اشترك بالحزمة الذهبية واحصل على وصول غير محدود شمرا أكاديميا
تسجيل مستخدم جديدVariation of the primary and reprocessed radiation in the flare-spot model
150
0
0.0
(
0
)
اسأل ChatGPT حول البحث
ﻻ يوجد ملخص باللغة العربية
We study light curves and spectra (equivalent widths of the iron line and some other spectral characteristics) which arise by reprocessing on the surface of an accretion disc, following its illumination by a primary off-axis source - an X-ray flare, assumed to be a point-like source just above the accretion disc. We consider all general relativity effects (energy shifts, light bending, time delays, delay amplification due to the spot motion) near a rotating black hole. For some sets of parameters the reflected flux exceeds the flux from the primary component. We show that the orbit-induced variations of the equivalent width with respect to its mean value can be as high as 30% for an observers inclination of 30 degrees, and much more at higher inclinations. We calculate the ratio of the reflected flux to the primary flux and the hardness ratio which we find to vary significantly with the spot phase mainly for small orbital radii. This offers the chance to estimate the lower limit of the black hole spin if the flare arises close to the black hole. We show the results for different values of the flare orbital radius.
قيم البحث
اقرأ أيضاً
We study light curves and spectra (equivalent widths of the iron line and some other spectral characteristics) which arise by reflection on the surface of an accretion disc, following its illumination by a primary off-axis source - an X-ray flare, as
sumed to be a point-like source just above the accretion disc resulting in a spot with radius dr/r<1. We consider General Relativity effects (energy shifts, light bending, time delays) near a rotating black hole, and we find them all important, including the light bending and delay amplification due to the spot motion. For some sets of parameters the reflected flux exceeds the flux from the primary component. We show that the orbit-induced variations of the equivalent width with respect to its mean value can be as high as 30% for the observers inclination of 30 degrees, and much more at higher inclinations. We calculate the ratio of the reflected flux to the primary flux and the hardness ratio which we find to vary significantly with the spot phase mainly for small orbital radii. This offers the chance to estimate the lower limit of the black hole spin if the flare arises close to the black hole.
We discuss a model of X-ray variability of active galactic nuclei (AGN). We consider multiple spots which originate on the surface of an accretion disk following intense irradiation by coronal flares. The spots move with the disk around the central b
lack hole and eventually decay while new spots continuously emerge. We construct time sequences of the spectra of the spotted disk and compute the corresponding energy-dependent fractional variability amplitude. We explore the dependence on the disk inclination and other model parameters. AGN seen at higher inclination with respect to the observer, such as Seyfert 2 galaxies, are expected to have fractional variability amplitude of the direct emission by a factor of a few higher than objects seen face on, such as the Seyfert 1s.
We provide the first in situ measurements of antenna element (tile) beam shapes of the Murchison Widefield Array (MWA), a low radio-frequency interferometer and an SKA precursor. Most current MWA processing pipelines use an assumed beam shape, errors
in which can cause absolute and relative flux density errors, as well as polarisation leakage. This makes understanding the primary beam of paramount importance, especially for sensitive experiments such as a measurement of the 21 cm line from the epoch of reionisation (EoR). The calibration requirements for measuring the EoR 21 cm line are so extreme that tile to tile beam variations may affect our ability to make a detection. Measuring the primary beam shape from visibilities alone is challenging, as multiple instrumental, atmospheric, and astrophysical factors contribute to uncertainties in the data. Building on the methods of Neben et al. (2015), we tap directly into the receiving elements of the MWA before any digitisation or correlation of the signal. Using ORBCOMM satellite passes we are able to produce all-sky maps for 4 separate tiles in the XX polarisation. We find good agreement with the cutting-edge fully embedded element (FEE) model of Sokolowski et al. (2017), and observe that the MWA beamformers consistently recreate beam shapes to within ~1dB in the reliable areas of our beam maps. We also clearly observe the effects of a missing dipole from a tile in one of our beam maps, and show that the FEE model is able to reproduce this modified beam shape. We end by motivating and outlining additional onsite experiments to further constrain the primary beam behaviour.
In this work the latitude dependent stellar spot rotation is investigated based on dynamo models. The maps of the magnetic pressure at the surface from the dynamo calculations are treated similarly to the temperature maps obtained using Doppler imagi
ng techniques. A series of snapshots from the dynamo models are cross-correlated to obtain the shift of the magnetic patterns at each latitude and time point. The surface differential rotation patterns obtained from the snapshots of the dynamo calculations show in all studied cases variability over the activity cycle. In the models using only the large scale dynamo field the measured rotation patterns are only at times similar to the input rotation law. This is due to the spot motion being mainly determined by the geometric properties of the large scale dynamo field. In the models with additional small scale magnetic field the surface differential rotation measured from the model follows well the input rotation law. The results imply that the stellar spots caused by the large scale dynamo field are not necessarily tracing the stellar differential rotation, whereas the spots formed from small scale fields trace well the surface flow patterns. It can be questioned whether the large spots observed in active stars could be caused by small scale fields. Therefore, it is not clear that the true stellar surface rotation can be recovered using measurements of large starspots, which are currently the only ones that can be observed.
OJ287 is a quasi-periodic quasar with roughly 12 year optical cycles. It displays prominent outbursts which are predictable in a binary black hole model. The model predicted a major optical outburst in December 2015. We found that the outburst did oc
cur within the expected time range, peaking on 2015 December 5 at magnitude 12.9 in the optical R-band. Based on Swift/XRT satellite measurements and optical polarization data, we find that it included a major thermal component. Its timing provides an accurate estimate for the spin of the primary black hole, chi = 0.313 +- 0.01. The present outburst also confirms the established general relativistic properties of the system such as the loss of orbital energy to gravitational radiation at the 2 % accuracy level and it opens up the possibility of testing the black hole no-hair theorem with a 10 % accuracy during the present decade.
سجل دخول لتتمكن من نشر تعليقات
التعليقات
جاري جلب التعليقات
سجل دخول لتتمكن من متابعة معايير البحث التي قمت باختيارها
