Experimental demonstration of PT-symmetric stripe lasers

Recently, the coexistence of parity-time (PT) symmetric laser and absorber has gained tremendous research attention. While the PT symmetric absorber has been observed in microwave metamaterials, the experimental demonstration of PT symmetric laser is still absent. Here we experimentally study PT-symmetric laser absorber in stripe waveguide. Using the concept of PT symmetry to exploit the light amplification and absorption, PT-symmetric laser absorbers have been successfully obtained. Different from the single-mode PT symmetric lasers, the PT-symmetric stripe lasers have been experimentally confirmed by comparing the relative wavelength positions and mode spacing under different pumping conditions. When the waveguide is half pumped, the mode spacing is doubled and the lasing wavelengths shift to the center of every two initial lasing modes. All these observations are consistent with the theoretical predictions and confirm the PT-symmetry breaking well.

End-fire injection of guided light into optical microcavity

Coupling light into microdisk plays a key role in a number of applications such as resonant filters and optical sensors. While several approaches have successfully coupled light into microdisk efficiently, most of them suffer from the ultrahigh sensitivity to the environmental vibration. Here we demonstrate a robust mechanism, which is termed as end-fire injection. By connecting an input waveguide to a circular microdisk directly, the mechanism shows that light can be efficiently coupled into optical microcavity. The coupling efficiency can be as high as 0.75 when the input signals are on resonances. Our numerical results reveal that the high coupling efficiency is attributed to the constructive interference between the whispering gallery modes and the input signals. We have also shown that the end-fire injection can be further extended to the long-lived resonances with low refractive index such as n = 1.45. We believe our results will shed light on the applications of optical microcavities.

Inversed Vernier effect based single-mode laser emission in coupled microdisks

Recently, on-chip single-mode laser emission has attracted considerable research attention due to its wide applications. While most of single-mode lasers in coupled microdisks or microrings have been qualitatively explained by either Vernier effect or inversed Vernier effect, none of them have been experimentally confirmed. Here, we studied the mechanism for single-mode operation in coupled microdisks. We found that the mode numbers had been significantly reduced to nearly single-mode within a large pumping power range from threshold to gain saturation. The detail laser spectra showed that the largest gain and the first lasing peak were mainly generated by one disk and the laser intensity was proportional to the frequency detuning. The corresponding theoretical analysis showed that the experimental observations were dominated by internal coupling within one cavity, which was similar to the recently explored inversed Vernier effect in two coupled microrings. We believe our finding will be important for understanding the previous experimental findings and the development of on-chip single-mode laser.

Quasi-guiding modes in microfibers on high refractive index substrate

Light confinement and amplification in micro- & nano-fiber have been intensively studied and a number of applications have been developed. However, the typical micro- & anno- fibers are usually free-standing or positioned on a substrate with lower refractive index to ensure the light confinement and guiding mode. Here we numerically and experimentally demonstrate the possibility of confining light within a microfiber on a high refractive index substrate. In contrast to the strong leaky to the substrate, we found that the radiation loss was dependent on the radius of microfiber and the refractive index contrast. Consequently, quasi-guiding modes could be formed and the light could propagate and be amplified in such systems. By fabricating tapered silica fiber and dye-doped polymer fiber and placing them on sapphire substrates, the light propagation, amplification, and laser behaviors have been experimentally studied to verify the quasi-guiding modes in microfer with higher index substrate. We believe that our research will be essential for the applications of micro- and nano-fibers.

Deformed Microcavity for Far Field Biosensing

Here we demonstrate a new concept for designing an ultra-sensitive deformed cavity biosensor. Owning to the breaking of rotational symmetry, the field distribution is not uniform along the cavity boundary and results in the dependence of spectra shift and mode splitting on the position of a scatter. In this case, the deformed cavity sensor can be extremely sensitive to the location of particle binding on the cavity boundary. Moreover, the directional emission from the deformed microcavity provides a possibility to detect a single particle or molecule in the far field.

Chaotic Microcavity Laser with Low threshold and Unidirectional Output

Here we report lasing action in limac{c}on-shaped GaAs microdisks with quantum dots (QDs) embedded. Although the intracavity ray dynamics is predominantly chaotic, high-$Q$ modes are concentrated in the region $chi > chi_c$ as a result of wave localization. Strong optical confinement by total internal reflection leads to very low lasing threshold. Our measurements show that all the lasing modes have output in the same direction, regardless of their wavelengths and intracavity mode structures. This universal emission direction is determined by directed phase space flow of optical rays in the open chaotic cavity. The divergence angle of output beam is less than 40 degree. The unidirectionality proves to be robust against small deviations of the real cavity shape and size from the designed values.

Near-IR Subwavelength Microdisk Lasers

We report single-mode lasing in subwavelength GaAs disks under optical pumping. The disks are fabricated by standard photolithography and two steps of wet chemical etching. The simple fabrication method can produce submicron disks with good circularity, smooth boundary and vertical sidewalls. The smallest lasing disks have a diameter of 627 nm and thickness of 265 nm. The ratio of the disk diameter to the vacuum lasing wavelength is about 0.7. Our numerical simulations confirm that the lasing modes are whispering-gallery modes with the azimuthal number as small as 4 and very small mode volume.