ترغب بنشر مسار تعليمي؟ اضغط هنا

We report on the fabrication and characterization of synthesized multiwall MoS2 nanotube (NT) and nanoribbon (NR) field-effect transistors (FETs). The MoS2 NTs and NRs were grown by chemical transport, using iodine as a transport agent. Raman spectro scopy confirms the material as unambiguously MoS2 in NT, NR, and flake forms. Transmission electron microscopy was used to observe cross sections of the devices after electrical measurements and these were used in the interpretation of the electrical measurements allowing estimation of the current density. The NT and NR FETs demonstrate n-type behavior, with ON/OFF current ratios exceeding 10^3, and with current densities of 1.02 {mu}A/{mu}m, and 0.79 {mu}A/{mu}m at VDS = 0.3 V and VBG = 1 V, respectively. Photocurrent measurements conducted on a MoS2 NT FET, revealed short-circuit photocurrent of tens of nanoamps under an excitation optical power of 78 {mu}W and 488 nm wavelength, which corresponds to a responsivity of 460 {mu}A/W. A long channel transistor model was used to model the common-source characteristics of MoS2 NT and NR FETs and was shown to be consistent with the measured data.
We report the realization of field-effect transistors (FETs) made with chemically synthesized multilayer 2D crystal semiconductor MoS2. Electrical properties such as the FET mobility, subthreshold swing, on/off ratio, and contact resistance of chemic ally synthesized (s-) MoS2 are indistinguishable from that of mechanically exfoliated (x-) MoS2, however flat-band voltages are different, possibly due to polar chemical residues originating in the transfer process. Electron diffraction studies and Raman spectroscopy show the structural similarity of s-MoS2 to x-MoS2. This initial report on the behavior and properties of s-MoS2 illustrates the feasibility of electronic devices using synthetic layered 2D crystal semiconductors.
We report the realization of field-effect transistors (FETs) made with chemically- synthesized layered two dimensional (2D) crystal semiconductor WS2. The 2D Schottky-barrier FETs demonstrate ambipolar behavior and a high (~105x) on/off current ratio at room temperature with current saturation. The behavior is attributed to the presence of an energy bandgap in the 2D crystal material. The FETs show clear photo response to visible light. The promising electronic and optical characteristics of the devices combined with the layered 2D crystal flexibility make WS2 attractive for future electronic and optical devices.
mircosoft-partner

هل ترغب بارسال اشعارات عن اخر التحديثات في شمرا-اكاديميا