اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدUltrasensitive Inverse Weak-Value Tilt Meter
60
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We present an interferometric technique for measuring ultra-small tilts. The information of a tilt in one of the mirrors of a modified Sagnac interferometer is carried by the phase difference between the counter propagating laser beams. Using a small misalignment of the interferometer, orthogonal to the plane of the tilt, a bimodal (or two-fringe) pattern is induced in the beams transverse power distribution. By tracking the mean of such a distribution, using a split detector, a sensitive measurement of the phase is performed. With 1.2 mW of continuous-wave laser power, the technique has a shot noise limited sensitivity of 56 frad/$sqrt{mbox{Hz}}$, and a measured noise floor of 200 frad/$sqrt{mbox{Hz}}$ for tilt frequencies above 2 Hz. A tilt of 200 frad corresponds to a differential displacement of 4.0 fm in our setup. The novelty of the protocol relies on signal amplification due to the misalignment, and on good performance at low frequencies. A noise floor of about 70 prad/$sqrt{mbox{Hz}}$ is observed between 2 and 100 mHz.
قيم البحث
اقرأ أيضاً
We examine the effect of different sources of technical noise on inverse weak value-based precision phase measurements. We find that this type of measurement is similarly robust to technical noise as related experiments in the weak value regime. In p
articular, the measurements considered here are robust to additive Gaussian white noise and angular jitter noise commonly encountered in optical experiments. Additionally, we show the same techniques used for precision phase measurement can be used with the same technical advantages for optical frequency measurements.
Large weak values have been used to amplify the sensitivity of a linear response signal for detecting changes in a small parameter, which has also enabled a simple method for precise parameter estimation. However, producing a large weak value require
s a low postselection probability for an ancilla degree of freedom, which limits the utility of the technique. We propose an improvement to this method that uses entanglement to increase the efficiency. We show that by entangling and postselecting $n$ ancillas, the postselection probability can be increased by a factor of $n$ while keeping the weak value fixed (compared to $n$ uncorrelated attempts with one ancilla), which is the optimal scaling with $n$ that is expected from quantum metrology. Furthermore, we show the surprising result that the quantum Fisher information about the detected parameter can be almost entirely preserved in the postselected state, which allows the sensitive estimation to approximately saturate the optimal quantum Cram{e}r-Rao bound. To illustrate this protocol we provide simple quantum circuits that can be implemented using current experimental realizations of three entangled qubits.
We improve the precision of the interferometric weak-value-based beam deflection measurement by introducing a power recycling mirror, creating a resonant cavity. This results in emph{all} the light exiting to the detector with a large deflection, thu
s eliminating the inefficiency of the rare postselection. The signal-to-noise ratio of the deflection is itself magnified by the weak value. We discuss ways to realize this proposal, using a transverse beam filter and different cavity designs.
The quantum singular value transformation is a powerful quantum algorithm that allows one to apply a polynomial transformation to the singular values of a matrix that is embedded as a block of a unitary transformation. This paper shows how to perform
the quantum singular value transformation for a matrix that can be embedded as a block of a Hamiltonian. The transformation can be implemented in a purely Hamiltonian context by the alternating application of Hamiltonians for chosen intervals: it is an example of the Quantum Alternating Operator Ansatz (generalized QAOA). We also show how to use the Hamiltonian quantum singular value transformation to perform inverse block encoding to implement a unitary of which a given Hamiltonian is a block. Inverse block encoding leads to novel procedures for matrix multiplication and for solving differential equations on quantum information processors in a purely Hamiltonian fashion.
We present a complex probability measure relevant for double (pairs of) states in quantum mechanics, as an extension of the standard probability measure for single states that underlies Borns statistical rule. When the double states are treated as th
e initial and final states of a quantum process, we find that Aharonovs weak value, which has acquired a renewed interest as a novel observable quantity inherent in the process, arises as an expectation value associated with the probability measure. Despite being complex, our measure admits the physical interpretation as mixed processes, i.e., an ensemble of processes superposed with classical probabilities.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
