An alternative measure of x-ray absorption spectroscopy (XAS) called inverse partial fluorescence yield (IPFY) has recently been developed that is both bulk sensitive and free of saturation effects. Here we show that the angle dependence of IPFY can
provide a measure directly proportional to the total x-ray absorption coefficient, $mu(E)$. In contrast, fluorescence yield (FY) and electron yield (EY) spectra are offset and/or distorted from $mu(E)$ by an unknown and difficult to measure amount. Moreover, our measurement can determine $mu(E)$ in absolute units with no free parameters by scaling to $mu(E)$ at the non-resonant emission energy. We demonstrate this technique with measurements on NiO and NdGaO$_3$. Determining $mu(E)$ across edge-steps enables the use of XAS as a non-destructive measure of material composition. In NdGaO$_3$, we also demonstrate the utility of IPFY for insulating samples, where neither EY or FY provide reliable spectra due to sample charging and self-absorption effects, respectively.
We present an x-ray absorption study of the oxidation states of transition-metal-ions of LiMnO2 and its related materials, widely used as cathodes in Li-ion batteries. The comparison between the obtained spectrum and the configuration-interaction clu
ster-model calculations showed that the Mn3+ in LiMnO2 is a mixture of the high-spin and low-spin states. We found that Li deficiencies occur in the case of Cr substitution, whereas there are no Li deficiencies in the case of Ni substitution. We conclude that the substitution of charge-transfer-type Ni or Cu is effective for LiMnO2 battery materials.
We demonstrate a new method of x-ray absorption spectroscopy (XAS) that is bulk sensitive, like traditional fluorescence yield measurements, but is not affected by self-absorption or saturation effects. This measure of XAS is achieved by scanning the
incident photon energy through an absorption edge and using an energy sensitive photon detector to measure the partial fluorescence yield (PFY). The x-ray emission from any element or core-hole excitation that is not resonant with the absorption edge under investigation is selected from the PFY. It is found that the inverse of this PFY spectrum, which we term inverse partial fluorescence yield (IPFY), is linearly proportional to the x-ray absorption cross-section without any corrections due to saturation or self-absorption effects. We demonstrate this technique on the Cu L and Nd M absorption edges of the high-Tc cuprate LNSCO by measuring the O K PFY and comparing the total electron yield, total fluorescence yield and IPFY spectra.
