Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userPeriodic surface modulation of $(LaSe)_{1.14}(NbSe_2)$ observed by scanning tunneling microscopy
127
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
Fourier transformation of atomically resolved STM topography of $(LaSe)_{1.14}(NbSe_2)$ revealed a surface modulation along the hexagonal surface lattice of $NbSe_2$ layer, but with a two times larger period. We compare it to the modified charge density wave found on plain $NbSe_2$ under strain.
rate research
Read More
In this paper we present scanning tunneling microscopy of a large $textrm{Bi}_2textrm{Se}_3$ crystal with superconducting PbBi islands deposited on the surface. Local density of states measurements are consistent with induced superconductivity in the topological surface state with a coherence length of order 540 nm. At energies above the gap the density of states exhibits oscillations due to scattering caused by a nonuniform order parameter. Strikingly, the spectra taken on islands also display similar oscillations along with traces of the Dirac cone, suggesting an inverse topological proximity effect.
We present a method to identify distinct tunneling modes in tunable superconducting tunnel junction composed of superconducting tip and sample in scanning tunneling microscope. Combining the measurement of the relative decay constant of tunneling current extracted from I-V-z spectroscopy with its statistical analysis over the atomic disorders in the sample surface, we identified the crossover of tunneling modes between single quasiparticle tunneling, multiple Andreev reflection, and Josephson tunneling with respect to the bias voltage. The method enables one to determine the particular tunneling regime independently of the spectral shapes, and to reveal the intrinsic modulation of Andreev reflection and Josephson current that would be crucial for quantum device application of superconductors.
We consider the magnetic structure on the Fe(001) surface and theoretically study the scanning tunneling spectroscopy using a spin-polarized tip (SP-STM). We show that minority-spin surface states induce a strong bias dependence of the tunneling differential conductance which largely depends on the orientation of the magnetization in the SP-STM tip relative to the easy magnetization axis in the Fe(001) surface. We propose to use this effect in order to determine the spin character of the Fe(001) surface states. This technique can be applied also to other magnetic surfaces in which surface states are observed.
We present very low temperature (0.15 K) scanning tunneling microscopy and spectroscopy experiments in the layered superconductor LaSb$_2$. We obtain topographic microscopy images with surfaces showing hexagonal and square atomic size patterns, and observe in the tunneling conductance a superconducting gap. We find well defined quasiparticle peaks located at a bias voltage comparable to the weak coupling s-wave BCS expected gap value (0.17 meV). The amount of states at the Fermi level is however large and the curves are significantly broadened. We find T$_c$ of 1.2 K by following the tunneling conductance with temperature.
We consider the problem of local tunneling into cuprate superconductors, combining model based calculations for the superconducting order parameter with wavefunction information obtained from first principles electronic structure. For some time it has been proposed that scanning tunneling microscopy (STM) spectra do not reflect the properties of the superconducting layer in the CuO$_2$ plane directly beneath the STM tip, but rather a weighted sum of spatially proximate states determined by the details of the tunneling process. These filter ideas have been countered with the argument that similar conductance patterns have been seen around impurities and charge ordered states in systems with atomically quite different barrier layers. Here we use a recently developed Wannier function based method to calculate topographies, spectra, conductance maps and normalized conductance maps close to impurities. We find that it is the local planar Cu $d_{x^2-y^2}$ Wannier function, qualitatively similar for many systems, that controls the form of the tunneling spectrum and the spatial patterns near perturbations. We explain how, despite the fact that STM observables depend on the materials-specific details of the tunneling process and setup parameters, there is an overall universality in the qualitative features of conductance spectra. In particular, we discuss why STM results on Bi$_2$Sr$_2$CaCu$_2$O$_8$ and Ca$_{2-x}$Na$_x$CuO$_2$Cl$_2$ are essentially identical.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
