اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدCombinatorial discovery of a lead-free morphotropic phase boundary in a thin-film piezoelectric perovskite
134
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We report on the discovery of a lead-free morphotropic phase boundary in Sm doped BiFeO3 with a simple perovskite structure using the combinatorial thin film strategy. The boundary is a rhombohedral to pseudo-orthorhombic structural transition which exhibits a ferroelectric (FE) to antiferroelectric (AFE) transition at approximately Bi0.86Sm0.14FeO3 with dielectric constant and out-of-plane piezoelectric coefficient comparable to those of epitaxial (001) oriented Pb(Zr,Ti)O3 (PZT) thin films at the MPB. The discovered composition may be a strong candidate of a Pb-free piezoelectric replacement of PZT.
قيم البحث
اقرأ أيضاً
Recently, based on the phase-field modeling, it was predicted that Hf1-xZrxO2 (HZO) exhibits the morphotropic phase boundary (MPB) in its compositional phase diagram. Here, we investigate the effect of structural changes between tetragonal (t) and or
thorhombic (o) phases on the ferroelectric and dielectric properties of HZO films to probe the existence of MPB region. The structural analysis show that by adjusting the ozone dosage during the atomic layer deposition process and annealing conditions, different ratios of t- to o-phases (f_(t/o) ) were achieved which consequently affect the ferroelectric and dielectric properties of the samples. Polarization versus electric field measurements show a remarkable increase in ferroelectric characteristics (Pr and Ec) of the sample that contains the minimum t-phase fraction (f_(t/o)~ 0.04). This sample shows the lowest dielectric constant compared to the other samples which is due to the formation of ferroelectric o-phase. The sample that contains the maximum f_(t/o)~ 0.41 demonstrates the highest dielectric response. By adjusting the f_(t/o), a large dielectric constant of ~ 55 is achieved. Our study reveals a direct relation between f_(t/o) and dielectric constant of HZO thin films which can be understood by considering the density of MPB region.
We investigate the microstructural evolution in a ferroelectric to antiferroelectric phase transition at the morphotropic phase boundary in the Bi(1-x)SmxFeO3 system. Continuous Sm3+ substitution on the A-site induces short-range anti-parallel cation
displacements as verified by the appearance of localized 1/4(110) weak spots in selected area electron diffraction patterns for 0.1<x<0.14 samples, and thus onset of antiferroelectricity. Kinetic Monte Carlo simulations confirm that increasing the strength of the anti-parallel interactions (i.e. increasing x) induces a ferroelectric to antiferroelectric transition. For 0.14<x<0.2 antiphase oxygen octahedra tilts induce complete antiferroelectricity.
Morphotropic phase boundaries (MPBs) show substantial piezoelectric and dielectric responses, which have practical applications. The predicted existence of MPB in HfO2-ZrO2 solid solution thin film has provided a new way to increase the dielectric pr
operties of a silicon-compatible device. Here, we present a new fabrication design by which the density of MPB and consequently the dielectric constant of HfO2-ZrO2 thin film was considerably increased. The density of MPB was controlled by fabrication of a 10-nm [1 nm-Hf0.5Zr0.5O2 (Ferroelectric)/1 nm-ZrO2 (Antiferroelectric)] nanolaminate followed by an appropriate annealing process. The coexistence of orthorhombic and tetragonal structures, which are the origins of ferroelectric (FE) and antiferroelectric (AFE) behaviors, respectively, was structurally confirmed, and a double hysteresis loop that originates from AFE ordering, with some remnant polarization that originates from FE ordering, was observed in P-E curve. A remarkable increase in dielectric constant compared to the conventional HfO2-ZrO2 thin film was achieved by controlling the FE-AFE ratio. The fabrication process was performed at low temperature and the device is compatible with silicon technology, so the new design yields a device that has possible applications in near-future electronics.
We report here the structure and dielectric studies on a new lead free (1-x)BaTiO3-xBi(Mg1/2Zr1/2)O3 solid solution to explore the morphotropic phase boundary. The powder x-ray diffraction studies on (1-x)BaTiO3-xBi(Mg1/2Zr1/2)O3 solid solution sugge
sts that structure is tetragonal (P4mm) for the composition with x=0.05 and cubic for the composition with x=0.30 and 0.40. Morphotropic phase boundary is observed in the composition range 0.10<x<0.30, where phase coexistence is observed and composition dependence of room temperature permittivity shows a peak. High temperature dielectric measurement for the composition with x=0.20 exhibits diffuse phase transition having peak temperature around ~ 396 K at 10 kHz. The diffuseness parameter ({gamma}) was obtained to be 1.68 for composition with x=0.20.
We have investigated heteroepitaxial films of Sm-doped BiFeO3 with a Sm-concentration near a morphotropic phase boundary. Our high-resolution synchrotron X-ray diffraction, carried out in a temperature range of 25C to 700C, reveals substantial phase
coexistence as one changes temperature to crossover from a low-temperature PbZrO3-like phase to a high-temperature orthorhombic phase. We also examine changes due to strain for films greater or less than the critical thickness for misfit dislocation formation. Particularly, we note that thicker films exhibit a substantial volume collapse associated with the structural transition that is suppressed in strained thin films.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
