An unusual increase of the conductance with temperature is observed in clean quantum point contacts for conductances larger than 2e^2/h. At the same time a positive magnetoresistance arises at high temperatures. A model accounting for electron-electr
on interactions mediated by bound- aries (scattering on Friedel oscillations) qualitatively describes the observation. It is supported by numerical simulation at zero magnetic field.
Hydraulic tension fractures were produced in porous limestones using a specially designed hydraulic cell. The 3D geometry of the samples was imaged using X-ray computed microtomography before and after fracturation. Using these data, it was possible
to estimate the permeability tensor of the core samples, extract the path of the rupture and compare it to the heterogeneities initially present in the rock.
The surface roughness of a recently exhumed strikeslip fault plane has been measured by three independent 3D portable laser scanners. Digital elevation models of several fault surface areas, from 1 m2 to 600 m2, have been measured at a resolution ran
ging from 5 mm to 80 mm. Out of plane height fluctuations are described by non-Gaussian distribution with exponential long range tails. Statistical scaling analyses show that the striated fault surface exhibits self-affine scaling invariance with a small but significant directional morphological anisotropy that can be described by two scaling roughness exponents, H1 = 0.7 in the direction of slip and H2 = 0.8 perpendicular to the direction of slip.
When carbon dioxide (CO2) is injected into an aquifer or a depleted geological reservoir, its dissolution into solution results in acidification of the pore waters. As a consequence, the pore waters become more reactive, which leads to enhanced disso
lution-precipitation processes and a modification of the mechanical and hydrological properties of the rock. This effect is especially important for limestones given that the solubility and reactivity of carbonates is strongly dependent on pH and the partial pressure of CO2. The main mechanism that couples dissolution, precipitation and rock matrix deformation is commonly referred to as intergranular pressure solution creep (IPS) or pervasive pressure solution creep (PSC). This process involves dissolution at intergranular grain contacts subject to elevated stress, diffusion of dissolved material in an intergranular fluid, and precipitation in pore spaces subject to lower stress. This leads to an overall and pervasive reduction in porosity due to both grain indentation and precipitation in pore spaces. The percolation of CO2-rich fluids may influence on-going compaction due to pressure solution and can therefore potentially affect the reservoir and its long-term CO2 storage capacity. We aim at quantifying this effect by using a 2D numerical model to study the coupling between dissolution-precipitation processes, local mass transfer, and deformation of the rock over long time scales. We show that high partial pressures of dissolved CO2 (up to 30 MPa) significantly increase the rates of compaction by a factor of ~ 50 to ~ 75, and also result in a concomitant decrease in the viscosity of the rock matrix.
