اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدLayer-by-layer entangled spin-orbital texture of the topological surface state in Bi2Se3
158
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We study Bi2Se3 by polarization-dependent angle-resolved photoemission spectroscopy (ARPES) and density-functional theory slab calculations. We find that the surface state Dirac fermions are characterized by a layer-dependent entangled spin-orbital texture, which becomes apparent through quantum interference effects. This explains the discrepancy between the spin polarization from spin-resovled ARPES - ranging from 20 to 85% - and the 100% value assumed in phenomenological models. It also suggests a way to probe the intrinsic spin texture of topological insulators, and to continuously manipulate the spin polarization of photoelectrons and photocurrents all the way from 0 to +/-100% by an appropriate choice of photon energy, linear polarization, and angle of incidence.
قيم البحث
اقرأ أيضاً
We study the manipulation of the photoelectron spin-polarization in Bi$_2$Se$_3$ by spin- and angle-resolved photoemission spectroscopy. General rules are established that enable controlling the spin-polarization of photoemitted electrons via light p
olarization, sample orientation, and photon energy. We demonstrate the $pm$100% reversal of a single component of the measured spin-polarization vector upon the rotation of light polarization, as well as a full three-dimensional manipulation by varying experimental configuration and photon energy. While a material-specific density-functional theory analysis is needed for the quantitative description, a minimal two-atomic-layer model qualitatively accounts for the spin response based on the interplay of optical selection rules, photoelectron interference, and topological surface-state complex structure. It follows that photoelectron spin-polarization control is generically achievable in systems with a layer-dependent, entangled spin-orbital texture.
Topological insulators are novel macroscopic quantum-mechanical phase of matter, which hold promise for realizing some of the most exotic particles in physics as well as application towards spintronics and quantum computation. In all the known topolo
gical insulators, strong spin-orbit coupling is critical for the generation of the protected massless surface states. Consequently, a complete description of the Dirac state should include both the spin and orbital (spatial) parts of the wavefunction. For the family of materials with a single Dirac cone, theories and experiments agree qualitatively, showing the topological state has a chiral spin texture that changes handedness across the Dirac point (DP), but they differ quantitatively on how the spin is polarized. Limited existing theoretical ideas predict chiral local orbital angular momentum on the two sides of the DP. However, there have been neither direct measurements nor calculations identifying the global symmetry of the spatial wavefunction. Here we present the first results from angle-resolved photoemission experiment and first-principles calculation that both show, counter to current predictions, the in-plane orbital wavefunctions for the surface states of Bi2Se3 are asymmetric relative to the DP, switching from being tangential to the k-space constant energy surfaces above DP, to being radial to them below the DP. Because the orbital texture switch occurs exactly at the DP this effect should be intrinsic to the topological physics, constituting an essential yet missing aspect in the description of the topological Dirac state. Our results also indicate that the spin texture may be more complex than previously reported, helping to reconcile earlier conflicting spin resolved measurements.
We present magnetic stray field measurements performed on a single micro-crystal of the half metallic ferromagnet CrO$_2$, covered by a naturally grown 2,-,5,nm surface layer of antiferromagnetic (AFM) Cr$_2$O$_3$. The temperature variation of the st
ray field of the micro-crystal measured by micro-Hall magnetometry shows an anomalous increase below $sim$,60,K. We find clear evidence that this behavior is due to the influence of the AFM surface layer, which could not be isolated in the corresponding bulk magnetization data measured using SQUID magnetometry. The distribution of pinning potentials, analyzed from Barkhausen jumps, exhibits a similar temperature dependence. Overall, the results indicate that the surface layer plays a role in defining the potential landscape seen by the domain configuration in the ferromagnetic grain.
We investigate the spin-current transport through antiferromagnetic insulator (AFMI) by means of the spin-Hall magnetoressitance (SMR) over a wide temperature range in Pt/NiO/Y$_3$Fe$_5$O$_{12}$ (Pt/NiO/YIG) heterostructures. By inserting the AFMI Ni
O layer, the SMR dramatically decreases by decreasing the temperature down to the antiferromagnetically ordered state of NiO, which implies that the AFM order prevents rather than promotes the spin-current transport. On the other hand, the magnetic proximity effect (MPE) on induced Pt moments by YIG, which entangles with the spin-Hall effect (SHE) in Pt, can be efficiently screened, and pure SMR can be derived by insertion of NiO. The dual roles of the NiO insertion including efficiently blocking the MPE and transporting the spin current from Pt to YIG are outstanding compared with other antiferromagnetic (AFM) metal or nonmagnetic metal (NM).
Bi2Se3 is a topological insulator with metallic surface states residing in a large bulk bandgap. It is believed that Bi2Se3 gets additional n-type doping after exposure to atmosphere, thereby reducing the relative contribution of surface states in to
tal conductivity. In this letter, transport measurements on Bi2Se3 nanoribbons provide additional evidence of such environmental doping process. Systematic surface composition analyses by X-ray photoelectron spectroscopy reveal fast formation and continuous growth of native oxide on Bi2Se3 under ambient conditions. In addition to n-type doping at the surface, such surface oxidation is likely the material origin of the degradation of topological surface states. Appropriate surface passivation or encapsulation may be required to probe topological surface states of Bi2Se3 by transport measurements.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
