اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدChannels that Heat Up
151
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
This work considers an additive noise channel where the time-k noise variance is a weighted sum of the channel input powers prior to time k. This channel is motivated by point-to-point communication between two terminals that are embedded in the same chip. Transmission heats up the entire chip and hence increases the thermal noise at the receiver. The capacity of this channel (both with and without feedback) is studied at low transmit powers and at high transmit powers. At low transmit powers, the slope of the capacity-vs-power curve at zero is computed and it is shown that the heating-up effect is beneficial. At high transmit powers, conditions are determined under which the capacity is bounded, i.e., under which the capacity does not grow to infinity as the allowed average power tends to infinity.
قيم البحث
اقرأ أيضاً
Motivated by damage due to heating in sensor operation, we consider the throughput optimal offline data scheduling problem in an energy harvesting transmitter such that the resulting temperature increase remains below a critical level. We model the t
emperature dynamics of the transmitter as a linear system and determine the optimal transmit power policy under such temperature constraints as well as energy harvesting constraints over an AWGN channel. We first derive the structural properties of the solution for the general case with multiple energy arrivals. We show that the optimal power policy is piecewise monotone decreasing with possible jumps at the energy harvesting instants. We derive analytical expressions for the optimal solution in the single energy arrival case. We show that, in the single energy arrival case, the optimal power is monotone decreasing, the resulting temperature is monotone increasing, and both remain constant after the temperature hits the critical level. We then generalize the solution for the multiple energy arrival case.
The capacity regions are investigated for two relay broadcast channels (RBCs), where relay links are incorporated into standard two-user broadcast channels to support user cooperation. In the first channel, the Partially Cooperative Relay Broadcast C
hannel, only one user in the system can act as a relay and transmit to the other user through a relay link. An achievable rate region is derived based on the relay using the decode-and-forward scheme. An outer bound on the capacity region is derived and is shown to be tighter than the cut-set bound. For the special case where the Partially Cooperative RBC is degraded, the achievable rate region is shown to be tight and provides the capacity region. Gaussian Partially Cooperative RBCs and Partially Cooperative RBCs with feedback are further studied. In the second channel model being studied in the paper, the Fully Cooperative Relay Broadcast Channel, both users can act as relay nodes and transmit to each other through relay links. This is a more general model than the Partially Cooperative RBC. All the results for Partially Cooperative RBCs are correspondingly generalized to the Fully Cooperative RBCs. It is further shown that the AWGN Fully Cooperative RBC has a larger achievable rate region than the AWGN Partially Cooperative RBC. The results illustrate that relaying and user cooperation are powerful techniques in improving the capacity of broadcast channels.
Alice and Bob want to share a secret key and to communicate an independent message, both of which they desire to be kept secret from an eavesdropper Eve. We study this problem of secret communication and secret key generation when two resources are a
vailable -- correlated sources at Alice, Bob, and Eve, and a noisy broadcast channel from Alice to Bob and Eve which is independent of the sources. We are interested in characterizing the fundamental trade-off between the rates of the secret message and secret key. We present an achievable solution and prove its optimality for the parallel channels and sources case when each sub-channel and source component satisfies a degradation order (either in favor of the legitimate receiver or the eavesdropper). This includes the case of jointly Gaussian sources and an additive Gaussian channel, for which the secrecy region is evaluated.
The capacity of discrete-time, non-coherent, multipath fading channels is considered. It is shown that if the delay spread is large in the sense that the variances of the path gains do not decay faster than geometrically, then capacity is bounded in the signal-to-noise ratio.
A rateless code-i.e., a rate-compatible family of codes-has the property that codewords of the higher rate codes are prefixes of those of the lower rate ones. A perfect family of such codes is one in which each of the codes in the family is capacity-
achieving. We show by construction that perfect rateless codes with low-complexity decoding algorithms exist for additive white Gaussian noise channels. Our construction involves the use of layered encoding and successive decoding, together with repetition using time-varying layer weights. As an illustration of our framework, we design a practical three-rate code family. We further construct rich sets of near-perfect rateless codes within our architecture that require either significantly fewer layers or lower complexity than their perfect counterparts. Variations of the basic construction are also developed, including one for time-varying channels in which there is no a priori stochastic model.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
