اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدComparison of coherence times in three dc SQUID phase qubits
105
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We report measurements of spectroscopic linewidth and Rabi oscillations in three thin-film dc SQUID phase qubits. One device had a single-turn Al loop, the second had a 6-turn Nb loop, and the third was a first order gradiometer formed from 6-turn wound and counter-wound Nb coils to provide isolation from spatially uniform flux noise. In the 6 - 7.2 GHz range, the spectroscopic coherence times for the gradiometer varied from 4 ns to 8 ns, about the same as for the other devices (4 to 10 ns). The time constant for decay of Rabi oscillations was significantly longer in the single-turn Al device (20 to 30 ns) than either of the Nb devices (10 to 15 ns). These results imply that spatially uniform flux noise is not the main source of decoherence or inhomogenous broadening in these devices.
قيم البحث
اقرأ أيضاً
We report measurements of Rabi oscillations and spectroscopic coherence times in an Al/AlOx/Al and three Nb/AlOx/Nb dc SQUID phase qubits. One junction of the SQUID acts as a phase qubit and the other junction acts as a current-controlled nonlinear i
solating inductor, allowing us to change the coupling to the current bias leads in situ by an order of magnitude. We found that for the Al qubit a spectroscopic coherence time T2* varied from 3 to 7 ns and the decay envelope of Rabi oscillations had a time constant T = 25 ns on average at 80 mK. The three Nb devices also showed T2* in the range of 4 to 6 ns, but T was 9 to 15 ns, just about 1/2 the value we found in the Al device. For all the devices, the time constants were roughly independent of the isolation from the bias lines, implying that noise and dissipation from the bias leads were not the principal sources of dephasing and inhomogeneous broadening.
We analyze the behavior of a dc Superconducting Quantum Interference Device (SQUID) phase qubit in which one junction acts as a phase qubit and the rest of the device provides isolation from dissipation and noise in the bias leads. Ignoring dissipati
on, we find the two-dimensional Hamiltonian of the system and use numerical methods and a cubic approximation to solve Schrodingers equation for the eigenstates, energy levels, tunneling rates, and expectation value of the currents in the junctions. Using these results, we investigate how well this design provides isolation while preserving the characteristics of a phase qubit. In addition, we show that the expectation value of current flowing through the isolation junction depends on the state of the qubit and can be used for non-destructive read out of the qubit state.
We consider voltage and current responses formation in DC SQUID with overdamped Josephson junctions in resistive and superconducting state in the frame of resistively shunted junction (RSJ) model. For simplicity we neglect the junction capacitance an
d the noise effect. Explicit expressions for the responses in resistive state were obtained for a SQUID which is symmetrical with respect to bias current injection point. Normalized SQUID inductance $l = 2 e I_c L/hbar$ (where $I_c$ is the critical current of Josephson junction, $L$ is the SQUID inductance, $e$ is the electron charge and $hbar$ is the Planck constant) was assumed to be within the range $l leq 1$, subsequently expanded up to $l approx 7$ using two fitting parameters. SQUID current response in superconducting state was considered for arbitrary value of the inductance. Impact of small technological spread of parameters relevant for low-temperature superconductor (LTS) technology was studied with generalization of the developed analytical approach for a case of small difference of critical currents and shunt resistances of the Josephson junctions, and inequality of SQUID inductive shoulders for both resistive and superconducting states. Comparison with numerical calculation results shows that developed analytical expressions can be used in practical LTS SQUIDs and SQUID-based circuits design, e.g. large serial SQIF, drastically decreasing the time of simulation.
We utilize a superconducting stripline resonator containing a dc-SQUID as a strong intermodulation amplifier exhibiting a signal gain of 25 dB and a phase modulation of 30 dB. Studying the system response in the time domain near the intermodulation a
mplification threshold reveals a unique noise-induced spikes behavior. We account for this response qualitatively via solving numerically the equations of motion for the integrated system. Furthermore, employing this device as a parametric amplifier yields a gain of 38 dB in the generated side-band signal.
The behavior of a dc SQUID, based on a dirty point contacts between a single-band and three-band superconductor with broken time-reversal symmetry is investigated. Using earlier obtained results for Josephson effects in such systems new features in c
haracteristics of a dc SQUID are revealed. It is shown that in the case of a BTRS (broken time-reversal symmetry) three-band superconductor for the applied external magnetic flux, which is divisible by the half-integer flux, strong degeneracy of ground states of a dc SQUID is taken place. This can lead to the appearance of possible multi-hysteresis loops on a dependence of a total flux in the dc SQUID from the externally applied flux. The number of these loops depends on the position of ground states of a three-band superconductor. Also it is found that dependencies of a critical current on applied magnetic flux can have complicated multi-periodic forms, which are differ from strictly periodic characteristics for conventional dc SQUIDs and Fraunhofer patterns for Josephson contacts in the external magnetic field.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
