Subscribe to the gold package and get unlimited access to Shamra Academy
Register a new userSub-arcsecond imaging with the International LOFAR Telescope: II. Completion of the LOFAR Long-Baseline Calibrator Survey
452
0
0.0
(
0
)
Ask ChatGPT about the research
No Arabic abstract
The Low-Frequency Array (LOFAR) Long-Baseline Calibrator Survey (LBCS) was conducted between 2014 and 2019 in order to obtain a set of suitable calibrators for the LOFAR array. In this paper we present the complete survey, building on the preliminary analysis published in 2016 which covered approximately half the survey area. The final catalogue consists of 30006 observations of 24713 sources in the northern sky, selected for a combination of high low-frequency radio flux density and flat spectral index using existing surveys (WENSS, NVSS, VLSS, and MSSS). Approximately one calibrator per square degree, suitable for calibration of $geq$ 200 km baselines is identified by the detection of compact flux density, for declinations north of 30 degrees and away from the Galactic plane, with a considerably lower density south of this point due to relative difficulty in selecting flat-spectrum candidate sources in this area of the sky. Use of the VLBA calibrator list, together with statistical arguments by comparison with flux densities from lower-resolution catalogues, allow us to establish a rough flux density scale for the LBCS observations, so that LBCS statistics can be used to estimate compact flux densities on scales between 300 mas and 2 arcsec, for sources observed in the survey. The LBCS can be used to assess the structures of point sources in lower-resolution surveys, with significant reductions in the degree of coherence in these sources on scales between 2 arcsec and 300 mas. The LBCS survey sources show a greater incidence of compact flux density in quasars than in radio galaxies, consistent with unified schemes of radio sources. Comparison with samples of sources from interplanetary scintillation (IPS) studies with the Murchison Widefield Array (MWA) shows consistent patterns of detection of compact structure in sources observed both interferometrically with LOFAR and using IPS.
rate research
Read More
(abridged). We outline LBCS (the LOFAR Long-Baseline Calibrator Survey), whose aim is to identify sources suitable for calibrating the highest-resolution observations made with the International LOFAR Telescope, which include baselines >1000 km. Suitable sources must contain significant correlated flux density (50-100mJy) at frequencies around 110--190~MHz on scales of a few hundred mas. At least for the 200--300-km international baselines, we find around 1 suitable calibrator source per square degree over a large part of the northern sky, in agreement with previous work. This should allow a randomly selected target to be successfully phase calibrated on the international baselines in over 50% of cases. Products of the survey include calibrator source lists and fringe-rate and delay maps of wide areas -- typically a few degrees -- around each source. The density of sources with significant correlated flux declines noticeably with baseline length over the range 200--600~km, with good calibrators on the longest baselines appearing only at the rate of 0.5 per square degree. Coherence times decrease from 1--3 minutes on 200-km baselines to about 1 minute on 600-km baselines, suggesting that ionospheric phase variations contain components with scales of a few hundred kilometres. The longest median coherence time, at just over 3 minutes, is seen on the DE609 baseline, which at 227km is close to being the shortest. We see median coherence times of between 80 and 110 seconds on the four longest baselines (580--600~km), and about 2 minutes for the other baselines. The success of phase transfer from calibrator to target is shown to be influenced by distance, in a manner that suggests a coherence patch at 150-MHz of the order of 1 degree.
Aims. An efficient means of locating calibrator sources for International LOFAR is developed and used to determine the average density of usable calibrator sources on the sky for subarcsecond observations at 140 MHz. Methods. We used the multi-beaming capability of LOFAR to conduct a fast and computationally inexpensive survey with the full International LOFAR array. Sources were pre-selected on the basis of 325 MHz arcminute-scale flux density using existing catalogues. By observing 30 different sources in each of the 12 sets of pointings per hour, we were able to inspect 630 sources in two hours to determine if they possess a sufficiently bright compact component to be usable as LOFAR delay calibrators. Results. Over 40% of the observed sources are detected on multiple baselines between international stations and 86 are classified as satisfactory calibrators. We show that a flat low-frequency spectrum (from 74 to 325 MHz) is the best predictor of compactness at 140 MHz. We extrapolate from our sample to show that the density of calibrators on the sky that are sufficiently bright to calibrate dispersive and non-dispersive delays for the International LOFAR using existing methods is 1.0 per square degree. Conclusions. The observed density of satisfactory delay calibrator sources means that observations with International LOFAR should be possible at virtually any point in the sky, provided that a fast and efficient search using the methodology described here is conducted prior to the observation to identify the best calibrator.
