اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدProbing hot electron transport across an epitaxial Schottky interface of SrRuO3/Nb:SrTiO3
219
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
SrRuO3 (SRO), a conducting transition metal oxide, is commonly used for engineering domains in BiFeO3. New oxide devices can be envisioned by integrating SRO with an oxide semiconductor as Nb doped SrTiO3 (Nb:STO). Using a three-terminal device configuration, we study vertical transport in a SRO/Nb:STO device at the nanoscale and find local differences in transport, that originate due to the high selectivity of SRO growth on the underlying surface terminations in Nb:STO. This causes a change in the interface energy band characteristics and is explained by the differences in the spatial distribution of the interface-dipoles at the local Schottky interface.
قيم البحث
اقرأ أيضاً
Hot electron transport of direct and scattered carriers across an epitaxial NiSi_2/n-Si(111) interface, for different NiSi_2 thickness, is studied using Ballistic Electron Emission Microscopy (BEEM). We find the BEEM transmission for the scattered ho
t electrons in NiSi_2 to be significantly lower than that for the direct hot electrons, for all thicknesses. Interestingly, the attenuation length of the scattered hot electrons is found to be twice larger than that of the direct hot electrons. The lower BEEM transmission for the scattered hot electrons is due to inelastic scattering of the injected hot holes while the larger attenuation length of the scattered hot electrons is a consequence of the differences in the energy distribution of the injected and scattered hot electrons and the increasing attenuation length, at lower energies, of the direct hot electrons in NiSi_2.
La0.9Ba0.1MnO3 is a ferromagnetic insulator in its bulk form, but exhibits metallicity in thin film form. It has a wide potential in a range of spintronic-related applications, and hence it is critical to understand thickness-dependent electronic str
ucture in thin films as well as substrate/film interface effects. Here, using electrical and in-situ photoemission spectroscopy measurements, we report the electronic structure and interface band profile of high-quality layer-by-layer-grown La0.9Ba0.1MnO3 on single crystal Nb:SrTiO3 substrates. A transition from insulating-to-conducting was observed with increasing La0.9Ba0.1MnO3 thickness, which was explained by the determined interface band diagram of La0.9Ba0.1MnO3/Nb: SrTiO3, where a type II heterojunction was formed.
We observed a strong modulation in the current-voltage characteristics of SrRuO$_3$/Nb:SrTiO$_3$ Schottky junctions by Mn substitution in SrRuO$_3$, which induces a metal-insulator transition in bulk. The temperature dependence of the junction ideali
ty factor indicates an increased spatial inhomogeneity of the interface potential with substitution. Furthermore, negative differential resistance was observed at low temperatures, indicating the formation of a resonant state by Mn substitution. By spatially varying the position of the Mn dopants across the interface with single unit cell control, we can isolate the origin of this resonant state to the interface SrRuO$_3$ layer. These results demonstrate a conceptually different approach to controlling interface states by utilizing the highly sensitive response of conducting perovskites to impurities.
We have observed temperature-dependent reversal of the rectifying polarity in Au/Nb:SrTiO3 Schottky junctions. By simulating current-voltage characteristics we have found that the permittivity of SrTiO3 near the interface exhibits temperature depende
nce opposite to that observed in the bulk, significantly reducing the barrier width. At low temperature, tunneling current dominates the junction transport due both to such barrier narrowing and to suppressed thermal excitations. The present results demonstrate that novel junction properties can be induced by the interface permittivity.
The hot-electron attenuation length in Ni is measured as a function of energy across two different Schottky interfaces viz. a polycrystalline Si(111)/Au and an epitaxial Si(111)/NiSi_2 interface using ballistic electron emission microscopy (BEEM). Fo
r similarly prepared Si(111) substrates and identical Ni thickness, the BEEM transmission is found to be lower for the polycrystalline interface than for the epitaxial interface. However, in both cases, the hot-electron attenuation length in Ni is found to be the same. This is elucidated by the temperature-independent inelastic scattering, transmission probabilities across the Schottky interface, and scattering at dissimilar interfaces.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
