اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدTheoretical and Experimental Study of LiBH4-LiBr Phase Diagram
104
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Because substitutions of BH4- anion with Br can stabilize the hexagonal structure of the LiBH4 at room temperature, leading to a high Li-ion conductivity, its thermodynamic stability has been investigated in this work. The binary LiBH4-LiBr system has been explored by means of X-ray diffraction and differential scanning calorimetry, combined with an assessment of thermodynamic properties. The monophasic zone of the hexagonal Li(BH4)1-x(Br)x solid solution has been defined from x=0.30 to x=0.55 at room temperature. Solubility limits have been determined by in-situ X-ray diffraction at various temperatures. For the formation of the h-Li(BH4)0.6(Br)0.4 solid solution, a value of the enthalpy of mixing has been determined experimentally equal to 1.0 kJ/mol. In addition, the enthalpy of melting has been measured for various compositions. Lattice stabilities of LiBH4 and LiBr have been determined by ab initio calculations, using CRYSTAL and VASP codes. Combining results of experiments and theoretical calculations, the LiBH4-LiBr phase diagram has been determined in all composition and temperature range by the CALPHAD method.
قيم البحث
اقرأ أيضاً
This paper presents an experimental and theoretical study of the distribution of carbon atoms in the octahedral interstitial sites of the face-centered cubic (fcc) phase of the iron-carbon system. The experimental part of the work consists of Mossbau
er measurements in Fe-C alloys with up to about 12 atomic percent C, which are interpreted in terms of two alternative models for the distribution of C atoms in the interstitial sites. The theoretical part combines an analysis of the chemical potential of C based on the quasichemical approximation to the statistical mechanics of interstitial solutions, with three-dimensional Monte Carlo simulations. The latter were performed by assuming a gas like mixture of C atoms and vacancies (Va) in the octahedral interstitial sites. The number of C-C, C-Va and Va-Va pairs calculated using Monte Carlo simulations are compared with those given by the quasichemical model. Furthermore, the relative fraction of the various Fe environments were calculated and compared with those extracted from the Mossbauer spectra. The simulations reproduce remarkably well the relative fractions obtained assuming the Fe(8)C(1-y) model for Mossbauer spectra, which includes some blocking of the nearest neighbour interstitial sites by a C atom. With the new experimental and theoretical information obtained in the present study, a critical discussion is reported of the extent to which such blocking effect is accounted for in current thermodynamic models of the Fe-C fcc phase. Abstract PACS Codes: 2.70.Uu, 76.
The defect chemistry of perovskite compounds is directly related to the stoichiometry and to the valence states of the transition metal ions. Such relations are of high interest as they offer the possibility to influence the catalytic activity of per
ovskites for the application in solid-oxide fuel- and electrolyser cells. Combining theoretical and experimental approaches, we explore the feasibility of actively manipulating the valence state of Fe and the concentration of point defects by synthesizing non-stoichiometric LaFeO$_3$ (LFO). In the theoretical part, formation energies and concentrations of point defects were determined as a function of processing conditions by first-principles DFT+U calculations. Based on the DFT+U results, significant compositional deviations from stoichiometric LFO cannot be expected by providing rich or poor conditions of the oxidic precursor compounds (Fe$_2$O$_3$ and La$_2$O$_3$) in a solid-state processing route. In the experimental part, LFO was synthesized with a targeted La-site deficiency. We analyze the resulting phases in detail by X-ray diffraction and dedicated microscopy methods, namely scanning electron microscopy (SEM) and (scanning) transmission electron Microscopy ((S)TEM) in combination with energy dispersive X-ray spectroscopy (EDS) and electron energy-loss spectrometry (EELS). Instead of a variation of the La/Fe ratio, a mixture of two phases, Fe$_2$O$_3$/LaFeO$_3$, was observed resulting in an invariant charge state of Fe, which is in line with the theoretical results. We discuss our findings with respect to partly differing assumptions made in previously published studies on this material system.
We predict the existence of a new ferromagnetic shape memory alloy Ga_2MnNi using density functional theory. The martensitic start temperature (T_M) is found to be approximately proportional to the stabilization energy of the martensitic phase (delta
E_tot) for different shape memory alloys. Experimental studies performed to verify the theoretical results show that Ga_2MnNi is ferromagnetic at room temperature and the T_M and T_C are 780K and 330K, respectively. Both from theory and experiment, the martensitic transition is found to be volume conserving that is indicative of shape memory behavior.
We use bulk-sensitive soft X-ray angle-resolved photoemission spectroscopy and investigate bulk electronic structures of Ce monopnictides (CeX; X=P, As, Sb and Bi). By exploiting a paradigmatic study of the band structures as a function of their spin
-orbit coupling (SOC), we draw the topological phase diagram of CeX and unambiguously reveal the topological phase transition from a trivial to a nontrivial regime in going from CeP to CeBi induced by the band inversion. The underlying mechanism of the topological phase transition is elucidated in terms of SOC in concert with their semimetallic band structures. Our comprehensive observations provide a new insight into the band topology hidden in the bulk of solid states.
We extend recent textit{ab initio} calculations of the electronic band structure and the phonon dispersion relations of rhombohedral GeTe to calculations of the density of phonon states and the temperature dependent specific heat. The results are com
pared with measurements of the specific heat. It is discovered that the specific heat depends on hole concentration, not only in the very low temperature region (Sommerfeld term) but also at the maximum of $C_p/T^3$ (around 16 K). To explain this phenomenon, we have performed textit{ab initio} lattice dynamical calculations for GeTe rendered metallic through the presence of a heavy hole concentration ($p$ $sim$ 2$times$ 10$^{21}$ cm$^{-3}$). They account for the increase observed in the maximum of $C_p/T^3$.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
