Covariance Analysis of Symmetry Energy Observables from Heavy Ion Collision

Using covariance analysis, we quantify the correlations between the interaction parameters in a transport model and the observables commonly used to extract information of the Equation of State of Asymmetric Nuclear Matter in experiments. By simulating $^{124}$Sn+$^{124}$Sn, $^{124}$Sn+$^{112}$Sn and $^{112}$Sn+$^{112}$Sn reactions at beam energies of 50 and 120 MeV per nucleon, we have identified that the nucleon effective mass splitting are most strongly correlated to the neutrons and protons yield ratios with high kinetic energy from central collisions especially at high incident energy. The best observable to determine the slope of the symmetry energy, L, at saturation density is the isospin diffusion observable even though the correlation is not very strong ($sim$0.7). Similar magnitude of correlation but opposite in sign exists for isospin diffusion and nucleon isoscalar effective mass. At 120 MeV/u, the effective mass splitting and the isoscalar effective mass also have opposite correlation for the double n/p and isoscaling p/p yield ratios. By combining data and simulations at different beam energies, it should be possible to place constraints on the slope of symmetry energy (L) and effective mass splitting with reasonable uncertainties.

Constraints on symmetry energy and nucleon effective mass splitting with Heavy Ion Collisions

A new version of the improved quantum molecular dynamics model has been developed to include standard Skyrme interactions. Four commonly used Skyrme parameter sets, SLy4, SkI2, SkM* and Gs are adopted in the transport model code to calculate the isospin diffusion observables as well as single and double ratios of transverse emitted nucleons. While isospin diffusion observables are sensitive to the symmetry energy term, they are not very sensitive to the nucleon effective mass splitting parameters in the interactions. Our calculations show that the high energy neutrons and protons and their ratios from reactions at different incident energies provide a robust observable to study the momentum dependence of the nucleon effective mass splitting. However the sensitivity of effective mass splitting effect on the n/p yield ratios decreases with increasing beam energy, even though high energy proton and neutron are produced more abundantly at high beam energy. Our calculations show that the optimum incident energy to study nucleon effective masses is between 100-200 MeV per nucleon.

Fragmentation cross-sections and binding energies of neutron-rich nuclei

An exponential dependence of the fragmentation cross-section on the average binding energy is observed and reproduced with a statistical model. The observed functional dependence is robust and allows the extraction of binding energies from measured cross-sections. From the systematics of 75,77,78,79Cu isotope cross-sections have been extracted. They are 636.94 +/- 0.40 MeV, 647.1 +/- 0.4 MeV, 651.6 +/- 0.4 MeV and 657.8 +/- 0.5 MeV, respectively. Specifically, the uncertainty of the binding energy of 75Cu is reduced from 980 keV (listed value in the 2003 mass table of Audi and Wapstra) to 400 keV. The predicted cross-sections of two near drip-line nuclei, 39Na and 40Mg, from the fragmentation of 48Ca are discussed.

Projectile Fragmentation of $^{86}$Kr at 64 MeV/nucleon

We measured fragmentation cross sections produced using the primary beam of $^{86}$Kr at 64 MeV/nucleon on $^9$Be and $^{181}$Ta targets. The cross sections were obtained by integrating the momentum distributions of isotopes with 25<Z<36 measured using the RIPS fragment separator at RIKEN. The cross-section ratios obtained with the $^{181}$Ta and $^{9}$Be targets depend on the fragment masses, contrary to the simple geometrical models. We compared the extracted cross sections to EPAX; an empirical parameterization of fragmentation cross sections. Predictions from current EPAX parameterization severely overestimate the production cross sections of very neutron-rich isotopes. Attempts to obtain another set of EPAX parameters specific to the reaction studied here, to extrapolate the neutron-rich nuclei more accurately have not been very successful, suggesting that accurate predictions of production cross sections of nuclei far from the valley of stability require information of nuclear properties which are not present in EPAX.

Extrapolation of neutron-rich isotope cross-sections from projectile fragmentation

Using the measured fragmentation cross sections produced from the 48Ca and 64Ni beams at 140 MeV per nucleon on 9Be and 181Ta targets, we find that the cross sections of unmeasured neutron rich nuclei can be extrapolated using a systematic trend involving the average binding energy. The extrapolated cross-sections will be very useful in planning experiments with neutron rich isotopes produced from projectile fragmentation. The proposed method is general and could be applied to other fragmentation systems including those used in other radioactive ion beam facilities.