اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدHigh Thermoelectric Performance and Defect Energetics of Multi-pocketed Full-Heusler Compounds
108
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We report first-principles density-functional study of electron-phonon interactions and thermoelectric transport properties of full-Heusler compounds Sr$_{2}$BiAu and Sr$_{2}$SbAu. Our results show that ultrahigh intrinsic bulk thermoelectric performance across a wide range of temperatures is physically possible and point to the presence of multiply degenerate and highly dispersive carrier pockets as the key factor for achieving it. Sr$_{2}$BiAu, which features ten energy-aligned low effective mass pockets (six along $Gamma-X$ and four at $L$), is predicted to deliver $n$-type $zT=0.4-4.9$ at $T=100-700$~K. Comparison with the previously investigated Ba$_{2}$BiAu compound shows that the additional $L$-pockets in Sr$_{2}$BiAu significantly increase its low-temperature power factor to a maximum value of $12$~mW~m$^{-1}$~K$^{-2}$ near $T=300$~K. However, at high temperatures the power factor of Sr$_{2}$BiAu drops below that of Ba$_{2}$BiAu because the $L$ states are heavier and subject to strong scattering by phonon deformation as opposed to the lighter $Gamma-X$ states that are limited by polar-optical scattering. Sr$_{2}$SbAu is predicted to deliver lower $n$-type of $zT=3.4$ at $T=750$~K due to appreciable misalignment between the $L$ and $Gamma-X$ carrier pockets, generally heavier scattering, and slightly higher lattice thermal conductivity. Soft acoustic modes, responsible for low lattice thermal conductivity, also increase vibrational entropies and high-temperature stability of the Heusler compounds, suggesting that their experimental synthesis may be feasible. The dominant intrinsic defects are found to be Au vacancies, which drive the Fermi level towards the conduction band and work in favor of $n$-doping.
قيم البحث
اقرأ أيضاً
The electronic and transport properties of the half-Heusler compound LaPtSb are investigated by performing first-principles calculations combined with semi-classical Boltzmann theory and deformation potential theory. Compared with many typical half-H
eusler compounds, the LaPtSb exhibits obviously larger power factor at room temperature, especially for the n-type system. Together with the very low lattice thermal conductivity, the thermoelectric figure of merit (ZT) of LaPtSb can be optimized to a record high value of 2.2 by fine tuning the carrier concentration.
Half-Heusler compounds usually exhibit relatively higher lattice thermal conductivity that is undesirable for thermoelectric applications. Here we demonstrate by first-principles calculations and Boltzmann transport theory that the BiBaK system is an
exception, which has rather low thermal conductivity as evidenced by very small phonon group velocity and relaxation time. Detailed analysis indicates that the heavy Bi and Ba atoms form a cage-like structure, inside which the light K atom rattles with larger atomic displacement parameters. In combination with its good electronic transport properties, the BiBaK shows a maximum n-type ZT value of 1.9 at 900 K, which outperforms most half-Heusler thermoelectric materials.
A series of full-Heusler alloys, $rm Fe_2V_{1-x}W_xAl$, $0 leq x leq 0.2$, was prepared, characterized and relevant physical properties to account for the thermoelectric performance were studied in a wide temperature range. Additionally, off-stoichio
metric samples with similar compositions have been included, and a 10~% improvement of the thermoelectric figure of merit was obtained. The V/W substitution causes i) a change of the main carrier type, from holes to electrons as evidenced from Seebeck and Hall measurements and ii) a substantial reduction of the lattice thermal conductivity due to a creation of lattice disorder by means of a distinct different mass and metallic radius upon the V/W substitution. Moreover $ZT$ values above 0.2 have been obtained. A microscopic understanding of the experimental data observed is revealed from ab-initio calculations of the electronic and phononic structure.
A half-Heusler material FeNb$_{0.8}$Ti$_{0.2}$Sb has been identified as a promising thermoelectric material due to its excellent thermoelectric performance at high temperatures. The origins of the efficient thermoelectric performance are investigated
through a series of low-temperature (2 - 400 K) measurements. The high data coherence of the low and high temperatures is observed. An optimal and nearly temperature-independent carrier concentration is identified, which is ideal for the power factor. The obtained single type of hole carrier is also beneficial to the large Seebeck coefficient. The electronic thermal conductivity is found to be comparable to the lattice thermal conductivity and becomes the dominant component above 200 K. These findings again indicate that electron scattering plays a key role in the electrical and thermal transport properties. The dimensionless figure of merit is thus mainly governed by the electronic properties. These effects obtained at low temperatures with the avoidance of possible thermal fluctuations together offer the physical origin for the excellent thermoelectric performance in this material.
Whether porosity can effectively improve thermoelectric performance is still an open question. Herein we report that thermoelectric performance can be significantly enhanced by creating porosity in n-type Mg3.225Mn0.025Sb1.5Bi0.49Te0.01, with a ZT of
~0.9 at 323 K and ~1.6 at 723 K, making the average ZT much higher for better performance. The large improvement at room temperature is significant considering that such a ZT value is comparable to the best ZT at this temperature in n-type Bi2Te3. The enhancement was mainly from the improved electrical mobility and multi-scale phonon scattering, particularly from the well-dispersed bismuth nano-precipitates in the porous structure. We further extend this approach to other thermoelectric materials such as half-Heuslers Nb0.56V0.24Ti0.2FeSb and Hf0.25Zr0.75NiSn0.99Sb0.01 and Bi0.5Sb1.5Te3 showing similar improvements, further advancing thermoelectric materials for applications.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
