اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدLeaky mode analysis of luminescent thin films: the case of ZnO on sapphire
101
0
0.0
(
0
)
تأليف
Roy Aad
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
Zinc oxide (ZnO) epitaxial thin films grown on c-sapphire substrates by pulsed laser deposition were investigated using angle and polarization-resolved photoluminescence spectroscopy. Side-emission spectra differed significantly from surface-emission spectra in exhibiting dominant, narrow, polarization-resolved peaks. These spectral features were attributed to leaky substrate modes in the layers. Observations were first verified using transmission calculations with non-adjustable parameters, which took into account the dispersion, the anisotropy of the ZnO refractive index and the dependence on film thickness. Results were consistent with Fabry-Perot-like interference being the origin of the distinctive ZnO luminescence observed at grazing incidence angles. A second analysis, based on the source terms method, was used in order to retrieve the bulk emission properties, including the wavelength-dependent quantum yield and the emission anisotropy. While ZnO thin films were considered here, this analysis method can be extended to any luminescent thin film of similar geometry, demonstrating the potential of leaky mode analysis for probing passive and active material properties.
قيم البحث
اقرأ أيضاً
Zinc Oxide thin films were grown on c-sapphire substrates using pulsed laser deposition. Pump power dependence of surface emission spectra, acquired using a quadrupled 266 nm laser, revealed room temperature stimulated emission (threshold of 900 kW/c
m2). Time dependent spectral analysis plus gain measurements of single-shot, side-emission, spectra pumped with a nitrogen laser revealed random lasing indicative of the presence of self-forming laser cavities. It is suggested that random lasing in an epitaxial system rather than a 3-dimensional configuration of disordered scattering elements, was due to waveguiding in the film. Waveguiding causes light to be amplified within randomly-formed closed-loops acting as lasing cavities.
The prediction of ferromagnetism at room temperature in Co-ZnO thin films has generated a large interest in the community due to the possible applications. However, the results are controversial, going from ferromagnetism to non-ferromagnetism, leadi
ng to a large debate about its origin (secondary phase, Co clusters or not). By carefully studying the micro-structure of various Co-ZnO films, we show that the Co2+ partly substitutes the ZnO wurtzite matrix without forming Co clusters. Surprisingly, the ferromagnetism nature of the films disappears as the Co content increases. In addition, our results suggest that the observed ferromagnetism is likely associated to a large amount of defects- close to the interface and strongly depending on the growth temperature- which may explained the spreading of the results.
Magnetite thin fims have been grown epitaxially on ZnO and MgO substrates using molecular beam epitaxy. The film quality was found to be strongly dependent on the oxygen partial pressure during growth. Structural, electronic, and magnetic properties
were analyzed utilizing Low Energy Electron Diffraction (LEED), HArd X-ray PhotoElectron Spectroscopy (HAXPES), Magneto Optical Kerr Effect (MOKE), and X-ray Magnetic Circular Dichroism (XMCD). Diffraction patterns show clear indication for growth in the (111) direction on ZnO. Vertical structure analysis by HAXPES depth profiling revealed uniform magnetite thin films on both type of substrates. Both, MOKE and XMCD measurements show in-plane easy magnetization with a reduced magnetic moment in case of the films on ZnO.
The profile of suspended silicon nitride thin films patterned with one-dimensional subwavelength grating structures is investigated using Atomic Force Microscopy. We first show that the results of the profilometry can be used as input to Rigorous Cou
pled Wave Analysis simulations to predict the transmission spectrum of the gratings under illumination by monochromatic light at normal incidence and compare the results of the simulations with experiments. Secondly, we observe sharp vertical deflections of the films at the boundaries of the patterned area due to local modifications of the tensile stress during the patterning process. These deflections are experimentally observed for various grating structures and investigated on the basis of a simple analytical model as well as finite element method simulations.
The observation of the electrically tunable and highly confined plasmons in graphene has stimulated the exploration of interesting properties of plasmons in other two dimensional materials. Recently, hyperbolic plasmon resonance modes are observed in
exfoliated WTe2 films, a type-II Weyl semimetal with layered structure, providing a platform for the assembly of plasmons with hyperbolicity and exotic topological properties. However, the plasmon modes were observed in relatively thick and small-area films, which restrict the tunability and application for plasmons. Here, large-area (~ cm) WTe2 films with different thickness are grown by chemical vapor deposition method, in which plasmon resonance modes are observed in films with different thickness down to about 8 nm. Hybridization of plasmon and surface polar phonons of the substrate is revealed by mapping the plasmon dispersion. The plasmon frequency is demonstrated to be tunable by changing the temperature and film thickness. Our results facilitate the development of a tunable and scalable WTe2 plasmonic system for revealing topological properties and towards various applications in sensing, imaging and light modulation.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
