اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدResonance enhanced isotope-selective photoionization of YbI for ion trap loading
248
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Neutral Ytterbium (YbI) and singly ionized Ytterbium (YbII) is widely used in experiments in quantum optics, metrology and quantum information science. We report on the investigation of isotope selective two-photoionisation of YbI that allows for efficient loading of ion traps with YbII. Results are presented on two-colour (399 nm and 369 nm) and single-colour (399 nm) photoionisation and their efficiency is compared to electron impact ionisation. Nearly deterministic loading of a desired number of YbII ions into a linear Paul trap is demonstrated.
قيم البحث
اقرأ أيضاً
Examination of loading the isotopes $^{85}$Rb and $^{87}$Rb simultaneously into a shallow far-off-resonance trap (FORT) has revealed an unexpected decrease in maximum atom number loaded as compared to loading either isotope alone. The simultaneous lo
ading of the FORT will be affected by additional homonuclear and heteronuclear light-assisted collisional losses. However, these losses are measured and found to be insufficient to explain the observed drop in total number of atoms loaded into the FORT. We find that our observations are consistent with a decrease in loading rate caused by inter-isotope disruptions of the efficient laser cooling required to load atoms into the optical trap.
We have developed a unique neutralizer device that uses an yttrium target surrounded by a platinum wall to magneto-optically trap radioactive atoms. In general, the radioactive nucleus produced in a nuclear reaction is extracted and transported in io
n form. For the magneto-optical trap, thermal neutralization must occur on the surface of a metal with a small work function. The converter can produce a neutral atomic beam with small angular divergence that, given the recycling of atoms and ions, converts ions into neutral atoms with remarkable efficiency. We demonstrated the ion neutralization process using stable rubidium and confirmed $10^6$ neutralized atoms in the magneto-optical trap. Additionally, the experiment using francium demonstrated the obtaining of neutralized francium atoms.
We have demonstrated that the ion current resulting from collisions between metastable krypton atoms in a magneto-optical trap can be used to precisely measure the trap loading rate. We measured both the ion current of the abundant isotope Kr-83 (iso
topic abundance = 11%) and the single-atom counting rate of the rare isotope Kr-85 (isotopic abundance ~ 1x10^-11), and found the two quantities to be proportional at a precision level of 0.9%. This work results in a significant improvement in using the magneto-optical trap as an analytical tool for noble-gas isotope ratio measurements, and will benefit both atomic physics studies and applications in the earth sciences.
Recently, we have experimentally demonstrated a continuous loading mechanism for an optical dipole trap from a guided atomic beam [1]. The observed evolution of the number of atoms and temperature in the trap are consequences of the unusual trap geom
etry. In the present paper, we develop a model based on a set of rate equations to describe the loading dynamics of such a mechanism. We consider the collision statistics in the non-uniform trap potential that leads to twodimensional evaporation. The comparison between the resulting computations and experimental data allows to identify the dominant loss process and suggests ways to enhance the achievable steady-state atom number. Concerning subsequent evaporative cooling, we find that the possibility of controlling axial and radial confinement independently allows faster evaporation ramps compared to single beam optical dipole traps.
One important factor which determines efficiency of loading cold atoms into an optical dipole trap from a magneto-optical trap is the distance between the trap centers. By studying this efficiency for various optical trap depths (2--110 mK) we find t
hat for optimum dipole trap loading, longitudinal displacements up to 15 mm are necessary. An explanation for this observation is presented and compared with other work and a simple analytical formula is derived for the optimum distance between the trap centers.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
