We present a numerical study of rapid, so called type III migration for Jupiter-sized planets embedded in a protoplanetary disc. We limit ourselves to the case of outward migration, and study in detail its evolution and physics, concentrating on the
structure of the co-rotation and circumplanetary regions, and processes for stopping migration. We also consider the dependence of the migration behaviour on several key parameters. We perform this study using global, two-dimensional hydrodynamical simulations with adaptive mesh refinement. We find that the outward directed type III migration can be started if the initial conditions support $Z > 1$, that corresponds to initial value $M_rmn{Delta} ga 1.5$. Unlike the inward directed migration, in the outward migration the migration rate increases due to the growing of the volume of the co-orbital region. We find the migration to be strongly dependent on the rate of the mass accumulation in the circumplanetary disc, leading to two possible regimes of migration, fast and slow. The structure of the co-orbital region and the stopping mechanism differ between these two regimes.
We present a numerical study of rapid, so called type III migration for Jupitersized planets embedded in a protoplanetary disc. We limit ourselves to the case of inward migration, and study in detail its evolution and physics, concentrating on the st
ructure of the corotation and circumplanetary regions, and processes for stopping migration. We also consider the dependence of the migration behaviour on several key parameters. We perform this study using the results of global, two-dimensional hydrodynamical simulations with adaptive mesh refinement. The initial conditions are chosen to satisfy the condition for rapid inward migration. We find that type III migration can be divided into two regimes, fast and slow. The structure of the coorbital region, mass accumulation rate, and migration behaviour differ between these two regimes. All our simulations show a transition from the fast to the slow regime, ending type III migration well before reaching the star. The stopping radius is found to be larger for more massive planets and less massive discs. A sharp density drop is also found to be an efficient stopping mechanism. In the fast migration limit the migration rate and induced eccentricity are lower for less massive discs, but almost do not depend on planet mass. Eccentricity is damped on the migration time scale.
We investigate the fast (type III) migration regime of high-mass protoplanets orbiting in protoplanetary disks. This type of migration is dominated by corotational torques. We study the details of flow structure in the planets vicinity, the dependenc
e of migration rate on the adopted disc model, and the numerical convergence of models (independence of certain numerical parameters such as gravitational softening). We use two-dimensional hydrodynamical simulations with adaptive mesh refinement,based on the FLASH code with improved time-stepping scheme. We perform global disk simulations with sufficient resolution close to the planet, which is allowed to freely move throughout the grid. We employ a new type of equation of state in which the gas temperature depends on both the distance to the star and planet, and a simplified correction for self-gravity of the circumplanetary gas. We find that the migration rate in the type III migration regime depends strongly on the gas dynamics inside the Hill sphere (Roche lobe of the planet) which, in turn, is sensitive to the aspect ratio of the circumplanetary disc. Furthermore, corrections due to the gas self-gravity are necessary to reduce numerical artifacts that act against rapid planet migration. Reliable numerical studies of Type III migration thus require consideration of both the thermal andthe self-gravity corrections, as well as a sufficient spatial resolution and the calculation of disk-planet attraction both inside and outside the Hill sphere. With this proviso, we find Type III migration to be a robust mode of migration, astrophysically promising because of a speed much faster than in the previously studied modes of migration.
We put theoretical constraints on the presence and survival of icy grains in debris discs. Particular attention is paid to UV sputtering of water ice, which has so far not been studied in detail in this context. We present a photosputtering model bas
ed on available experimental and theoretical studies. We quantitatively estimate the erosion rate of icy and ice-silicate grains, under the influence of both sublimation and photosputtering, as a function of grain size, composition and distance from the star. The effect of erosion on the grains location is investigated through numerical simulations coupling the grain size to its dynamical evolution. Our model predicts that photodesorption efficiently destroy ice in optically thin discs, even far beyond the sublimation snow line. For the reference case of beta Pictoris, we find that only > 5mm grains can keep their icy component for the age of the system in the 50-150AU region. When taking into account the collisional reprocessing of grains, we show that the water ice survival on grains improves (grains down to ~ 20 um might be partially icy). However, estimates of the amount of gas photosputtering would produce on such a hypothetical population of big icy grains lead to values for the OI column density that strongly exceed observational constraints for beta Pic, thus ruling out the presence of a significant amount of icy grains in this system. Erosion rates and icy grains survival timescales are also given for a set of 11 other debris disc systems. We show that, with the possible exception of M stars, photosputtering cannot be neglected in calculations of icy grain lifetimes.
