اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدLow-impedance superconducting microwave resonators for strong coupling to small magnetic mode volumes
59
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Recent experiments on strongly coupled microwave and ferromagnetic resonance modes have focused on large volume bulk crystals such as yttrium iron garnet, typically of millimeter-scale dimensions. We extend these experiments to lower volumes of magnetic material by exploiting low-impedance lumped-element microwave resonators. The low impedance equates to a smaller magnetic mode volume, which allows us to couple to a smaller number of spins in the ferromagnet. Compared to previous experiments, we reduce the number of participating spins by two orders of magnitude, while maintaining the strength of the coupling rate. Strongly coupled devices with small volumes of magnetic material may allow the use of spin orbit torques, which require high current densities incompatible with existing structures.
قيم البحث
اقرأ أيضاً
Graphene is an attractive material for nanomechanical devices because it allows for exceptional properties, such as high frequencies and quality factors, and low mass. An outstanding challenge, however, has been to obtain large coupling between the m
otion and external systems for efficient readout and manipulation. Here, we report on a novel approach, in which we capacitively couple a high-Q graphene mechanical resonator ($Q sim 10^5$) to a superconducting microwave cavity. The initial devices exhibit a large single-photon coupling of $sim 10$ Hz. Remarkably, we can electrostatically change the graphene equilibrium position and thereby tune the single photon coupling, the mechanical resonance frequency and the sign and magnitude of the observed Duffing nonlinearity. The strong tunability opens up new possibilities, such as the tuning of the optomechanical coupling strength on a time scale faster than the inverse of the cavity linewidth. With realistic improvements, it should be possible to enter the regime of quantum optomechanics.
We implement superconducting YBCO planar resonators with two fundamental modes for circuit quantum electrodynamics experiments. We first demonstrate good tunability in the resonant microwave frequencies and in their interplay as it emerges from the d
ependence of the transmission spectra on the device geometry. We then investigate the magnetic coupling of the resonant modes with bulk samples of DPPH organic radical spins. The transmission spectroscopies performed at low temperature show that the coherent spin-photon coupling regime with the spin ensembles can be achieved by each of the resonator modes. The analysis of the results within the framework of the Input-Output formalism and by means of entropic measures demonstrates coherent mixing of the degrees of freedom corresponding to two remote spin ensembles and, with a suitable choice of the geometry, the approaching of a regime with spin-induced mixing of the two photon modes.
In many hybrid quantum systems, a superconducting circuit is required that combines DC-control with a coplanar waveguide (CPW) microwave resonator. The strategy thus far for applying a DC voltage or current bias to microwave resonators has been to ap
ply the bias through a symmetry point in such a way that it appears as an open circuit for certain frequencies. Here, we introduce a microwave coupler for superconducting CPW cavities in the form of a large shunt capacitance to ground. Such a coupler acts as a broadband mirror for microwaves while providing galvanic connection to the center conductor of the resonator. We demonstrate this approach with a two-port $lambda/4$-transmission resonator with linewidths in the MHz regime ($Qsim10^3$) that shows no spurious resonances and apply a voltage bias up to $80$ V without affecting the quality factor of the resonator. This resonator coupling architecture, which is simple to engineer, fabricate and analyse, could have many potential applications in experiments involving superconducting hybrid circuits.
Coulomb interaction has important consequences on the physics of quantum spin Hall edge states, weakening the topological protection via two-particle scattering and renormalizing both the velocity and charge of collective plasmon modes compared to th
at of free electrons. Despite these effects, interactions remain difficult to quantify. We propose here simple and robust edge resonator geometries to characterize Coulomb interaction by means of high-frequency measurements. They rely on a transmission line approach, and take advantage of the impedance mismatch between the edge states and their microwave environment.
Placing an ensemble of $10^6$ ultracold atoms in the near field of a superconducting coplanar waveguide resonator (CPWR) with $Q sim 10^6$ one can achieve strong coupling between a single microwave photon in the CPWR and a collective hyperfine qubit
state in the ensemble with $g_textit{eff} / {2 pi} sim 40$ kHz larger than the cavity line width of ${kappa}/{2 pi} sim 7$ kHz. Integrated on an atomchip such a system constitutes a hybrid quantum device, which also can be used to interconnect solid-state and atomic qubits, to study and control atomic motion via the microwave field, observe microwave super-radiance, build an integrated micro maser or even cool the resonator field via the atoms.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
