اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدRelocation of the topological surface state of Bi$_{2}$Se$_{3}$ beneath the surface by Ag intercalation
163
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We studied the Ag-intercalated 3D topological insulator Bi$_{2}$Se$_{3}$ by scanning tunneling microscopy/spectroscopy and angle-resolved photoemission spectroscopy, combined with a first principles calculations. We demonstrate that silver atoms deposited on the surface of Bi$_{2}$Se$_{3}$ are intercalated between the quintuple layer (QL) units of the crystal, causing a expansion of the van der Waals gaps and the detachment of topmost QLs from the bulk crystal. This leads to a relocation (in the real space) of the the topological state beneath the detached quintuple layers, accompanied by the emergence of parabolic and M-shaped trivial bands localized above the relocated topological states. These novel findings open a pathway to the engineering of Dirac fermions shielded from the ambient contamination and may facilitate the realization of fault-tolerant quantum devices.
قيم البحث
اقرأ أيضاً
Transport and torque magnetometry measurements are performed at high magnetic fields and low temperatures in a series of p-type (Ca-doped) Bi$_{2}$Se$_{3}$ crystals. The angular dependence of the Shubnikov-de Haas and de Haas-van Alphen quantum oscil
lations enables us to determine the Fermi surface of the bulk valence band states as a function of the carrier density. At low density, the angular dependence exhibits a downturn in the oscillations frequency between $0^circ$ and $90^circ$, reflecting a bag-shaped hole Fermi surface. The detection of a single frequency for all tilt angles rules out the existence of a Fermi surface with different extremal cross-sections down to $24$~meV. There is therefore no signature of a camel-back in the valence band of our bulk samples, in accordance with the direct band gap predicted by $GW$ calculations.
We have performed scanning tunneling microscopy and differential tunneling conductance ($dI/dV$) mapping for the surface of the three dimensional topological insulator Bi$_{2}$Se$_{3}$. The fast Fourier transformation applied to the $dI/dV$ image sho
ws an electron interference pattern near Dirac node despite the general belief that the backscattering is well suppressed in the bulk energy gap region. The comparison of the present experimental result with theoretical surface and bulk band structures shows that the electron interference occurs through the scattering between the surface states near the Dirac node and the bulk continuum states.
We study the fate of the surface states of Bi$_2$Se$_3$ under disorder with strength larger than the bulk gap, caused by neon sputtering and nonmagnetic adsorbates. We find that neon sputtering introduces strong but dilute defects, which can be model
ed by a unitary impurity distribution, whereas adsorbates, such as water vapor or carbon monoxide, are best described by Gaussian disorder. Remarkably, these two disorder types have a dramatically different effect on the surface states. Our soft x-ray ARPES measurements combined with numerical simulations show that unitary surface disorder pushes the Dirac state to inward quintuplet layers, burying it below an insulating surface layer. As a consequence, the surface spectral function becomes weaker, but retains its quasiparticle peak. This is in contrast to Gaussian disorder, which smears out the quasiparticle peak completely. At the surface of Bi$_2$Se$_3$, the effects of Gaussian disorder can be reduced by removing surface adsorbates using neon sputtering, which, however, introduces unitary scatterers. Since unitary disorder has a weaker effect than Gaussian disorder, the ARPES signal of the Dirac surface state becomes sharper upon sputtering.
Rubidium adsorption on the surface of the topological insulator Bi$_2$Se$_3$ is found to induce a strong downward band bending, leading to the appearance of a quantum-confined two dimensional electron gas states (2DEGs) in the conduction band. The 2D
EGs shows a strong Rashba-type spin-orbit splitting, and it has previously been pointed out that this has relevance to nano-scale spintronics devices. The adsorption of Rb atoms, on the other hand, renders the surface very reactive and exposure to oxygen leads to a rapid degrading of the 2DEGs. We show that intercalating the Rb atoms, presumably into the van der Waals gaps in the quintuple layer structure of Bi$_2$Se$_3$, drastically reduces the surface reactivity while not affecting the promising electronic structure. The intercalation process is observed above room temperature and accelerated with increasing initial Rb coverage, an effect that is ascribed to the Coulomb interaction between the charged Rb ions. Coulomb repulsion is also thought to be responsible for a uniform distribution of Rb on the surface.
Crystalline symmetries have played a central role in the identification of topological materials. The use of symmetry indicators and band representations have enabled a classification scheme for crystalline topological materials, leading to large sca
le topological materials discovery. In this work we address whether amorphous topological materials, which lie beyond this classification due to the lack of long-range structural order, exist in the solid state. We study amorphous Bi$_2$Se$_3$ thin films, which show a metallic behavior and an increased bulk resistance. The observed low field magnetoresistance due to weak antilocalization demonstrates a significant number of two dimensional surface conduction channels. Our angle-resolved photoemission spectroscopy data is consistent with a dispersive two-dimensional surface state that crosses the bulk gap. Spin resolved photoemission spectroscopy shows this state has an anti-symmetric spin texture resembling that of the surface state of crystalline Bi$_2$Se$_3$. These experimental results are consistent with theoretical photoemission spectra obtained with an amorphous tight-binding model that utilizes a realistic amorphous structure. This discovery of amorphous materials with topological properties uncovers an overlooked subset of topological matter outside the current classification scheme, enabling a new route to discover materials that can enhance the development of scalable topological devices.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
