Measurement of acoustic glitches in solar-type stars from oscillation frequencies observed by Kepler

For the very best and brightest asteroseismic solar-type targets observed by Kepler, the frequency precision is sufficient to determine the acoustic depths of the surface convective layer and the helium ionization zone. Such sharp features inside the acoustic cavity of the star, which we call acoustic glitches, create small oscillatory deviations from the uniform spacing of frequencies in a sequence of oscillation modes with the same spherical harmonic degree. We use these oscillatory signals to determine the acoustic locations of such features in 19 solar-type stars observed by the Kepler mission. Four independent groups of researchers utilized the oscillation frequencies themselves, the second differences of the frequencies and the ratio of the small and large separation to locate the base of the convection zone and the second helium ionization zone. Despite the significantly different methods of analysis, good agreement was found between the results of these four groups, barring a few cases. These results also agree reasonably well with the locations of these layers in representative models of the stars. These results firmly establish the presence of the oscillatory signals in the asteroseismic data and the viability of several techniques to determine the location of acoustic glitches inside stars.

Model-independent determination of sharp features inside a star from its oscillation frequencies

It has been established earlier that sharp features like the base of the convective zone or the second helium ionisation zone inside a star give rise to sinusoidal oscillations in the frequencies of pulsation. The acoustic depth of such features can be estimated from this oscillatory signal in the frequencies. We apply this technique for the CoRoT frequencies of the solar-type star HD49933. This is the first time that such analysis has been done of seismic data for any star other than the Sun. We are able to determine the acoustic depth of both the base of the convective zone and the HeII ionisation zone of HD49933 within 10% error from the second differences of the frequencies. The locations of these layers using this technique is in agreement with the current seismic models of HD49933.

Asteroseismology and interferometry of the red giant star epsilon Oph

The GIII red giant star epsilon Oph has been found to exhibit several modes of oscillation by the MOST mission. We interpret the observed frequencies of oscillation in terms of theoretical radial p-mode frequencies of stellar models. Evolutionary models of this star, in both shell H-burning and core He-burning phases of evolution, are constructed using as constraints a combination of measurements from classical ground-based observations (for luminosity, temperature, and chemical composition) and seismic observations from MOST. Radial frequencies of models in either evolutionary phase can reproduce the observed frequency spectrum of epsilon Oph almost equally well. The best-fit models indicate a mass in the range of 1.85 +/- 0.05 Msun with radius of 10.55 +/- 0.15 Rsun. We also obtain an independent estimate of the radius of epsilon Oph using high accuracy interferometric observations in the infrared K band, using the CHARA/FLUOR instrument. The measured limb darkened disk angular diameter of epsilon Oph is 2.961 +/- 0.007 mas. Together with the Hipparcos parallax, this translates into a photospheric radius of 10.39 +/- 0.07 Rsun. The radius obtained from the asteroseismic analysis matches the interferometric value quite closely even though the radius was not constrained during the modelling.