NASA-CNES agreement, the NASA Star and Exoplanet Database (NStED) serves as the official US portal for the public CoRoT data products. NStED is a general purpose archive with the aim of providing support for NASAs planet finding and ch
aracterization goals. Consequently, the NASA Exoplanet Science Institute (NExScI) developed, and NStED adapted, a periodogram service for CoRoT data to determine periods of variability phenomena and create phased photometric light curves. Through the NStED periodogram interface, the user may choose three different period detection algorithms to use on any photometric time series product, or even upload and analyze their own data. Additionally, the NStED periodogram is remotely accessed by the CoRoT archive as part of its interface. NStED is available at {bf http://nsted.ipac.caltech.edu}.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
