اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدA normal metal tunnel-junction heat diode
133
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We propose a low-temperature thermal rectifier consisting of a chain of three tunnel-coupled normal metal electrodes. We show that a large heat rectification is achievable if the thermal symmetry of the structure is broken and the central island can release energy to the phonon bath. The performance of the device is theoretically analyzed and, under the appropriate conditions, temperature differences up to $sim$ 200 mK between the forward and reverse thermal bias configurations are obtained below 1 K, corresponding to a rectification ratio $mathcal{R} sim$ 2000. The simplicity intrinsic to its design joined with the insensitivity to magnetic fields make our device potentially attractive as a fundamental building block in solid-state thermal nanocircuits and in general-purpose cryogenic electronic applications requiring energy management.
قيم البحث
اقرأ أيضاً
A superconductor subject to electromagnetic irradiation in the terahertz range can show amplitude oscillations of its order parameter. However, coupling this so-called Higgs mode to the charge current is notoriously difficult. We propose to achieve s
uch a coupling in a particle-hole-asymmetric configuration using a DC-voltage-biased normal-metal--superconductor tunnel junction. Using the quasiclassical Greens function formalism, we demonstrate three characteristic signatures of the Higgs mode: (i) The AC charge current exhibits a pronounced resonant behavior and is maximal when the radiation frequency coincides with the order parameter. (ii) The AC charge current amplitude exhibits a characteristic nonmonotonic behavior with increasing voltage bias. (iii) At resonance for large voltage bias, the AC current vanishes inversely proportional to the bias. These signatures provide an electric detection scheme for the Higgs mode.
We present evidence for the cooling of normal metal phonons by electron tunneling in a Superconductor - Normal metal - Superconductor tunnel junction. The normal metal electron temperature is extracted by comparing the device current-voltage characte
ristics to the theoretical prediction. We use a quantitative model for the phonon cooling that includes the electron-phonon coupling in the normal metal and the Kapitza resistance between the substrate and the metal. It gives an excellent fit to the data and enables us to extract an effective phonon temperature in the normal metal.
We report the realization of an ultra-efficient low-temperature hybrid heat current rectifier, thermal counterpart of the well-known electric diode. Our design is based on a tunnel junction between two different elements: a normal metal and a superco
nducting island. Electronic heat current asymmetry in the structure arises from large mismatch between the thermal properties of these two. We demonstrate experimentally temperature differences exceeding $60$ mK between the forward and reverse thermal bias configurations. Our device offers a remarkably large heat rectification ratio up to $sim 140$ and allows its prompt implementation in true solid-state thermal nanocircuits and general-purpose electronic applications requiring energy harvesting or thermal management and isolation at the nanoscale.
We investigate electron cooling based on a clean normal-metal/spin-filter/superconductor junction. Due to the suppression of the Andreev reflection by the spin-filter effect, the cooling power of the system is found to be extremely higher than that f
or conventional normal-metal/nonmagnetic-insulator/superconductor coolers. Therefore we can extract large amount of heat from normal metals. Our results strongly indicate the practical usefulness of the spin-filter effect for cooling detectors, sensors, and quantum bits.
We consider a voltage-biased Normal metal-Insulator-Superconductor (NIS) tunnel junction, connected to a high-temperature external electromagnetic environment. This model system features the commonly observed subgap leakage current in NIS junctions t
hrough photon-assisted tunneling which is detrimental for applications. We first consider a NIS junction directly coupled to the environment and analyze the subgap leakage current both analytically and numerically; we discuss the link with the phenomenological Dynes parameter. Then we focus on a circuit where a low-temperature lossy transmission line is inserted between the NIS junction and the environment. We show that the subgap leakage current is exponentially suppressed as the length, $ell$, and the resistance per unit length, $R_0$, of the line are increased. We finally discuss our results in view of the performance of NIS junctions in applications.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
