Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userCAMELOT - Concept study and early results for onboard data processing and GPS-based timestamping
120
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
Due to recent advances in nanosatellite technology, it is now feasible to integrate scintillators with an effective area of hundreds of square-centimeters on a single three-unit cubesat. We present the early test results for the digital payload electronics developed for the proposed CAMELOT (Cubesats Applied for MEasuring and LOcalising Transients) mission. CAMELOT is a fleet of nanosatellites intended to do full-sky monitoring and perform accurate timing-based localization of gamma-ray transients. Here we present the early results on the GPS timestamping capabilities of the CAMELOT payload electronics, concluding that the investigated setup is capable to timestamp the received gamma-ray photons with an accuracy and precision better than 0.02 millisecond, which corresponds to a timing based localization accuracy of $sim 3.5^{prime}$. Further refinements will likely allow us to improve the timing accuracy down to the sub-microsecond level.
rate research
Read More
A fleet of nanosatellites using precise timing synchronization provided by the Global Positioning System is a new concept for monitoring the gamma-ray sky that can achieve both all-sky coverage and good localization accuracy. We are proposing this new concept for the mission CubeSats Applied for MEasuring and LOcalising Transients (CAMELOT). The differences in photon arrival times at each satellite are to be used for source localization. Detectors with good photon statistics and the development of a localization algorithm capable of handling a large number of satellites are both essential for this mission. Large, thin CsI scintillator plates are the current candidates for the detectors because of their high light yields. It is challenging to maximize the light-collection efficiency and to understand the position dependence of such thin plates. We have found a multi-channel readout that uses the coincidence technique to be very effective in increasing the light output while keeping a similar noise level to that of a single channel readout. Based on such a detector design, we have developed a localization algorithm for this mission and have found that we can achieve a localization accuracy better than 20 arc minutes and a rate of about 10 short gamma-ray bursts per year.
We describe the processing of data from the Low Frequency Instrument (LFI) used in production of the Planck Early Release Compact Source Catalogue (ERCSC). In particular, we discuss the steps involved in reducing the data from telemetry packets to cleaned, calibrated, time-ordered data (TOD) and frequency maps. Data are continuously calibrated using the modulation of the temperature of the cosmic microwave background radiation induced by the motion of the spacecraft. Noise properties are estimated from TOD from which the sky signal has been removed using a generalized least square map-making algorithm. Measured 1/f noise knee-frequencies range from 100mHz at 30GHz to a few tens of mHz at 70GHz. A destriping code (Madam) is employed to combine radiometric data and pointing information into sky maps, minimizing the variance of correlated noise. Noise covariance matrices required to compute statistical uncertainties on LFI and Planck products are also produced. Main beams are estimated down to the approx -10dB level using Jupiter transits, which are also used for geometrical calibration of the focal plane.
We propose a fleet of nanosatellites to perform an all-sky monitoring and timing based localisation of gamma-ray transients. The fleet of at least nine 3U cubesats shall be equipped with large and thin CsI(Tl) scintillator based soft gamma-ray detectors read out by multi-pixel photon counters. For bright short gamma-ray bursts (GRBs), by cross-correlating their light curves, the fleet shall be able to determine the time difference of the arriving GRB signal between the satellites and thus determine the source position with an accuracy of $sim10^prime$. This requirement demands precise time synchronization and accurate time stamping of the detected gamma-ray photons, which will be achieved by using on-board GPS receivers. Rapid follow up observations at other wavelengths require the capability for fast, nearly simultaneous downlink of data using a global inter-satellite communication network. In terms of all-sky coverage, the proposed fleet will outperform all GRB monitoring missions.
The CALorimetric Electron Telescope (CALET), launched for installation on the International Space Station (ISS) in August, 2015, has been accumulating scientific data since October, 2015. CALET is intended to perform long-duration observations of high-energy cosmic rays onboard the ISS. CALET directly measures the cosmic-ray electron spectrum in the energy range of 1 GeV to 20 TeV with a 2% energy resolution above 30 GeV. In addition, the instrument can measure the spectrum of gamma rays well into the TeV range, and the spectra of protons and nuclei up to a PeV. In order to operate the CALET onboard ISS, JAXA Ground Support Equipment (JAXA-GSE) and the Waseda CALET Operations Center (WCOC) have been established. Scientific operations using CALET are planned at WCOC, taking into account orbital variations of geomagnetic rigidity cutoff. Scheduled command sequences are used to control the CALET observation modes on orbit. Calibration data acquisition by, for example, recording pedestal and penetrating particle events, a low-energy electron trigger mode operating at high geomagnetic latitude, a low-energy gamma-ray trigger mode operating at low geomagnetic latitude, and an ultra heavy trigger mode, are scheduled around the ISS orbit while maintaining maximum exposure to high-energy electrons and other high-energy shower events by always having the high-energy trigger mode active. The WCOC also prepares and distributes CALET flight data to collaborators in Italy and the United States. As of August 31, 2017, the total observation time is 689 days with a live time fraction of the total time of approximately 84%. Nearly 450 million events are collected with a high-energy (E>10 GeV) trigger. By combining all operation modes with the excellent-quality on-orbit data collected thus far, it is expected that a five-year observation period will provide a wealth of new and interesting results.
We describe the processing of the 336 billion raw data samples from the High Frequency Instrument (HFI) which we performed to produce six temperature maps from the first 295 days of Planck-HFI survey data. These maps provide an accurate rendition of the sky emission at 100, 143, 217, 353, 545 and 857 GHz with an angular resolution ranging from 9.9 to 4.4^2. The white noise level is around 1.5 {mu}K degree or less in the 3 main CMB channels (100--217GHz). The photometric accuracy is better than 2% at frequencies between 100 and 353 GHz and around 7% at the two highest frequencies. The maps created by the HFI Data Processing Centre reach our goals in terms of sensitivity, resolution, and photometric accuracy. They are already sufficiently accurate and well-characterised to allow scientific analyses which are presented in an accompanying series of early papers. At this stage, HFI data appears to be of high quality and we expect that with further refinements of the data processing we should be able to achieve, or exceed, the science goals of the Planck project.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
