Self-consistent model of spin accumulation magnetoresistance in ferromagnet-insulator-semiconductor tunnel junctions

Spin accumulation in a paramagnetic semiconductor due to voltage-biased current tunneling from a polarized ferromagnet is experimentally manifest as a small additional spin-dependent resistance. We describe a rigorous model incorporating the necessary self-consistency between electrochemical potential splitting, spin-dependent injection current, and applied voltage that can be used to simulate this so-called 3T signal as a function of temperature, doping, ferromagnet bulk spin polarization, tunnel barrier features and conduction nonlinearity, and junction voltage bias.

Coherent spin transport through a 350-micron-thick Silicon wafer

We use all-electrical methods to inject, transport, and detect spin-polarized electrons vertically through a 350-micron-thick undoped single-crystal silicon wafer. Spin precession measurements in a perpendicular magnetic field at different accelerating electric fields reveal high spin coherence with at least 13pi precession angles. The magnetic-field spacing of precession extrema are used to determine the injector-to-detector electron transit time. These transit time values are associated with output magnetocurrent changes (from in-plane spin-valve measurements), which are proportional to final spin polarization. Fitting the results to a simple exponential spin-decay model yields a conduction electron spin lifetime (T1) lower bound in silicon of over 500ns at 60K.

Experimental realization of a silicon spin field-effect transistor

A longitudinal electric field is used to control the transit time (through an undoped silicon vertical channel) of spin-polarized electrons precessing in a perpendicular magnetic field. Since an applied voltage determines the final spin direction at the spin detector and hence the output collector current, this comprises a spin field-effect transistor. An improved hot-electron spin injector providing ~115% magnetocurrent, corresponding to at least ~38% electron current spin polarization after transport through 10 microns undoped single-crystal silicon, is used for maximum current modulation.

35% magnetocurrent with spin transport through Si

Efficient injection of spin-polarized electrons into the conduction band of silicon is limited by the formation of a silicide at the ferromagnetic metal (FM)/silicon interface. In the present work, this magnetically-dead silicide (where strong spin-scattering significantly reduces injected spin polarization) is eliminated by moving the FM in the spin injector from the tunnel junction base anode to the emitter cathode and away from the silicon surface. This results in over an order-of-magnitude increase in spin injection efficiency, from a previously-reported magnetocurrent ratio of ~2% to ~35% and an estimated spin polarization in Si from ~1% to at least ~15%. The injector tunnel-junction bias dependence of this spin transport signal is also measured, demonstrating the importance of low bias voltage to preserve high injected spin polarization.

Spin lifetime in silicon in the presence of parasitic electronic effects

A hybrid ferromagnet/semiconductor device is used to determine a lower bound on the spin lifetime for conduction electrons in silicon. We use spin precession to self-consistently measure the drift velocity vs. drift field of spin-polarized electrons and use this electronic control to change the transit time between electron injection and detection. A measurement of normalized magnetocurrent as a function of drift velocity is used with a simple exponential-decay model to argue that the lifetime obtained (~2 ns) is artificially lowered by electronic effects and is likely orders of magnitude higher.