اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدOn symmetries of elasticity tensors and Christoffel matrices
153
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We prove that the symmetry group of an elasticity tensor is equal to the symmetry group of the corresponding Christoffel matrix.
قيم البحث
اقرأ أيضاً
A new method is presented for finding Killing tensors in spacetimes with symmetries. The method is used to find all the Killing tensors of Melvins magnetic universe and the Schwarzschild vacuum. We show that they are all trivial. The method requires
less computation than solving the full Killing tensor equations directly, and it can be used even when the spacetime is not algebraically special.
In this paper, we establish two sufficient conditions for the strong ellipticity of any fourth-order elasticity tensor and investigate a class of tensors satisfying the strong ellipticity condition, the elasticity $mathscr{M}$-tensor. The first suffi
cient condition is that the strong ellipticity holds if the unfolding matrix of this fourth-order elasticity tensor can be modified into a positive definite one by preserving the summations of some corresponding entries. Second, an alternating projection algorithm is proposed to verify whether an elasticity tensor satisfies the first condition or not. Besides, the elasticity $mathscr{M}$-tensor is defined with respect to the M-eigenvalues of elasticity tensors. We prove that any nonsingular elasticity $mathscr{M}$-tensor satisfies the strong ellipticity condition by employing a Perron-Frobenius-type theorem for M-spectral radii of nonnegative elasticity tensors. Other equivalent definitions of nonsingular elasticity $mathscr{M}$-tensors are also established.
We discuss several physical constraints imposed on elasticity parameters of a transversely isotropic (TI) tensor. There are three types of restrictions we investigate; a fundamental one of stability conditions, and two additional ones, commonly consi
dered in seismology. The first commonly considered restriction comes from an assumption of a wave with a greater speed in the horizontal than vertical direction. The second constitute the assumption that quasi-P wave is faster than quasi-S waves. We show several numerical examples to examine how these restrictions affect a TI tensor with known values of certain elasticity constants that could be acquired from the vertical or horizontal measurements.
We use the Discrete Element Method (DEM) to understand the underlying attenuation mechanism in granular media, with special applicability to the measurements of the so-called effective mass developed earlier. We consider that the particles interact v
ia Hertz-Mindlin elastic contact forces and that the damping is describable as a force proportional to the velocity difference of contacting grains. We determine the behavior of the complex-valued normal mode frequencies using 1) DEM, 2) direct diagonalization of the relevant matrix, and 3) a numerical search for the zeros of the relevant determinant. All three methods are in strong agreement with each other. The real and the imaginary parts of each normal mode frequency characterize the elastic and the dissipative properties, respectively, of the granular medium. We demonstrate that, as the interparticle damping, $xi$, increases, the normal modes exhibit nearly circular trajectories in the complex frequency plane and that for a given value of $xi$ they all lie on or near a circle of radius $R$ centered on the point $-iR$ in the complex plane, where $Rpropto 1/xi$. We show that each normal mode becomes critically damped at a value of the damping parameter $xi approx 1/omega_n^0$, where $omega_n^0$ is the (real-valued) frequency when there is no damping. The strong indication is that these conclusions carry over to the properties of real granular media whose dissipation is dominated by the relative motion of contacting grains. For example, compressional or shear waves in unconsolidated dry sediments can be expected to become overdamped beyond a critical frequency, depending upon the strength of the intergranular damping constant.
We consider an alternative way of obtaining the effective elastic properties of a cracked medium. Similarly, to the popular linear-slip model, we assume flat, parallel fractures, and long wavelengths. However, we do not treat fractures as weakness pl
anes of displacement discontinuity. In contrast to the classical models, we represent fractures by a thin layer embedded in the background medium. In other words, we follow the Schoenberg-Douma matrix formalism for Backus averaging, but we relax their assumptions of infinite weakness and marginal thickness of a layer so that it does not correspond to the linear-slip plane. To represent the properties of a fracture, we need a fourth order elasticity tensor and a thickness parameter. The effective tensor becomes more complicated, but it may describe a higher concentration of parallel cracks more accurately. Apart from the derivations of the effective elasticity tensors, we perform numerical experiments in which we compare the performance of our approach with a linear-slip model in the context of highly fractured media. Our model becomes pertinent if filled-in cracks occupy more than one percent of the effective medium.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
