اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدFree-running Sn precipitates: an efficient phase separation mechanism for metastable GeSn epilayers
112
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We report on the temperature stability of pseudomorphic GeSn films grown by molecular beam epitaxy on Ge(001) substrates. Both the growth temperature-dependence and the influence of post-growth annealing steps were investigated. In either case we observe that decomposition of metastable epilayers with Sn concentrations around 10% sets in above 230{deg}C, the eutectic temperature of the Ge/Sn system. Time-resolved annealing experiments in a scanning electron microscope reveal the crucial role of liquid Sn droplets in this phase separation process. Driven by a gradient of the chemical potential, the Sn droplets move on the surface along preferential crystallographic directions, thereby taking up Sn and Ge from the strained GeSn layer at their leading edge. While Sn-uptake increases the volume of the melt, dissolved Ge becomes re-deposited by a liquid-phase epitaxial process at the trailing edge of the droplet. Secondary droplets are launched from the rims of the single-crystalline Ge trails into intact regions of the GeSn film, leading to an avalanche-like transformation front between the GeSn film and re-deposited Ge. This process makes phase separation of metastable GeSn layers particularly efficient at rather low temperatures.
قيم البحث
اقرأ أيضاً
A novel phase field model has been developed to study the effect of coherent precipitate on the Zener pinning of matrix grain boundaries. The model accounts for misfit strain between precipitate and matrix as well as the elastic inhomogeneity and ani
sotropy between them. The results show that increase in elastic misfit, elastic inhomogeneity, and elastic anisotropy increases the coarsening rate of the precipitates. Increased coarsening of precipitates in turn decreases the pinning of grain boundaries. Therefore, increase in misfit strain, elastic inhomogeneity and anisotropy negatively affect the Zener pinning through coherent precipitate. This study shows elastic anisotropy gives rise to the needle shape precipitate. It has also been shown that these needle shaped precipitates are not very effective in Zener pinning. This study provides an understanding into the effect of coherent precipitate on the Zener pinning of matrix grain boundaries.
We probe charge photogeneration and subsequent recombination dynamics in neat regioregular poly(3-hexylthiophene) films over six decades in time by means of time-resolved photoluminescence spectroscopy. Exciton dissociation at 10K occurs extrinsicall
y at interfaces between molecularly ordered and disordered domains. Polaron pairs thus produced recombine by tunnelling with distributed rates governed by the distribution of electron-hole radii. Quantum-chemical calculations suggest that hot-exciton dissociation at such interfaces results from a high charge-transfer character.
GeSn alloys are metastable semiconductors that have been proposed as building blocks for silicon-integrated short-wave and mid-wave infrared photonic and sensing platforms. Exploiting these semiconductors requires, however, the control of their epita
xy and their surface chemistry to reduce non-radiative recombination that hinders the efficiency of optoelectronic devices. Herein, we demonstrate that a combined sulfur- and iodine-based treatments yields effective passivation of Ge and Ge0.9Sn0.1 surfaces. X-ray photoemission spectroscopy and in situ spectroscopic ellipsometry measurements were used to investigate the dynamics of surface stability and track the reoxidation mechanisms. Our analysis shows that the largest reduction in oxide after HI treatment, while HF+(NH4)2S results in a lower re-oxidation rate. A combined HI+(NH4)2S treatment preserves the lowest oxide ratio <10 % up to 1 hour of air exposure, while less than half of the initial oxide coverage is reached after 4 hours. These results highlight the potential of S- and I-based treatments in stabilizing the GeSn surface chemistry thus enabling a passivation method that is compatible with materials and device processing.
GeSn alloys are the subject of intense research activities as these group IV semiconductors present direct bandgap behaviors for high Sn contents. Today, the control of strain becomes an important challenge to improve GeSn devices. Strain micro-measu
rements are usually performed by Raman spectroscopy. However, different relationships linking the Raman spectral shifts to the built-in strain can be found in the literature. They were deduced from studies on low Sn content GeSn layers (i.e. xSn<8%) or on GeSiSn layers. In this work, we have calibrated the GeSn Raman relationship for really high Sn content GeSn binaries (6<xSn<15%). We have used fully strained GeSn layers and fully relaxed GeSn under-etched microstructures to clearly differentiate the contributions of strain and chemical composition on the Ge-Ge Raman spectral shift. We have shown that the GeSn Raman-strain coefficient for high Sn contents is higher compared to that for pure Ge.
Despite their potential to exceed the theoretical Shockley-Queisser limit, ferroelectric photovoltaics (FPVs) have performed inefficiently due to their extremely low photocurrents. Incorporating Bi2FeCrO6 (BFCO) as the light absorber in FPVs has rece
ntly led to impressively high and record photocurrents [Nechache et al. Nature Photon. 2015, 9, 61], reviving the FPV field. However, our understanding of this remarkable phenomenon is far from satisfactory. Here, we use first-principles calculations to determine that such excellent performance mainly lies in the efficient separation of electron-hole (e-h) pairs. We show that photoexcited electrons and holes in BFCO are spatially separated on the Fe and Cr sites, respectively. This separation is much more pronounced in disordered BFCO phases, which show exceptional PV responses. We further set out to design a strategy for next-generation FPVs, not limited to BFCO, by exploring 44 additional Bi-based double-perovskite oxides. We suggest 9 novel active-layer materials that can offer strong e-h separations and a desired band gap energy for application in FPVs. Our work indicates that charge separation is the most important issue to be addressed for FPVs to compete with conventional devices.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