[abridged] The International LOFAR Telescope is an interferometer with stations spread across Europe. With baselines of up to ~2,000 km, LOFAR has the unique capability of achieving sub-arcsecond resolution at frequencies below 200 MHz, although this is technically and logistically challenging. Here we present a calibration strategy that builds on previous high-resolution work with LOFAR. We give an overview of the calibration strategy and discuss the special challenges inherent to enacting high-resolution imaging with LOFAR, and describe the pipeline, which is publicly available, in detail. We demonstrate the calibration strategy by using the pipeline on P205+55, a typical LOFAR Two-metre Sky Survey (LoTSS) pointing. We perform in-field delay calibration, solution referencing to other calibrators, self-calibration, and imaging of example directions of interest in the field. For this specific field and these ionospheric conditions, dispersive delay solutions can be transferred between calibrators up to ~1.5 degrees away, while phase solution transferral works well over 1 degree. We demonstrate a check of the astrometry and flux density scale. Imaging in 17 directions, the restoring beam is typically 0.3 x 0.2 although this varies slightly over the entire 5 square degree field of view. We achieve ~80 to 300 $mu$Jy/bm image rms noise, which is dependent on the distance from the phase centre; typical values are ~90 $mu$Jy/bm for the 8 hour observation with 48 MHz of bandwidth. Seventy percent of processed sources are detected, and from this we estimate that we should be able to image ~900 sources per LoTSS pointing. This equates to ~3 million sources in the northern sky, which LoTSS will entirely cover in the next several years. Future optimisation of the calibration strategy for efficient post-processing of LoTSS at high resolution (LoTSS-HR) makes this estimate a lower limit.
3C295 is a bright, compact steep spectrum source with a well-studied integrated radio spectral energy distribution (SED) from 132 MHz to 15 GHz. However, spatially resolved spectral studies have been limited due to a lack of high resolution images at low radio frequencies. These frequencies are crucial for measuring absorption processes, and anchoring the overall spectral modelling of the radio SED. In this paper, we use International LOFAR (LOw-Frequency ARray) Telescope (ILT) observations of 3C295 to study its spatially resolved spectral properties with sub-arcsecond resolution at 132 MHz. Combining our new 132 MHz observation with archival data at 1.6 GHz, 4.8 GHz, and 15 GHz, we are able to carry out a resolved radio spectral analysis. The spectral properties of the hotspots provides evidence for low frequency flattening. In contrast, the spectral shape across the lobes is consistent with a JP spectral ageing model. Using the integrated spectral information for each component, we then fit low-frequency absorption models to the hotspots, finding that both free-free absorption and synchrotron self-absorption models provide a better fit to the data than a standard power law. Although we can say there is low-frequency absorption present in the hotspots of 3C295, future observations with the Low Band Antenna of the ILT at 55 MHz may allow us to distinguish the type of absorption.
Active galactic nuclei (AGNs) show episodic activity, evident in galaxies that exhibit restarted radio jets. These restarted jets can interact with their environment, leaving signatures on the radio spectral energy distribution. Tracing these signatures requires resolved spectral index measurements over a broad frequency range including low frequencies. We present such a study for the radio galaxy 3C 293. Using the International LOFAR telescope (ILT) we probed spatial scales as fine as ~0.2 at 144 MHz, and to constrain the spectrum we combined these data with Multi-Element Radio Linked Interferometer Network (MERLIN) and Very Large Array (VLA) archival data. In the inner lobes (~2 kpc), we detect the presence of a spectral turnover that peaks at ~225 MHz and is most likely caused by free-free absorption from the rich surrounding medium. We confirm that these inner lobes are part of a jet-dominated young radio source (spectral age $lesssim$0.17 Myr), which is strongly interacting with the rich interstellar medium (ISM) of the host galaxy. The outer lobes (~100 kpc) have a spectral index of $alpha$~0.6-0.8 from 144-4850 MHz with a remarkably uniform spatial distribution and only mild spectral curvature ($Deltaalphalesssim$ 0.2). We propose that intermittent fuelling and jet flow disruptions are powering the mechanisms that keep the spectral index in the outer lobes from steepening and maintain the spatial uniformity of the spectral index. Overall, it appears that 3C 293 has gone through multiple (two to three) epochs of activity. This study adds 3C 293 to the new sub-group of restarted galaxies with short interruption time periods. This is the first time a spatially resolved study simultaneously studies a young source as well as the older outer lobes at such low frequencies. This illustrates the potential of the ILT to expand such studies to a larger sample of radio galaxies.
Log in to be able to interact and post comments
comments
Fetching comments
Sign in to be able to follow your search criteria
