اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدDirect-write, focused ion beam-deposited,7 K superconducting C-Ga-O nanowire
662
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We have fabricated C-Ga-O nanowires by gallium focused ion beam-induced deposition from the carbon-based precursor phenanthrene. The electrical conductivity of the nanowires is weakly temperature dependent below 300 K, and indicates a transition to a superconducting state below Tc = 7 K. We have measured the temperature dependence of the upper critical field Hc2(T), and estimate a zero temperature critical field of 8.8 T. The Tc of this material is approximately 40% higher than that of any other direct write nanowire, such as those based on C-W-Ga, expanding the possibility of fabricating direct-write nanostructures that superconduct above liquid helium temperatures
قيم البحث
اقرأ أيضاً
In a recent paper Tettamanzi et al (2009 Nanotechnology bf{20} 465302) describe the fabrication of superconducting Nb nanowires using a focused ion beam. They interpret their conductivity data in the framework of thermal and quantum phase slips below
$T_c$. In the following we will argue that their analysis is inappropriate and incomplete, leading to contradictory results. Instead, we propose an interpretation of the data within a SN proximity model.
Recent advances in focused ion beam technology have enabled high-resolution, direct-write nanofabrication using light ions. Studies with light ions to date have, however, focused on milling of materials where sub-surface ion beam damage does not inhi
bit device performance. Here we report on direct-write milling of single crystal diamond using a focused beam of oxygen ions. Material quality is assessed by Raman and luminescence analysis, and reveals that the damage layer generated by oxygen ions can be removed by nonintrusive post-processing methods such as localised electron beam induced chemical etching.
We present low-temperature measurements of low-loss superconducting nanowire-embedded resonators in the low-power limit relevant for quantum circuits. The superconducting resonators are embedded with superconducting nanowires with widths down to 20nm
using a neon focused ion beam. In the low-power limit, we demonstrate an internal quality factor up to 3.9x10^5 at 300mK [implying a two-level-system-limited quality factor up to 2x10^5 at 10 mK], not only significantly higher than in similar devices but also matching the state of the art of conventional Josephson-junction-embedded resonators. We also show a high sensitivity of the nanowire to stray infrared photons, which is controllable by suitable precautions to minimize stray photons in the sample environment. Our results suggest that there are excellent prospects for superconducting-nanowire-based quantum circuits.
Making use of focused Ga-ion beam (FIB) fabrication technology, the evolution with device dimension of the low-temperature electrical properties of Nb nanowires has been examined in a regime where crossover from Josephson-like to insulating behaviour
is evident. Resistance-temperature data for devices with a physical width of order 100 nm demonstrate suppression of superconductivity, leading to dissipative behaviour that is shown to be consistent with the activation of phase-slip below Tc. This study suggests that by exploiting the Ga-impurity poisoning introduced by the FIB into the periphery of the nanowire, a central superconducting phase-slip nanowire with sub-10 nm dimensions may be engineered within the core of the nanowire.
A direct patterning technique of gallium-irradiated superconducting silicon has been established by focused gallium-ion beam without any mask-based lithography process. The electrical transport measurements for line and square shaped patterns of gall
ium-irradiated silicon were carried out under self-field and magnetic field up to 7 T. Sharp superconducting transitions were observed in both patterns at temperature of 7 K. The line pattern exhibited a signature of higher onset temperature above 10 K. A critical dose amount to obtain the superconducting gallium-irradiated silicon was investigated by the fabrication of various samples with different doses. This technique can be used as a simple fabrication method for superconducting device.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
