اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدNanopatterning of Si surfaces by normal incident ion erosion: influence of metal incorporation on surface morphology evolution
131
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
The morphology evolution of Si (100) surfaces under 1200 eV Ar+ ion bombardment at normal incidence with and without metal incorporation is presented. The formation of nanodot patterns is observed only when the stationary Fe concentration in the surface is above 8x10^14 cm^-2. This is interpreted in terms of an additional surface instability due to non-uniform sputtering in connection with metal enrichment at the nanodots. At low metal concentration smoothing dominates and pattern formation is thus inhibited. The transition from a k^-2 to a k^-4 behavior in the asymptotic power spectral density function supports the conclusion that ballistic smoothing and ion-enhanced viscous flow are the two dominant mechanisms of surface relaxation.
قيم البحث
اقرأ أيضاً
We use first-principles methods to investigate the adsorption of Cu, Pb, Ag, and Mg onto a H-terminated Si surface. We show that Cu and Pb can adsorb strongly while Ag and Mg are fairly inert. In addition, two types of adsorption states are seen to e
xist for Pb. We also study the clustering energetics of Cu and Pb on the surface and find that while Cu clusters eagerly, Pb may prefer to form only small clusters of a few atoms. This kind of behavior of impurities is incorporated in kinetic Monte Carlo simulations of wet etching of Si. The simulation results agree with experiments supporting the idea that micromasking by Cu clusters and Pb atoms is the mechanism through which these impurities affect the etching process.
Electron-hole pair creation by an adsorbate incident on a metal surface is described using textit{ab initio} methods. The approach starts with standard first principles electronic structure theory, and proceeds to combine classical, quantum oscillato
r and time dependent density functional methods to provide a consistent description of the non-adiabatic energy transfer from adsorbate to substrate. Of particular interest is the conservation of the total energy at each level of approximation, and the importance of a spin transition as a function of the adsorbate/surface separation. Results are presented and discussed for H and D atoms incident on the Cu(111) surface.
After the early suggestion by John Pendry to probe unoccupied bands at surfaces through the time reversal of the photoemission process, the inverse-photoemission technique yielded the first conclusive experimental evidence for the existence of image-
potential bound states at metal surfaces and has led over the last two decades to an active area of research in condensed-matter and surface physics. Here we describe the current status of the many-body theory of inelastic lifetimes of these image-potential states and also the Shockley surface states that exist near the Fermi level in the projected bulk band gap of simple and noble metals. New calculations of the self-energy and lifetime of surface states on Au surfaces are presented as well, by using the $GWGamma$ approximation of many-body theory.
We implement substrate rotation in a 2+1 dimensional solid-on-solid model of ion beam sputtering of solid surfaces. With this extension of the model, we study the effect of concurrent rotation, as the surface is sputtered, on possible topographic reg
ions of surface patterns. In particular we perform a detailed numerical analysis of the time evolution of dots obtained from our Monte Carlo simulations at off-normal-incidence sputter erosion. We found the same power-law scaling exponents of the dot characteristics for two different sets of ion-material combinations, without and with substrate rotation.
We present magnetic stray field measurements performed on a single micro-crystal of the half metallic ferromagnet CrO$_2$, covered by a naturally grown 2,-,5,nm surface layer of antiferromagnetic (AFM) Cr$_2$O$_3$. The temperature variation of the st
ray field of the micro-crystal measured by micro-Hall magnetometry shows an anomalous increase below $sim$,60,K. We find clear evidence that this behavior is due to the influence of the AFM surface layer, which could not be isolated in the corresponding bulk magnetization data measured using SQUID magnetometry. The distribution of pinning potentials, analyzed from Barkhausen jumps, exhibits a similar temperature dependence. Overall, the results indicate that the surface layer plays a role in defining the potential landscape seen by the domain configuration in the ferromagnetic grain.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
